Suppose a circuit is required to recognize the 4-bit pattern (1100), and the output (z=1) whenever it occurs in the continuous serial input (X) of the circuit. 1- Draw the mealy state diagram. 2- Write down the state table. 3- Check state reductions. 4- Assign binary values to the states.
Q: 2- A certain application requires that a four-bit binary number be decoder use 74154 decoders to…
A: All the 16 outputs are connected through a resistor and then an LED to serve as a 16 LED controller.…
Q: 1- Design a 3-bit UP-DOWN synchronous counter such that the UP or DOWN counter is selected by a…
A: The state diagram for the UP-DOWN synchronous counter is shown in the below figure.
Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…
A: Flip flop is a latch with additional control input (clock or enable ). A flip flop is used to store…
Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…
A: consider the given question;
Q: Question Implement the Function 'Y = ACB + BC + E' using a 4-Input, 2-Address Bit Multiplexer. What…
A:
Q: Write MIPS program
A: The answer to the above problem is given below:-
Q: 4. FIGURE 1 shows how a 3 to 8 line decoder (TTL 74138) can be used in conjunction with NAND gate…
A: From the above question, we need to calculate a Address of the address bus in order to read the…
Q: clock signal frequency for a 4-bit up counter is 20kHz. What is the frequency of the most valuable…
A: Option :b Answer
Q: Draw a truth table, Karnaugh diagram and logical gates circuit to show the function of an even…
A: In a binary 3 pin input, the decimal equivalents are from 0 to 7. In between 0 to 7, 0, 2, 4 and 6…
Q: 3. Solve the analog conversion for 8-bit binary numbers 101011112?
A:
Q: X1,X2,X3, and X4 are four variables. X1's range is (0 to 200), X2's range is (0 to 24h), that of X3…
A: The solution can be achieved as follows.
Q: Design don't-care conditions. an excess-3-to-binary decoder using the unused combinations of the…
A: Design an excess 3 to binary decoder using the unused combinations of the code as dont care…
Q: Design a circuit which will add a 4-bit binary number to a 5-bit binary number. Use five full…
A: There are two independent questions. We are authorized to answer one question at a time, since you…
Q: Find the binary assignment table for the following circuit, then re-design it using JK flip flops. R…
A: Given circuit diagram: To find: Binary assignment table for the following circuit and re-design it…
Q: DISCUSSION: 1- Determine the logic required to decode the binary number 1011, by producing a HIGH…
A:
Q: 1. a) Explain parity method for error detection for 8-bit data transmission using necessary circuit.
A: When a message or signal is forwarded, it may be resolved by noise or data is corrupted. To avoid…
Q: . If a 6-bit binary number is used to represent an analog value in the range from -63 to 126, what…
A: According to given question, analog value range 63 to 126 6 bit binary number is used to represent…
Q: In digital communication .explain all the methods/mechanism used for the minimization of bit error…
A: Bit error rate(BER): The bit error rate (BER) is the number of bit errors per unit time. The bit…
Q: The addition of two 5-bit binary numbers in parallel implies that all the bits of the augend and…
A: We need to draw the circuit diagram providing the carry output in carry-look ahead adder.
Q: A В C
A:
Q: Q3/ A. Design 4-Bit Asynchronous counter the sequence for the 4-bit binary counter from 0000 through…
A:
Q: Problem 2 Generate the PLA programming table for the combinational circuit that squares a 3-bit…
A: …
Q: The MOVS instruction is move the element of string from [DS:SI] to new memory location specified by…
A: In this question we will write about the instructions MOVS used in Microprocessor....
Q: design 2 to 8 bit binary comparator and write it's summary?
A: 2 bit comparator A comparator used to compare two binary numbers each of two bits is called a 2-bit…
Q: 5) An 8-bit register contains 10010110. What is the corresponding value (in decimal) if it…
A:
Q: Design a 3Bit Even Parity Bit Generator using: a) Multiplexer b) Decoder and appropriate gates
A: Design a 3Bit Even Parity Bit Generator using: a) Multiplexer b) Decoder and appropriate gates
Q: (b) Consider a processor that includes a base with indexing addressing mode. Suppose an instruction…
A: Consider a processor that includes a base with indexing addressing mode. Suppose an instruction is…
Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…
A:
Q: 4. Design 5-bit Serial in/Serial out shift register and write its truth table? Consider that the…
A: to design 5- bit serial in/ serial out shift register and its truth table by considering the shift…
Q: 1 the minimum signal to noise ratio (SNR) to receive the symbols bability of bit error 106 or less?…
A:
Q: a) Briefly explain the Nyquist theorem in the context of digital sampling.
A: Note: We are authorized to answer one question at a time since you have not mentioned which question…
Q: A data of 111e is serially transmitted using both binary and BCD? Which encoding technique is faster…
A: Bartleby has policy to solve only 1st question. For solutions of rest questions re-upload them.
Q: Q4. A common bus system which is capable of transferring 2 bits at time with number of registers are…
A: Multiplexer- A multiplexer is a device that is used to select one of several input signals and send…
Q: 2. How many X states does a decimal- to-binary encoder have on its Karnaugh's map? (X=don't care) а.…
A: For th equestion the answer is as follows
Q: 3. What is shift register? What is its purpose? Mention its ? 4. Design 5-bit Serial in/Serial out…
A: 1. shift register and its purpose 2. to design 5- bit serial in/ serial out shift register and its…
Q: 5. Write a pseudocode program for the process by which two numbers, say 4 and 3, could be multiplied…
A: Below find the solution !!
Q: 4. FIGURE 1 shows how a 3 to 8 line decoder (TTL 74138) can be used in conjunction with NAND gate…
A:
Q: Design a logic circuit for a 3-bit message to be transmitted with an even parity bit. Four data bits…
A:
Q: Address latch enable (ALE) signal is a pulse co logic 1 that signals external circuitry when a valid…
A: In this question we will write about address latch enable....
Q: Draw the block diagram for a common bus system for 16 registers of 32 bits each. The bus is…
A: Multiplexer It is a data selector. It has many inputs and one output.
Q: Observe the encoded binary signal? What line encoding format was used
A: What type of encoding format is used
Q: The state diagram of a sequence detector which allows overlap is shown below. A sequence detector…
A:
Q: a. What is the counting range in binary and decimal for an up-counter with 3 bits? p. What is the…
A:
Q: Electronics Q What is the difference between a task and a function in verilog? What is the…
A: Verilog is Hardware Description language . The memory and array declaration in Verilog is static in…
Q: What is the binary representation of whole number 1,234 as a 12-bit signed integer? What is the…
A: In 12-bit signed integer, MSB is use to represent sign and rest of 11 bits are used to represent the…
Q: Suppose a circuit is required to recognize the 4-bit pattern (1100), and the output (z=1) whenever…
A:
Q: Draw the Moore and Mealy State Diagram of a Finite State Machine that functions as a Binary Sequence…
A: Draw the Moore and Mealy State Diagram of a Finite State Machine thatfunctions as a Binary Sequence…
Q: What do you understand by static data member and static member function?
A: Static data member: When a data member is declared as static, only one copy of the data is…
Q: Q What is the output frequency of a 4-bit binary counter for an input clock of 160 MHz? What are the…
A:
Q: Q2) Write the Assembly language instructions required to find: Z-X/Y, where X and Y are 16- bit…
A: Memory address Mnemonics 2000 LDA 2050 2003 MOV H, A 2004 LDA 2051 2007 ADD H 2008 MOV L,…
Step by step
Solved in 3 steps with 3 images
- Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two processors are identical otherwise and their bus cycles are the same speed. Suppose all instructions and operands are two Bytes. By what factor do the maximum data transfer rates vary? Suppose all instructions and operands are one Byte. By what factor do the maximum data transfer rates vary? Discuss your answers.What is a transmission gate? Draw its circuit circuit diagram. How does it operate? What is the need for a transmission gate? What is it disadvantage?Implement the Function 'Y = ACB + BC + E' using a 4-Input, 2-Address Bit Multiplexer.What are the Equations for the Multiplexer Data Inputs (D3 - D0)?
- 1- Write the output function ? 2- Design a hardware of this circuit? 3- Design the logic circuit on Proteus and Tinkercad? 4- Verify the truth table of Y ?Draw the block diagram for a common bus system for 16 registers of 32 bits each. The bus is constructed with multiplexers.Develop an assembly code for an LED 8-bit binary counter, where LEDs are connected to the Port 2. Here are the instructions, (1) counter should start when a HIGH input is present at P1.0 and stop the counter when a LOW input is present/read at the P1.2. (2) Draw the circuits diagram. Hint: Switch connected to P1.0 should pass HIGH when switch is pressed, where as switch connected to P1.2 should pass LOW when switch is pressed. Accordingly adjust your circuit connections and the code.
- Q3) A bit word 1010 is transmitted. Construct the even parity 7-bit hamming code for this data? If at receiver end data is received as 1000010, then check and correct the code using even parity scheme. Assume the direction of generation and checking the code from right to left?What is the largest binary number that can be expressed with 16 bits? What are the equivalent decimal and hexadecimal numbers?Implement the following Boolean function by using 4x1 multiplexer. ����(?, ?, ?, ?) = Ʃ?(1,3,5,6,8,11,14) Construct a logical circuit of 64 × 1 multiplexer using 4 × 1 multiplexer. Construct a priority encoder circuit of 8x3. Design a 4-bit BCD to Gray Code Converter by using Programmable Array logic.