Suppose that when you inverted the eudiometer, a bubble of air became trapped inside it. Would this make your experimental value of R larger, smaller, or have no effect?

Q: Calculate the appearance of D2 (mol/L•min) when the appearance is A is 0.854? 4A + 2DE2 -> 4AE + D2

A:

Q: Why is the y intercept of a regression line 0?

A:

Q: Are the gas laws affected depending on whether you use heavy gas particles or light gas particles?…

A: Gas laws depends upon the change of volume, pressure and temperature. If we increase temperature…

Q: Shown below are the scatter plots for four different data sets. Answer the questions that follow.…

A: The explanation is given below-

Q: Report the y-Intercept of the best-fit line for the Calibration Curve Report the R2 value of the…

A: The best fit-line given is as shown below,

Q: O= 0.24 xu? > D.24 x10-16 KT 3. 人2 JE OP -23 = 1.381 *10 P= 1D/325 pa 23 d= (Vz) (0-24x10 18nt)…

A:

Q: TABLE 1: Gas Composition in Weight Fraction Composition Component (Weight fraction) Methane 0.790…

A: Specific gravity of gas is ratio of density of gas to the density of of air. If the gas follows…

Q: I need help with number one please

A: Part 1: Data in part one shows volume decreases with increase in pressure. It means volume is…

Q: Part C High-pressure liquid chromatography (HPLC) is a method used in chemistry and biochemistry to…

A: Pressure is Pascal is given. Pressure in Torr = ?

Q: Taking the density of air to be 1.29 kg/m3, what is the magnitude of the linear momentum of a cubic…

A: Given : density of air = 1.29 Kg/m3  And volume of air = 1 m3  Since mass = density X volume  =>…

Q: The following 2 components are separated by HPLC using C18 as the stationary phase. Predict the…

A: Chromatography is used to separate the compound based on the polarity. It contains a stationary…

Q: A particle diagram is a symbolic representation of atoms and molecules at the microscopic level.…

A:

Q: In 1-2 sentences identify the dependent variable(s) and explain the trend we observe.

A: Rise in temperature and concentration of CO2 in ppm are dependent variables.

Q: 4) Other Linearization Choices 0/2 poin When using x = 1/A, the meaning of the slope is hc. There is…

A: If  E = hcλ can be represented as y = mx straight line where m is the slope of the life If x = 1λ…

Q: Given the following mixture of two compounds 25.00 mL of X (MW =82.00 g/mol)(density 1.013 g/mL) and…

A: Mole fraction of a component in a solution is the ratio of moles of that component and total moles.…

Q: I got an answer of 138kJ but it was wrong, please help

A: ∆Hreaction = (energy needed to break the bond)- (energy released upon bond formation) Also we can…

Q: Part A What would you advise him to do? The Delisle temperature scale used in Mexico. Typical baking…

A: Temperature is measured using Fahrenheit and Celsius scales.  The given temperature is 185 oC.

Q: Calculate the value of Kc 2ClO3- + 12H+ +10e-←→Cl2 + 6H2O: E= +1.52 volt S2O82-+ 2e-←→ 2SO42-:…

A:

Q: 6) In an Edie-Hofstee plot of v versus v/[S] what are the units of the y- intercept? 7) The Vmax…

A:

Q: If the SI expression of 1.2 mg has a Power of 10 expression of 1.2 x 10^-3 g, then the SI expression…

A: The significant figures of a number written in positional notation are digits that carry meaningful…

Q: In symmetrical distribution, mean, median, and mode are:

A: Symmetrical distribution occurs when the mean, median, and mode all occur at the same point and the…

Q: What is the difference between computational calculations based on Molecular Mechanics and…

A: Computational chemistry is a branch of chemistry that uses computers to assist in solving chemical…

Q: 7. What effect will a 1.0°C error (all temperature readings are 1.0°C greater than the actual value)…

A: If regarding 1°C greater than the actual value for the final temperature ΔT will be greater than the…

Q: If you are using a NORMAL phase HPLC, predict the order of elution of 1. n-hexane, n-hexanol and…

A:

Q: Multiply both sides of the equation by the same expression: (Be sure that the answer field changes…

A:

Q: Step Two Multiply both sides of the equation by the same expression: (Be sure that the answer field…

A:

Q: Define the term lambda max (λmax)

A: Given that : We have to define lambda max (λmax).

Q: How would you expect your plot of Pvap vs. T (°C) to differ if you had examined methanol instead of…

A: Vapor pressure is the measure of how much a substance is prone to go to the vapor state. To compare…

Q: 6. If we were to generate a sampling distribution of means based on a sample of size of 50, what…

A:

Q: Describe the differences between gravity and vacuum filtration

A: Please have a look on the solution:

Q: list some reasons why your computer density values did not correspond to the value obtained from the…

A: Error is defined as the difference between the true result and the measured result. There are…

Q: Suppose the n-well is doped with phosphorous having a density, No. of 14332582438752 cm³3. Estimate…

A: The Answer to the following question is-

Q: In a certain oxide of nitrogen in g/L at multiple pressures at 0 °C, different density results were…

A: Given: The density v/s pressure data at 0.0 oC as, Pressure Density 1 atm 1.9804 2/3…

Q: Determine the value of K- at 550 °C (Gas constant = 8.315 Pa m3 K-1 mol-1) %3D

A: This is a question from chemical equilibrium. To solve this problem, we have to take help of two…

Q: 10. Hz SO4 caqp/acetone

A: It is an example of Jones  oxidation reaction Jones reagent is a strong oxidizing agent  It will…

Q: Match column A with column B. Write the CAPITAL letter on the space provided before each number.…

A: We have to Match column A with column B and  Write the CAPITAL letter on the space provided before…

Q: The following linear plot is derived from a function of the form y = ae", where a and b are…

A: Given: y = aebx

Q: a. What mass of oxygen is used up to burn a full tank of 36.00 kg of gasoline? Text b. Why might a…

A: IMPORTANT POINTS : By stoichiometry mole of each reactant and product can be related by balanced…

Q: 1. The calibration of a 10-mL pipet produced the following data: Mass Beaker Mass Beaker + Water…

A: To determine the Mean Volume of water actually dispensed by water.

Q: 2. Assuming that all groups carried out the experiment and associated calculations correctly, which…

A: Enthalpy of fusion is defined as the amount of energy required to change the state of matter from…

Q: Woodward -Fieser Rules, calculate the λmax of the following compound:

A: Woodward–Fieser rules: Woodward–Fieser rules are several sets of empirically derived rules which are…

Q: Kerma can be calculated from particle fluence by Hab K = $ x E x Truo

A: Answer : True Kerma can be calculated as

Q: Calculate the mean and 90% confidence interval for the data set. Sample Value 8.0626 8.0650 3 8.0583…

A:

Q: Can someone explain how the answer is 221.1416? Im getting 209.169003

A:

Q: Please explain exactly how to plot and solve. TYIA Pressure trial 1: 0.0759938 density trial 1:…

A: A substance in gas phase can be defined based on four variables. These variables are used to…

Q: how do i find the regression line formula and r ^2 labeled on the graph?

A: To find regression formula and r2 we can use Excel.

Q: Determine the equation of line with x intercept -3 that is perpendicular to a line x-3y-16=0

A:

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.