Suppose the Vole memory cells at addresses 0XB0 to 0XB8 contain the bit patterns given in the following table: Address Contents OXBO Ox13 OXB1 OXB8 OXB2 OXA3 OXB3 Ох02 ОхB4 Ох33 OXB5 OXB8 OXB6 OXCO OXB7 Ох00 OXB8 OXOF a. If the program counter starts at 0XB0, what bit pattern is in register number 0x3 after the first instruction has been executed? b. What bit pattern is in memory cell 0XB8 when the halt instruction is executed?

Q: Address Content 50 10 51 57 52 21 53 OA 54 52 55 01 56 32 57 58 59 Со 00 Suppose the memory cells at…

A: 'A'is the hexa decimal value in register o

Q: Address Content 50 10 51 57 52 53 21 OA 54 55 52 01 56 32 57 СО 58 59 00 Suppose the memory cells at…

A: Answer: I have given answer in the brief examples

Q: Address Content 50 10 51 57 52 21 OA 53 54 52 55 01 56 32 57 58 CO 59 00 Suppose the memory cells at…

A: Here, I have to answer the above question.

Q: 1. Suppose the Vole memory cells from addresses 0x00 to 0x05 contain the bit patterns given in the…

A: We must demonstrate the execution of the above-mentioned assembly program in which the vole cell…

Q: Address Content 50 10 51 57 52 21 53 0A 54 52 55 01 56 32 57 CO 58 CO 59 00 Suppose the memory cells…

A: Find the required answer given as below:

Q: Suppose the memory cells at addresses B0 to B8 in the machine described in Appendix C contain the…

A: B0 13 B1 B8 B2 A3 B3 02 B4 33 B5 B8 B6 C0 B7 00 B8 0F

Q: 3. Suppose the memory cells at addresses A4 to B1 in the machine described in Appendix C contain the…

A: According to the information given:- We have to answer the machine started with its program counter…

Q: Suppose memory holds the following data values in these addresses: Address: Data: 1000: 25 1004: 33…

A: This is has used the concept of index addressing mode. Here is the explanation:

Q: Suppose the memory cells at addresses 50 through 59 contain the bit patterns above written in…

A: ANSWER: It's simpler to communicate a parallel worth to someone else as "B" then, at that point, it…

Q: Suppose the hypothetical processor has two I/O instructions:  0011=Load AC from I/O 0111=Store AC to…

A: Given:- 0011=Load AC from I/O0111=Store AC to I/O

Q: Consider a memory implemented for 8086 microprocessor Draw the memory block diagram. Determine the…

A: Actually, the answer has given below:

Q: Data bytes are stored in memory locations from 8050h to 805FH. Write 8085 ALP to transfer the data…

A: Write ALP to transfer the data to the location 8150h to 815Fh in the reverse order ..

Q: 3- Suppose that ECx=12345678h , EBx=87654321h ,and DS=1100h. Determine the contents of each address…

A: Suppose that ECx =12345678h, EBx=87654321h,and DS =1100h .

Q: Assume that the base address of 8255-PPI chip is OC00H and the address of port C of the chip is…

A: Assembly level language is a low-level programming language, that's used to communicate directly…

Q: Below is a list of 64-bit memory address references given as word address. Ox03, Oxb4, Ox2b, Ox01,…

A: The solution for the above-given question is given below:

Q: Consider the basic computer whose microinstruction set is described by table 1. If the f Address E02…

A: It is defined as a type of computer memory used to quickly accept, store, and transfer data and…

Q: the hypothetical processor has two I/O instructions: 0011=Load AC from I/O 0111=Store AC to I/O In…

A:

Q: Answer the question below based on given portion of the memory unit with a word size of 8 bits, and…

A: Provided below is the detailed step by step explanation for finding the missing fields in the memory…

Q: The first two bytes of a 4M x 16 main memory have the following Hex values: Byte 0 is FE Byte 1 is…

A: Hey, since there are multiple questions posted, we will answer first question. If you want any…

Q: Consider a MIPS processor and a program that is loaded in the main memory between the addresses 130h…

A: Explanation done in step 2

Q: Show how the following values would be stored by byte-addressable machines with 32-bit words, using…

A: Answer:-

Q: Variable x has 4-byte representation 0x01234567 Address given by &x is 0x100 If the machine uses…

A: Variable x has 4-byte representation 0x01234567   Address given by &x is 0x100   If the machine…

Q: uppose the hypothetical processor has two I/O instructions: 0011=Load AC from I/O 0111=Store AC to…

A:

Q: 1. The hypothetical machine of figure 3.4 also has two I/O instructions: 0011= Load AC fro I/O 0111=…

A: Given:

Q: 1. Suppose 8 bit registers have following contents X=00001111 Y=10101010 Z= 11011011 W=00110011 What…

A: The gate OR is equal to the input AND gate. The gate OR gate is the same size as the NAND gate…

Q: Suppose we have a byte-addressable computer using fully associative o 20-bit main memory addresses…

A: Actually, 1 byte =8 bits. cache memory is a fast access memory.

Q: Q: Suppose the hypothetical processor has two I/O instructions:  0011=Load AC from I/O 0111=Store AC…

A: Given data  uppose the hypothetical processor has two I/O instructions: 0011=Load AC from…

Q: Let (BX)=100H, DI=200H, DS=1200H, SI= FO02H, AX= 0105H, and the following memory content. what is…

A: Solution:

Q: What is the highest address possible if 16 bits are used for each address? A. 65536 B. 12868 C.…

A: Answer : - option A) 65536

Q: Consider the following registers X and Y of a certain computer contains the decimal values 1024 and…

A: Introduction.  Given,     register  X=1024     register Y=4096  Three instructions, are given:-  I1.…

Q: A-Calculate the offset address for the following. Assume all numbers in hexadecimal and the first…

A: Here there are multiple questions so i am providing answer of 1st question in step2. And post 2nd…

Q: llión Suppose you have a RISC machine with a This particular computer uses an instruction cache, a…

A: The answer is

Q: Give the value of register A after the execution of the following program on an i8085 CPU. The…

A: 8085 Instructions: There are six general purpose register in 8085 . B,C,D,E,H and L. LXI - Load the…

Q: Compare zero-, one-, two-, ad three address machines by writing programs to compute (A +BXC) ÷ (D –…

A: Here is the answer with an explanation:-

Q: What are the values stored in memory address [1200] and [1400] after execution, respectively ? MOV…

A: Solution: MOV AL,[1200] will load 25h value in AL register MOV AH,AL ​​​​​​​will load 25h value…

Q: Q1. Draw the register transfer language flow chart for the following program: START: LDA 2050H MOV…

A: Block diagram of the computer system that shows all address, bus, and data buses:

Q: Consider the array : char arr[5]; If address of arr is 100 then what will be the address of…

A: Given: char arr[5]; Address of arr=100. Size of one char = 1 byte. To Find: Address of arr[4]

Q: The following table has memory addresses in each row, and columns which represent each of the MIPS…

A:

Q: B- Calculate the offset address for the following. Assume all numbers in hexadecimal and the first…

A: Here we solve it : ==================================================================== Figure 1:

Q: Suppose the following is the first four lines in the data section of your assembly program. Give the…

A: ANSWER:-

Q: The contents of memory location B0007H are FFH and those at B000AH are O0H. What is the data word…

A: The contents of the memory location B0000H are FFH, and those atB0001H are 00H, what is data word…

Q: The following addresses of a Little-Endian machine contain the given hex values shown. fa 32-bit…

A: Given the following addresse of a Little-endian machine contain the given Hex values show. if  a…

Q: For the 8086 microprocessor, show the physical addresses and the contents of memory after execution…

A: The DW,DD and DB are data declaration directives 1. DW: Directive used to declare Word type…

Q: For the 8086 microprocessor, show the physical addresses and the contents of memory after execution…

A: The DW,DD and DB are data declaration directives 1. DW: Directive used to declare Word type…

Q: A computer with a 32-bit word uses an instruction format that includes direct and indirect…

A: The answer given as below:·

Q: Suppose you have a RISC machine with a 2.7 GHz clock (i.e., the clock ticks 2.7 billion times per…

A: The answer is

Q: Consider the RAM16X8 of SAP-1 whose contents are given (in hexadecimal) as following. Address  (Hex)…

A: Check further steps for the answer :

Q: 2. Consider the initial value of register Stia Ox12345678 and the content of memory location…

A: Consider the initial value of register $t1 is 0x12345678 and the content of memory location…

Q: The following is a code segment with a routine named MAIN which calls a subroutine named SUB. X, Y,…

A: Below find solution in step 2

Q: For a system employing paging, consider a logical address space of 1024 pages of 4096 bytes, mapping…

A: Here, we must locate but is utilized for the logical address space (LAS).. LAS is made up of two…