Suppose you take a trip to the local coffee shop to order a regular cup of hot coffee ( temperature = 100°C) which is about 12 ounces (approximately 360 mL). How many milliliters of water at 15°C with a density of 0.999 g/mL should be mixed with the coffee to lower the temperature to 60°C? (Assume the specific heat and density of the water and coffee are the same.) Select one: a. 150 mL b. 320 mL c. 475 mL d. 550 mL

Suppose you take a trip to the local coffee shop to order a regular cup of hot coffee ( temperature = 100°C) which is about 12 ounces (approximately 360 mL). How many milliliters of water at 15°C with a density of 0.999 g/mL should be mixed with the coffee to lower the temperature to 60°C? (Assume the specific heat and density of the water and coffee are the same.) Select one: a. 150 mL b. 320 mL c. 475 mL d. 550 mL

General, Organic, and Biological Chemistry

7th Edition

ISBN:9781285853918

Author:H. Stephen Stoker

Publisher:H. Stephen Stoker

Chapter2: Measurements In Chemistry

Section: Chapter Questions

Problem 2.106EP

See similar textbooks

Similar questions

During a recent winter month in Sheboygan, Wisconsin, it was necessary to obtain 3500 kWh of heat provided by a natural gas furnace with 89% efficiency to keep a small house warm (the efficiency of a gas furnace is the percent of the heat produced by combustion that is transferred into the house). (a) Assume that natural gas is pure methane and determine the volume of natural gas in cubic feet that was required to heat the house. The average temperature of the natural gas was 56 F; at this temperature and a pressure of 1 atm, natural gas has a density of 0.68 1 g/L. (b) How many gallons of LPG (liquefied petroleum gas) would be required to replace the natural gas used? Assume the LPG is liquid propane [ C3H8 : density, 0.5318 g/mL; enthalpy of combustion, 2219 Id/mo for the formation of CO2(g) and H2O(l) ] and the furnace used to burn the LPG has the same efficiency as the gas furnace. (c) What mass of carbon dioxide is produced by combustion of the methane used to heat the house? (d) What mass of water is produced by combustion of the methane used to heat the house? (e) What volume of air is required to provide the oxygen for the combustion of the methane used to heat the house? Air contains 23% oxygen by mass. The average density of air during the month was 1.22 g/L. (f) How many kilowatt—hours ( 1kWh=3.6106 J) of electricity would be required to provide the heat necessary to heat the house? Note electricity is 100% efficient in producing heat inside a house. (g) Although electricity is 100% efficient in producing heat inside a house, production and distribution of electricity is not 100% efficient. The efficiency of production and distribution of electricity produced in a coal-fired power plant is about 40%. A certain type of coal provides 2.26 kWh per pound upon combustion. What mass of this coal in kilograms will be required to produce the electrical energy necessary to heat the house if the efficiency of generation and distribution is 40%?
what volume of water (in ml), initially at 54.3 C, needs to be mixed with 146ml of water, initially at 29.1 C, so that the final temperature of the water is 35.2 C? Assume that the density of the water remains constant over the above temperature range? ? mL
An adult eats food whose nutritional energy totals approximately 2100 CalCal per day. The adult burns 1800 CalCal per day. If 1 lb of fat is stored by the body for each 1.46 x104 of excess nutritional energy consumed, how long will it take this person to gain 1 lblb? Express your answer using one significant figure.
An adult eats food whose nutritional energy totals approximately 2200 Cal per day. The adult burns 2000 Cal per day. If 1 lb of fat is stored by the body for each 14.6×103kJ of excess nutritional energy consumed, how long will it take this person to gain 1 lb? Express your answer using one significant figure.
You are asked to calibrate a 25 mL volumetric pipet. You determine that the temperature of your distilled water is exactly 24.5 degrees Celsius. You carefully determined the mass of a clean dry beaker and found that it was 57.5513 g. You pulled water up to the mark and transferred this to the beaker and found that the new mass was 82.9344 g. What is the actual volume of the pipet? The density of water at 24.5 degrees Celsius is 0.997983 g/mL.
1. A hot tub is filled with 570 gal of water a. What is the volume of water, in liters, in the tub? b. What is the mass, in kilograms, of water in the tub? c. How many kilocalories are needed to heat the water from 62 °F to 105 °F? d. If the hot-tub heater provides 5900 kJ/min, how long, in minutes, will it take to heat the water in the hot tub from 62 °F to 105 °F?
In a large building, oil is used in a steam boiler heating system. The combustion of 1.0-lb of oil provides 2.4 x 10^7J. How many kilograms of oil are needed to change 190kg of water of steam at 100 Celsius? Express your answer to two significant figures and include the appropriate units.
A sheet of gold weighing 8.6g and at a temperature of 14.9C is placed flat on a sheet of iron weighing 19.6g and at a temperature of 58.9C . What is the final temperature of the combined metals? Assume that no heat is lost to the surroundings. Be sure your answer has the correct number of significant digits.
A student notices that her father (who is trying to lose weight) is drinking a lot of diet Pepsi with the artificial sweetener aspartame. The student has read that aspartame, at high doses, may be a carcinogen. She has read that the FDA recommends no more than 50.0 mg of aspartame per kg of body weight per day. Given that her father weighs 175 pounds, how many cans of diet Pepsi can he “safely” consume per day? (453.6 g/1 pound; 177 mg aspartame/can diet Pepsi)
The temperature at which a fuel begins to burn is called the ignitiontemperature. The ignition temperature for #2 fuel oil is 700°F. Find the ignitiontemperature in degrees Celsius. Round the answer to the nearer tenth.
In Dexter’s lab, he pours 0.720kg of molten gold at 1063°C into a 1.30kg iron cauldron filled with 2.70kg of water both at 15.0°C. At the same moment he drops a 0.400kg piece of ice initially at -20.0°C into the cauldron and begins to stir. If we treat the cauldron and its contents as a calorimeter, what will be the final temperature for the system in degrees Celsius?
In the task of the temperature scales, you lacked the formulas and the procedure in the exercises. These videos will help you answer this task ‌1) Convert from Celsius to Fahrenheit: [https://youtu.be/gHkn9zfXp3s‌] 2) Convert from Fahrenheit to Celsius: [https://youtu.be/K6tJAznwQR8‌] ** 3) Convert from Kelvin to Fahrenheit: [https://youtu.be/3HfRka2LKvI]