K=200 NmwwwA10 kgMK = 0.1BбокуB1System startsfrom rest.Determine thevelocity of"after B hasfallen down0.5m0.5m*System starts from rest* Determine the Velocity of "A" after B has fallen down 0.5m.(Spring Constant 'K' =200N/m) (Friction Coefficient =0.1) (Mass of A=10kg) (Mass of B=60kg)"1"A"

Name: K=200 NmwwwA10 kgMK = 0.1BбокуB1System startsfrom rest.Determine thev
Uploaded: 2024-03-20T06:58:04.000Z
Channel: Bartleby
Description: K=200 NmwwwA10 kgMK = 0.1BбокуB1System startsfrom rest.Determine thevelocity of"after B hasfallen down0.5m0.5m*System starts from rest* Determine the Velocity of "A" after B has fallen down 0.5m.(Spring Constant 'K' =200N/m) (Friction Coefficient =0

In the given question, Spring constant (k) = 200N/m Mass of A = ma = 10kg Mass of B = mb = 60kg…

Science

Physics

*System starts from rest* Determine the Velocity of "A" after B has fallen down 0.5m. (Spring Constant 'K' =200N/m) (Friction Coefficient =0.1) (Mass of A=10kg) (Mass of B= 60kg)

System starts from rest Determine the Velocity of "A" after B has fallen down 0.5m. (Spring Constant 'K' =200N/m) (Friction Coefficient =0.1) (Mass of A=10kg) (Mass of B= 60kg)

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter7: Work And Kinetic Energy

Section: Chapter Questions

Problem 61P: When a 3.0-kg block is pushed against a massless spring of force constant constant 4.5103N/m , the...

See similar textbooks

Similar questions

A block of mass M rests on a table. It is fastened to the lower end of a light, vertical spring. The upper end of the spring is fastened to a block of mass m. The upper block is pushed down by an additional force 3mg, so the spring compression is 4mg/k. In this configuration, the upper block is released from rest. The spring lifts the lower block off the table. In terms of m, what is the greatest possible value for m?
In a needle biopsy, a narrow strip of tissue is extracted from a patient with a hollow needle. Rather than being pushed by hand, to ensure a clean cut the needle can be fired into the patients body by a spring. Assume the needle has mass 5.60 g, the light spring has force constant 375 N/m, and the spring is originally compressed 8.10 cm to project the needle horizontally without friction. The tip of the needle then moves through 2.40 cm of skin and soft tissue, which exerts a resistive force of 7.60 N on it. Next, the needle cuts 3.50 cm into an organ, which exerts a backward force of 9.20 N on it. Find (a) the maximum speed of the needle and (b) the speed at which a flange on the back end of the needle runs into a stop, set to limit the penetration to 5.90 cm.
A bungee cord is essentially a very long rubber band that can stretch up to four times its unstretched length. However, its spring constant vanes over its stretch [see Menz, P.G. “The Physics of Bungee Jumping.” The Physics Teacher (November 1993) 31: 483-487]. Take the length of the cord to be along the direction and define the stretch as the length of the cord minus its un-stretched length that is, (see below). Suppose a particular bungee cord has a spring constant, for of and for. (Recall that the of (Recall that the spring constant is the slope of the force versus its stretch (a) What is the tension in the cord when the stretch is 16.7 m (the maximum desired for a given jump)? (b) How much work must be done against the elastic force of the bungee cord to stretch It 16.7 m? Figure 7.16 (credit modification of work by Graeme Churchard)
When an 80.0kg man stands on a pogo stick, the spring is compressed 0.120 m. (a) What is the force constant of the spring? (b) Will the spring be compressed more when he hops down the read?
As a 75.0-kg man steps onto a bathroom scale, the spring inside the scale compresses by 0.650 mm. Excited to see that he has lost 2.50 kg since his previous weigh-in, the man jumps 0.300 m straight up into the air and lands directly on the scale. (a) What is the springs maximum compression? (b) If the scale reads in kilograms, what reading does it give when the spring is at its maximum compression?
When an 80.0-kg man stands on a pogo stick, the spring is compressed 0.120 m. (a) What is the force constant of the spring? (b) Will the spring be compressed more when he hops down the road?
A block of mass m, after sliding down a frictionless incline, strikes another block of mass M that is attached to a spring of spring constant k (see below). The blocks stick together upon impact and travel together. (a) Find the compression of the spring in terms of m, M, h, g, and k when the combination comes to rest. Hint: The speed of the combined blocks m + M ( v2 ,) is based on the speed of block in just prior to the collision with the block M ( v1 ) based on the equation v2=(m/m)=M(v1).< This will be discussed further in the chapter on Linear Momentum and Collisions. (b) The loss of kinetic energy as a result of the bonding of the two masses upon impact is stored in the so-called binding energy of the two masses. Calculate the binding energy.
A 35.0-cm long spring is hung vertically from a ceiling and stretches to 41.5 cm when a 7.50-kg weight is hung from its free end. (a) Find the spring constant. (b) Find the length of the spring if the 7.50-kg weight is replaced with a 195-N weight.
Review. This problem extends the reasoning of Problem 41 in Chapter 9. Two gliders are set in motion on an air track. Glider 1 has mass m1 = 0.240 kg and moves to the right with speed 0.740 m/s. It will have a rear-end collision with glider 2, of mass m2 = 0.360 kg, which initially moves to the right with speed 0.120 m/s. A light spring of force constant 45.0 N/m is attached to the back end of glider 2 as shown in Figure P9.41. When glider 1 touches the spring, superglue instantly and permanently makes it stick to its end of the spring. (a) Find the common speed the two gliders have when the spring is at maximum compression. (b) Find the maximum spring compression distance. The motion after the gliders become attached consists of a combination of (1) the constant-velocity motion of the center of mass of the two-glider system found in part (a) and (2) simple harmonic motion of the gliders relative to the center of mass. (c) Find the energy of the center-of-mass motion. (d) Find the energy of the oscillation.
When a 3.0-kg block is pushed against a massless spring of force constant constant 4.5103N/m , the spring is compressed 8.0 cm. The block is released, and it slides 2.0 m (from the point at which it is released) across a horizontal surface before friction stops it. What is the coefficient of kinetic friction between the block and the surface?
You attach a block to the bottom end of a spring hanging vertically. You slowly let the block move down and find that it hangs at rest with the spring stretched by 15.0 cm. Next, you lilt the block back up to the initial position and release it from rest with the spring unstretched. What maximum distance does it move dawn? (a) 7.5 cm (b) 15.0 cm (c) 30.0 cm (d) 60.0 cm (e) The distance cannot be determined without knowing the mass and spring constant.
In a control system, an accelerometer consists of a 4.70-g object sliding on a calibrated horizontal rail. A low-mass spring attaches the object to a flange at one end of the rail. Grease on the rail makes static friction negligible, but rapidly damps out vibrations of the sliding object. When subject to a steady acceleration of 0.800g, the object should be at a location 0.500 cm away from its equilibrium position. Find the force constant of the spring required for the calibration to be correct.