The 28-kg wheel has a radius of gyration about its center O of ko = 220 mm, and radius r = 0.4 m. When the wheel is subjected to the couple moment M = 63 N•m, it slips as it rolls. Determine the linear acceleration of the wheel's center O (in m/s²). The coefficient of kinetic friction between the wheel and the plane is μ = 0.47. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. Take g = 9.81 m/s². M Your Answer: Answer 1

The 28-kg wheel has a radius of gyration about its center O of ko = 220 mm, and radius r = 0.4 m. When the wheel is subjected to the couple moment M = 63 N•m, it slips as it rolls. Determine the linear acceleration of the wheel's center O (in m/s²). The coefficient of kinetic friction between the wheel and the plane is μ = 0.47. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. Take g = 9.81 m/s². M Your Answer: Answer 1

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The uniform 140-lblb beam is initially at rest when the forces are applied to the cables. Set FAFAF_A = 70 lblb and FBFBF_B = 190 lblb .(Figure 1) Determine the magnitude of the acceleration of the mass center at this instant. Determine the angular acceleration of the beam at this instant.
The body and bucket of a skid steer loader has a weight of 2000 lb, and its center of gravity is located at G. Each of the four wheels has a weight of 100 lb and a radius of gyration about its center of gravity of 1ft. If the engine supplies a torque of M = 100 lb ft to each of the rear drive wheels, determine the speed of the loader in t = 10 s starting from rest. The wheels roll without slipping
6/40 If the frictional moment at the pivot O is 2 N+m, de- termine the angular acceleration of the grooved drum, which has a mass of 8 kg and a radius of gyra- tion kg = 225 mm. 200 mm kg 12kg
The racing vehicle has a mass of 750 kg and center of mass in G. If there is no slippage, determinate the normal reaction, in Newtons, presented on each of the front wheels in A, when an acceleration of a = 6.4 m/s².
At the instant shown, the spring is undeformed. Determine the change in potential energy if the 20 kg disk (radius of gyration = 0.5 m) rolls 2 revolutions without slipping. Note that the shown velocity vector refers to the translation of the centre of the wheel. Choices are in image.
The pendulum has a mass of 8.8 kg, a centre of gravity at G, and a radius of gyration of 0.31 m about the fixed pin support at O. At what position (in degrees) must the pendulum by released from rest so that its angular acceleration is 18.6 (clockwise) at that instant? Take = 0.25 m. The motion occurs in a vertical plane and friction is negligible. Choose the correct answer. 43.2 36.7 34.6 48.4 41.1
If the cord is subjected to a horizontal force of P = 150 N, and gear is supported by a fixed pin at O,determine the angular velocity of the gear and the velocity of the 20-kg gear rack in 4 s, starting from rest. The mass of the gear is 50 kg and it has a radius of gyration of k0 = 125 mm. Assume that the contact surface between the gear rack and the horizontal plane is smooth.
The wheel has a mass of 100 kg and a radius of gyration of kO = 0.2 m. A motor supplies a torque M = (40u + 900) N #m, where u is in radians, about the drive shaft at O. Determine the speed of the loading car, which has a mass of 300 kg, after it travels s = 4 m. Initially the car is at rest when s = 0 and u = 0°. Neglect the mass of the attached cable and the mass of the car’s wheels
The dynamic system is initially at rest. The rod has a mass of m=0.5kg and a length of L=1m. The CG of the rod is located at G, and the rod is rotated about the point O, a distance, h=0.25m, away from point G. At the time of releasing find a. Acceleration at the CG (point G) b. Reaction at O (Use moment of inertia of the rod I= mL2/12)
At the instant shown, the 200-lb bar rotates clockwise at 4 rad/s. The spring attached to its endalways remains vertical due to the roller guide at C. If the spring has an unstretched length of 2ft and a stiffness of k = 9 lb/ft, determine the angular velocity of the bar the instant it has rotated 39° clockwise.
The 153-kg wheel has a radius of gyration about its center of mass O of kO = 283 mm. If it rotates counterclockwise at an angular speed of 1431 rev/min and the tension force applied to the braking band at A is TA = 1771N,a) Determine the angular acceleration, in rad/s2, so that the wheel comes to rest in 67.6 revolutions after TA and TB are applied.
Q1: A cylindrical body has a mass Mand outer radius R (the moment of inertia I I= 1 2 MR^ 2 ) starts to roll from rest (upper position) down on an inclined surface. If the effect of friction force was ignored, determine the linear speed of the cylinder when it hits level ground a height h lower.