The antacid TUMS was titrated using 0.3 m HCl. The buret reading was initally 0.53ml. After reaching the end point the final volume reading was 27.82ml. What volume of HCl was used in this titration? Include unit in the answer.

Q: *WRITE RESULTS AND DISCUSSIONS OF TITRATION- CONCENTRATION OF VINEGAR *WRITE CONCLUSION

A: A question based on acid-base titrations that is to be accomplished.

Q: How many milliliters of 0.0854 M NaOH are required to titrate 25.00 mL of 0.1250M HI to the…

A: The quantity of titrant applied is just enough that totally neutralize the analyte solution at the…

Q: How to prepare the following for a titration procedure? 1. 20 mL of 2 M HCl 2. 20 mL of 0.05 M KOH…

A: Molarity - It is defined as moles of solvent dissolved per liters of solution. The molar mass  of  H…

Q: Should the molarity of the base change when titrating? Explain

A: Titration can be defined as the slow addition of one solution with known concentration to a known…

Q: piper ets of 0.545 M NaOH into a test tub nto a small beaker to keep it from spilling and then…

A: Given,  Molarity of NaOH = 0.545 M Volume of NaOH  = 25 mL Mmol of NaOH = M × V = 0.545 × 25 =…

Q: In acid-base titration one of :the following is incorrect

A: The end point will be sharper when concentrated solutions are used because more concentrated…

Q: Determine the titration curve for HCl marked with the titration end point

A: The titration curve is given below

Q: A solution is prepared by diluting 20.0 mL of 0.0010 M HCl to a final volume of 2.00 liters. What…

A: Consider the given information is as follows; Volume of initial HCl solution V1= 20.0 mL = 0.02 L…

Q: Use the References te access important values if needed for this question. A 50.0 ml. sample of a…

A: Given information: Concentration of acetic acid = 0.378 M Concentration of barium hydroxide = 0.328…

Q: What volume in mL of 0.1444 M NaOH is required to titrate 15.00 mL of 0.1097 M  acetic acid (HAc)?

A:

Q: How many moles of Li2CO3 were titrated if 18.24 mL of 0.243 M HCl was required?

A: Given :- molarity of HCl solution = 0.243 M               Volume of HCl solution = 18.24 mL  To…

Q: How would we know if we have reached the end point if we were titrations a base with acid? Assume…

A: An acid base titration is performed using phenolphthalein indicator which changes colour at the end…

Q: How many ml of NaOH stock solution have been added to establish the buffer?

A: To prepare the desired buffer solution, at first, an acetic acid solution was taken and NaOH was…

Q: Give a example of an acid base titration with the equation other than naoh and hcl

A:

Q: Titration of 17.85 mL of HNO3solution requires 16.00 mLof 0.1600 M KOH solution. What is the…

A: Given information: Volume of HNO3 = 17.85 mL Volume of KOH = 16.00 mL Concentration of KOH = 0.1600…

Q: A Determine the concentration of the titraut (NAOH). B) Determine the concentration of the unknown…

A: A) The concentration of NaOH is determined by standardization with KHP- Mass of KHP titrated =0.85 g…

Q: Demonstrate an understanding of acids and bases andtheir relationship with buffers.

A: A buffer is simply a mixture of a weak acid and its conjugate base or a weak base and its conjugate…

Q: 1. If 16.33 mL of 0.6664 M KOH was needed to titrate a sample of HC;H;O2to its equivalence point,…

A:

Q: is the point at which the titration is complete * O Endpoint O equivalence point Boiling point none…

A: We have to tell the name of the point at which titration is completed. The given options are End…

Q: In an acid-base titration,21.16 mL an NaOH solution are needed to neutralize 20.04 of a 01.0997 M…

A:

Q: A 100.0 mL of 0.1 M HCI solution is mixed with a 50.0 mL of 0.1 M of KOH solution. The resultant…

A:

Q: Explain why pH is observed: ● prior to titration ● before the equivalence point is reached ● at the…

A: Interpretation -  To tell about why pH is observed -  ● prior to titration● before the equivalence…

Q: What volume of 0.200 M NaOH would be required for a titration of 65.00 mL of 0.200 M HCl?

A: In chemistry, there are many ways to check the deviation of experimental data from the accurate…

Q: How does the pH change in a buffered system compared to an unbuffered system?

A: A system of solution in which there is a remarkable amount of a weak base with its conjugate acid or…

Q: The equation Hln = H + In means? آختر احدى الدجابات A. The medium is acidic or basic B. Which form…

A: Hln   = H+  + ln- If acid is added then according to Le-Chatelier’s principle, the reaction will…

Q: Differentiate Direct titration from Residual Titration. Kindly expound, because our learning…

A: There are mainly two type of titration in analytical chemistry, one is direct titration and another…

Q: 1. Describe how the technique of back titration could be used in an acid-base neutralization if the…

A: "Since there are multiple question, and it is not specified which question has to solve , i am…

Q: A sample containing 26.38 mL of 0.1439 M HBr is titrated with a solution of NaOH having a molarity…

A: pH is defined as the negative logarithm of hydronium ions. pH value ranges from 0 to 14. 0 is very…

Q: le is titrated wit

A: Let, KCI= a% and KI= b%. So, 0.50×a10074.55 ×143.32+0.50×b100166.00×234.77=0.2818…

Q: Solution Measured pH Theoretical [H30*| |Calculated pH Distilled water 7.10 Original buffer solution…

A:

Q: Suppose you are performing acid-base titration with HCl and NH4OH, select your indicator with…

A: In case of Strong acid and weak base just like HCl and NH4OH we use indicator methyl orange since it…

Q: A volume of 25.0 mL of 2.75 M HCl, is to be titrated with 1.025 M strong base, B(OH)2. Calculate the…

A: The strength of an acid solution is determined by titrating it against a standard base solution or…

Q: "Sodium hydrogencarbonate is a basic salt”. Justify the statement. How is it converted into washing…

A: Sodium hydrogen carbonate is an inorganic compound that has chemical formula NaHCO3. Sodium hydrogen…

Q: How many indicators in acid base titration. O Three. O Four. O Five.

A: Acid base titration are those in which acid is neutralised by base.

Q: Titration of 25 mL 0.01 M NAOH with HBr pH at EP when [HBr] = pH at EP when [HBr] 0.10 M 0.0010 M 2.

A: Given: Titration of 0.01 M NaOH with HBr. Case I: [HBr] used = 0.10 M Case II: [HBr] used = 0.0010 M…

Q: What is buffer solution?give the application of buffer with proper example?

A: A solution is made up of two components - solute and solvent. A solution can be heterogeneous and…

Q: What is the preferred acid for titrating bases

A:

Q: dissolve in HCI?

A:

Q: Buffering Capacity is the number of millimoles of acid or base to be added to a litre of buffer…

A:

Q: Given below Some Statement Choose the Love Statement acid-base litration the indicator is a usually…

A:

Q: The antacid "TUMS" was titrated using 0.3 M HCl. The buret reading was initially 2.67 mL. After…

A:

Q: A solution is prepared using 15.0 ml of 1.0 M HCl and 20.0 ml of 0.50 M HNO3. The final volume of…

A: Given: (15 ml of 0.15 M HCl)  +  (20.0 ml of 0.50 M HNO3.) The total volume of the solution= 1.25 L…

Q: Can you perform a titration to which, the acid is the titrant and the base is the analyte? (The…

A: A titration is an analytical method to find the concentration of an unknown solution from a solution…

Q: tion is standardized by titrating with a solution conta O3 and boiled to remove carbon dioxide. The…

A: According to the question, HCl solution is standardized by titrating with solution containing Na2CO3…