The color change of a chemical indicator requires an overtitration of 0.03 mL. Calculate the percent relative error if the total volume of titrant is (a) 50.0 mL (b) 10. 0 mL (c) 25.0 mL (d) 30. 0 mL
Q: One of the following statements is incorrect: Titration error is the difference between equivalence…
A: A titration is the process of determining the quantity of a substance A by adding measured…
Q: 10. The color change of a chemical indicator requires an over titration of 0.03 mL. Calculate the…
A: Given, The error in measurement = 0.03 mL The experimental values are 50.00 mL, 10.0 mL, 25.0 mL,…
Q: pka=pH halfway to the equivalence point. what is the equivalence point volume? it says to do so by…
A: Introduction: Titration is the process to find concentration of unknown solution using known…
Q: 6 ml of water used (5 ml of tap water 1ml of buffer) Hard Water Trial 1 Hard Water Trial 2…
A: We would use given instructions for calculation to proceed for calculation. For this we would use…
Q: What is the assay for Potassium iodide? Write down chemical reaction(s), the indicator used,…
A:
Q: Application (specific analysis) General Primary standard Specific Titrimetric Titrant Indicator End…
A:
Q: Procedure: 0.0402 g of water was titrated with Fisher's reagent according to the pharmacopoeial…
A: The T-factor for the mentioned titration can be calculated using the expression: =0.1566×weight of…
Q: At the half-way point in the titration of a weak acid with a strong base the pH was measured as…
A: Given: pH of the acid at half-way point = 5.16
Q: DIFFUSSION + Tube No. Sample RANK COLOR OF SOLUTION Copper (II) sulfate 2 Prussian blue 3 Methyl…
A: A question based on velocity of diffusion, which is to be accomplished.
Q: Based on the graph, what is the pKa of vinegar?
A: The dissociation of an acid (HA) is shown below. The expression for dissociation constant (Ka) is…
Q: Which of the following is a good description of a standard solution as a titrant? Section а.…
A:
Q: 6ml of water used (1ml of buffer and 5ml of soft water) Hard Water Trial 1 Hard Water Trial 2…
A: We would use the given calculations steps to calculate ppm of CaCO3. For this we would use volume…
Q: Concentration of HCl used: 25ML Volume of HCl used: 0.1031 Indicator: phenaiphthalein (pneno)…
A:
Q: What is the MW of calcium carbonate?
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Calibrate the pH meter @ pH 4, 7 and 10.
A: Interpretation: To calibrate the pH meter @pH 4, 7 and 10.
Q: Suppose you did the titration three times and got the following data for the concentration of NaOH:…
A: The question is based on the concepts of analytical chemistry. we have to determine the relative…
Q: If the titer during the standardization procedure of HCI is 32.50 ml by using 0.2115 grams of sodium…
A: here we are required to find the percent error in the concentration of sodium carbonate
Q: pka=pH halfway to the equivalence point. what is the equivalence point volume? it says to do so by…
A: A titration curve represents pH of the solution with volume of base added.
Q: which of the following is secondary standard ? A) hydrochloric acid B) sodium oxalate , C)…
A: Given compounds, A) hydrochloric acid B) sodium oxalate C) potassium hydrogen phthalate D) sodium…
Q: 4) A series of titrations gave the following concentration (M) values: 0.517,0.528, 0.521, 0.523.…
A: Molarity is defined as “the mole of the solute per unit volume of the solution”. It is represented…
Q: Hard Water Trial 1 Hard Water Trial 2 Hard Water Trial 3 Initial Syringe Reading (mL) 1ml 1ml…
A: We would use the volume of water to calculate moles of CaCO3. Then from moles we would calculate…
Q: What is the difference between the equivalence point and the end
A: Titration reactions also involve color change. These reactions involve end point and equivalence…
Q: otentiometry Topic Briefly discuss the following: 1.different types of membrane indicator…
A: 1. Solution - According to the question - membrane electrodes that produce an electrical potential…
Q: 1. Bromothymol blue indicator is color yellow in an acid solution and ______ in a basic solution. A.…
A: ✓As we know bromthymol blue is a weak acid. It can be in acid or base form, depending on the pH of…
Q: Q(5): .The end point indicator used in Fajan's method is fluorescene, it is consider as Select one:…
A:
Q: Calculate the equivalence factor (F) of the KF reagent if a 180 mg sample of sodium tartrate…
A: Mass/weight = 180 mg Volume = 15 ml Equivalence factor (F) = ?
Q: 13. Anhydrous sodium carbonate is used as the primary standard to determine the exact concentration…
A: A primary standard is generally used in titrations to identity the end-point. It must be highly…
Q: Please can you help me fill in the blanks, with proper calculations thank you.
A:
Q: A solution containing sodium fluoride is mixed with a solution containing magnesium nitrate to form…
A: Given, concentration of NaF = 0.0080 M Concentration of Mg(NO3)2 = 0.070 M.
Q: calculate the neutralization equivalent for malonic acid and maleic acid
A: For an acid, neutralization equivalent is determined as- Neutralization Equivalent = Molecular…
Q: -Volume of unknown acid___ -Average molarity of NaOH from above__ -mL of NaOH at equivalence point__…
A: Solutions- Given data- Sheet of pH readings, Molarity of NaOH etc.
Q: 6ml of water used (5ml of hard water and 1ml of buffer) Hard Water Trial 1 Hard Water Trial…
A: We would use the given formula to calculate the water hardness ( ppm CaCO3 ) .
Q: Use acid-base titration to determine the concentration of: – A strong acid: HCl Phenolphthalein is…
A: An acid – base titration is used to determine the unknown concentration of an acid or base by…
Q: Example #5) 10mL of 3.0M HBr is mixed with 20mL of 2.0M KOH HBr + KOH → H₂O + KBr Substance H₂O HBr…
A: Using the stoichiometry of acid to base, moles of water formed can be calculated which helps in…
Q: pka=pH halfway to the equivalence point. what is the equivalence point volume? it says to do so by…
A: The Inflection point of a titration curve is defined as the point where the curve is changing from…
Q: d) If the uncertainty in one volume reading for the class A burette used is 0.03 mL., find the…
A:
Q: Application (specific analysis) General Specific Primary Titrimetric Titrant Indicator End Point…
A: Four types of titrimetric methods are: 1. Acid-base (neutralization) 2. Precipitation 3.…
Q: The color change of a chemical indicator requires an over-titration of 0.03 mL. Calculate the…
A: Use the following formula to calculate the percent relative error:
Q: 1. It is a reagent of known concentration used in titrations * analyte solution normal solution…
A: Titration is a method to determine the concentration of an unknown solution by using the solution of…
Q: If 20 mL of a hydrochloric acid solution (HCl) required 18 mL of a sodium hydroxide in a titration…
A: Given that, Volume of HCl = 20 mL Volume of NaOH required for neutralization of 20 mL HCl = 18 mL…
Q: You want to determine the concentration of NaCl in a water. In preliminary analysis, it appears to…
A: A numerical problem based on quantitative analysis, which is to be accomplished.
Q: A 50.00 (±0.02) mL portion of an HCl solution required 29.71(±0.02) mL of 0.01963(±0.0032) M…
A:
Q: Formulate a hypothesis regarding the solubility of aspirin at different pH. The experiment A) Three…
A: Hii there, As there are multiple sub parts posted. we are answering first-three sub parts . If you…
Q: Question 2 (b) Name and discuss five stages in which gravimetric analysis procedure may be divided
A: Interpretation- In the given question-2(b) we have to discuss five stages in which gravimetric…
Q: Which of the following statements are correct? K2CrO4 is used as an indicator in the argentometric…
A: An indicator can be defined as a substance that changes colour of solution on addition to acidic or…
Q: QUESTION 2 One statement is not true regarding the determination of pka of Bromothymol Blue…
A: A question based on Beer-Lambert law, which is to be accomplished.
Q: Calcium is determined in serum by microtitration with EDTA. A 100-μL sample is treated with two…
A: Volume of sample = V1 = 100ml = 0.1L Volume of EDTA = V2 = 0.203L Molarity of EDTA = M2 = 0.00122 M…
Q: Application (specific analysis) General Specific Method Primary Titrimetric Titrant Indicator End…
A: There are various method in inorganic chemistry to estimate the unknown concentration. Titration is…
Q: Which type of indicator is used in Fajans-Fisher-Khodakov method adsorption indicator; irreversible…
A: The correct option is given in the next step:
The color change of a chemical indicator requires an overtitration of 0.03 mL. Calculate the percent relative error if the total volume of titrant is (a) 50.0 mL (b) 10. 0 mL (c) 25.0 mL (d) 30. 0 mL
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 4 images
- what is the significance of gravimetry analysis?A sample containing BTEX What is the appropriate quantitative and qualitative analysis method for it in the laboratory?If the initial recorded volume titrated is 0.50 ml and the final recording is 26.95 ml, what is the total volume given a 50 ml burette?
- Give one application of tacheometry.A man went door to door posing as a goldsmith He promised to bring back the glitter of the old and dull ornaments An unsuspecting lady gave a set of gold bangles to himwhich he dipped in a particular solution The bangles sparkled like new but their weight was reduced drastically The lady was upset but after a futile argument the man beat ahasty retreat Can you play the detective to find out the nature of the solution he had used?give a specific example of gravimetry analysis by enumerating the steps of the analysis
- The purity of KHP was determined by first weighing KHP using weighing by difference. and the weighed sample was titrated with NaOH solution. Calculate the % purity of the KHP sample given the following data. Express your answer in 2 decimal places. No need to include the unit. I need anwer asap please show solution this is analytical chemistryWhen a Vitamin C (ascorbic acid; MM = 176.12 g mol-1) tablet is crushed, dissolved and titrated with 0.0340 M KIO3(aq) to a purple/blue endpoint (given by a starch indicator), the volume of KIO3 used is 29.80 mL. If 60 mg of ascorbic acid is the recommended dietary allowance (i.e., 100% of the RDA), then what is the % RDA for the Vitamin C in the tablet? KIO3(aq) + 5 KI + 6 H+ → 3 I2(aq) + 3 H2O I2 (aq) + ascorbic acid → 2 I- + dehydroascorbic acid1. A group of students from the instrumental analysis laboratory of the course analyzed the sodium content in a serum sample using ICP-OES. They used 5 flasks with 25 mL of sample serum in each and added different amounts of a standard 2.640MNaCl solution to a total volume of 50 mL . Calculate: a. Equation for calibration b. Serum sodium concentration
- A student performed a titration on a commercial acid certified to be 0.500 M. Using her data from the titration, the student determined her sample to be 0.487 M. Assuming the certified value was the true value, what was the percent error of her measurement?What is an analytical balance?In an analysis of vinegar by titration, a student placed the vinegar in the buret and a measured volume of NaOH with phenolphthalein indicator in an Erlenmeyer flask. What observation should the student expect? choices a.The solution in the flask would be colorless and would turn dark pink at the end point. b.The solution in the flask would be faint pink and would turn colorless at the end point. c.The solution in the flask would be dark pink and would turn colorless at the end point. d.The solution in the flask would be colorless and would turn faint pink at the end point.