The contract load of a medium scale Industry (MSI) at 11 kV, 50 Hz is 0.8 MW, but the maximum demand of that industry in last two years has not exceeded 0.6 MW at average power factor of 0.75, while as per Oman electricity norms power factor must be maintained 0.92 to avoid any penalty. What is capacitor rating (in KVAr) and capacitance (in micro farad) of capacitor bank?" O 364.56 & 9.59 O 374.88 & 7.10 O 445.63 & 32.56 O No option is correct

The contract load of a medium scale Industry (MSI) at 11 kV, 50 Hz is 0.8 MW, but the maximum demand of that industry in last two years has not exceeded 0.6 MW at average power factor of 0.75, while as per Oman electricity norms power factor must be maintained 0.92 to avoid any penalty. What is capacitor rating (in KVAr) and capacitance (in micro farad) of capacitor bank?" O 364.56 & 9.59 O 374.88 & 7.10 O 445.63 & 32.56 O No option is correct

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.11P

See similar textbooks

Similar questions

The length of a three-phase power transmission line with a nominal operating voltage of 69 kV is 16km. The impedance of the transmission line per unit length is 0.125 + j0.4375 ohm/ km. At the end of the line, a 70 MVA star connected load with a power factor of 0.8 back under 69 kV interphase voltage is fed. Capacitive circuit element with a capacitance of 19.14 mikro F / phase is placed as shunt at the end of the transmission line. According to these given; a) Line head voltage and current, b) Calculate the active and reactive power per line.
It is desired to purchase a synchronous condenser to correct the 2,400-KVA 0.67-lagging power factor load in an industrial plant to 0.95 lagging. Neglect losses, calculate: (a) the kilovolt-ampere input rating of the required synchronous condenser; (b) the total kilovoltamperes of the plant. Using the phasor diagram.
Two buses are interconnected by a transmission line of impedance (0.03 + j0.012) pu. The voltage on one bus is 1/0°, and the load on the other bus is (1 + j0.4) pu. Determine the voltage on the second bus. Also calculate the real and reactive power on the first bus.
e) Alternating Current is preferred over Direct Current in Power System, Why? f) Write the Installed Generation Capacity of Sultanate of Oman with current energy share of Conventional and Non-Conventional Energy Sources. g) Why the Capacitance effect is neglected in Short Transmission Line. h) Distinguish between Lumped or Distributed elements in a Transmission Line.
Please answer quickly "In series-connected ac circuit, the total voltage across the circuit is always equal to the sum of the magnitude (only) of the individual voltage across each element." True False The power factor is equal to cosine of the phase difference. True False A leading power factor means that the circuit is predominantly capacitive in nature. True False "Since most loads are resistive in nature (e.g. motors), improvement of power factor is done by connecting capacitor banks or a synchronous condenser " True False
The yearly load duration curve of a certain power station can be approximated as a straight line ; the maximum and minimum loads being 80 MW and 40 MW respectively. To meet this load, three turbine generator units, two rated at 20 MW each and one at 10 MW are installed. Determine (i) installed capacity (ii) plant factor (iii) kWh output per year (iv) load factor.
A single-phase ring distributor is proposed for a newly constructed hospital for COVID 19 Pandemic in Expo center Lahore which feeds on Johar Town Substation. Isolation and Emergency department will be the load points are 20A at 0.8 p.f lagging and 15A at 0.6 p.f lagging respectively. The total impedance of each section Johar Town Substation to Isolation, Isolation to Emergency, and Emergency to Johar Town Substation will be (1 + j 1), (1+ j2), and (1 + j3) ohms respectively. Analyze the ring distributor and Find the total current fed from Johar Town Substation and current in each section.
For a 152 kV, 60 Hz system, the capacitance up to the location of the circuit breaker is 0.020 micro Farad and the frequency of oscillation is 15 kHz respectively. Calculate the following : (i) inductive reactance of the line (ii) The maximum value of restriking voltage across the contacts of the circuit breaker. (iii) The maximum value of RRRV. ( expected time 10 minutes)
For the given 3-phase power transfer, a star system is associated with a greater insulation. Select one: True False
Two similar star-grounded synchronous generators, one of which has its star point grounded, supply 11 kV three-phase busbars. An 11/66 kV delta/star connected transformer with the star point grounded is supplied from the busbars. The impedances referred to 11 kV, are as given below : Generator Transformer Impedance to positive-sequence currents j3.0 Ω j 3.0 Ω Impedance to negative-sequence currents j 2.0 S2 j3.0Ω Impedance to zero-sequence currents j 1.012 j3.0Ω Determine the fault current for an LG fault (a) on a busbar, and (b) at an hv terminal of the transformer. (c) Find also the voltage to ground of the two sound busbars in case (a).
A short line having an impedance of (2 + j3) ohm interconnects two power stations A and B both operating at 11kV equal in magnitude and phase. To transfer 25 MW at 0.8 power factor lagging from A to B determine the voltage drop must be compensated by the booster so that the voltages are maintain the same at both ends.
1-In series R-L circuit transients, the momentary current imm is directly proportional to the RMS voltage. Select one: True False 2-Symmetrical components method are used to solve the symmetrical faults. Select one: True False 3-If the circuit has leading power factor, then it is called as _______________ circuit. Inductive Capacitive Resistive Resistive and Inductive