The data below was obtained with a Cl- ISE to prepare a plot of mV vs. log[Cl-]. Assume the unknown saltwater solution was diluted as in the procedure before being measured. What is the ppm Cl- of the undiluted unknown solution? Cl- Concentration (ppm) Potential (mV) 10 160 100 94 1000 40 Diluted Unknown Saltwater 132

The data below was obtained with a Cl- ISE to prepare a plot of mV vs. log[Cl-]. Assume the unknown saltwater solution was diluted as in the procedure before being measured. What is the ppm Cl- of the undiluted unknown solution? Cl- Concentration (ppm) Potential (mV) 10 160 100 94 1000 40 Diluted Unknown Saltwater 132

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter15: Molecular Luminescence Spectrometry

Section: Chapter Questions

Problem 15.10QAP

See similar textbooks

Similar questions

Which is not an error associated with an incorrectly defined pH measurement? A) contact potential deviation-AgCl or Ag precipitates due to dilution of KCl or presence of reducing reagentB) alkaline fault - electrode responds to Na+ instead of H+ when [Na+] is low and [H+] is highC) acid error – the measured pH is higher than the actual pH because the glass is saturated with H+ and can no longer be protonatedD) temperature – the pH meter is calibrated at different temperatures from the sample
The permeabilities and ion concentrations are shown below for a squid giant axon at resting potential, Em. Na+ K+ Cl- Concentration out(mM) 463 10 592 Concentration in(mM) 49 340 114 Permeability(10-8 cm/s) 3.5 45 7.3 (a) What is the Nernst potential for Na+? mV(a) What is the Nernst potential for K+? mV(a) What is the Nernst potential for Cl-? mV(a) What is the membrane potential Em according to the Goldman equation?
The representation of the potential of an indicator electrode against the logarithm of the analyte activity is...(1). a straight line for all analyte concentrations. (2). a curve with zero slope for any concentration value below a certain limit. (3). an exponential curve. (4). a logarithmic curve.
A pH probe/meter uses the following equations: Ecell = L + 0.0592 log a1 = L - 0.0592 pH Where L = L1 + EAg/AgCI + Easy= constants L1 = - 0.0592 log a2 a1 = activity of analyte solution a2 = activity of internal solution Questions: How will measured pH value be affected vs “real” pH if the temperature of the sample is 30C when pH was measured? How will measured pH value be affected vs “real” pH if HCl in pH electrode, became 0.15M instead of 0.1M? How pH value will be affected vs “real” pH if the glass of the pH electrode is not fully hydrated? Please answer all questions and provide a brief explanation
0.5M HA sample with 0.2 dissociation; It is placed in a conductivity cell with a length of 0.9 cm and an area of 2 cm2 and its conductivity is read as 300 mS. For this purpose;a) Equivalent conductivity of the electrolyte ?b) Boundary equivalent conductivity ?c) Decomposition constant ?
A standard addition method for the voltammetric determination of Pb2+ involved addition of 5.00 mL of 0.800 x 10-3 M Pb2+ to one of two 25.00 mL aliquots of the sample. Supporting electrolyte and water were then added to each aliquot to give a final volume of 50.00 mL. Calculate the molar concentration of Pb2+ based on the following data Diffusion current of sample only = 78.3 uA A Diffusion current of sample with standard addition = 88.7 uA
In a GC run, dodecane was used as test solute for a 30 m x 250 ?m i.d. DB-5 column. The dodecane peak eluted at 5.2 min. and the distance between its two inflection points was 4.0 s. This was the number of theoretical plates generated by this column:
Indicate the option that is true:(1). An indicator electrode has an upper limit of measurement; That is, it does not serve as a precise analytical instrument when the concentrations of the analyte are very high.(2). Some electrodes take a long time to respond, but that is usually not an insurmountable drawback.(3). The representation of the potential of an indicator electrode against the analyte concentration is a straight line for analyte concentrations below a certain value.(4). For activities lower than the lower detection limit, the electrode always measures the same potential.
Prepare 25ppm of Cd (NO3 )2.4H2O in a 500ml from 1000ppm stock solution of Cd (NO3)2.4H2O
1. 1093-g sample of impure Na2CO3 was analyzed by residual precipitimetry. After adding 50.00 mL of 0.06911 M AgNO3, the sample was back-titrated with 0.05781 M KSCN, requiring 27.36 mL to reach the endpoint. The percentage Na2CO3 (MW = 106.0 g/mole) in the tested sample is ________ % ? Note: Express final answer using least number of significant figures. 2. The alkalinity of natural waters is usually controlled by OH- (MW = 17.01 g/mole), CO3-2 (MW = 60.01 g/mole), and HCO3- (MW = 61.01 g/mole), which may be present singularly or in combination. Titrating a 10.0-mL sample to a phenolphthalein endpoint requires 38.12 mL of a 0.5812 M solution of HCl, and an additional 18.67 mL of the same titrant to reach the methyl orange endpoint. The composition of the sample is _________% CO3-2 and ___________ % OH- Note: Express final answers using least number of significant figures.
A 5.00 mL tap water sample was measured out with a volumetric pipette, and added to a 25 mL Erlenmeyer flask. It was then titrated with a 0.0100 M Na2EDTA.2H2O solution, and found to take 0.635 mL of the EDTA solution to reach the blue endpoint. How many moles of the 0.0100 M Na2EDTA.2H2O were added in the titration reaction? Show calculation. How many moles of calcium ions were reacted? Show calculation.
Allowable recovery from limiting salt calculations Determine the limiting sait and allowable recovery for a brackish water RO system containing the following solutes: calcium 74 mg/L. barium 0.008 mg/L. and sulfate 68 mg/L. Assume 100 percent rejection of all solutes and & polarization factor of 1.15 and ignore activity coeficients (i.e., activity = concentration).