The data below were obtained for the growth of a pure culture of Escherichia coli in nutrient broth at a temperature of 37°C. Determine (1) the specific growth rate and (2) generation time of E. coli and the duration of the (3) lag and (4) log (or exponential) phases. (ln 2 = 0.693) Time (h) 0 1 2 3 4 8 16 32 Bacterial No./mL 104.1 103.9 104.4 105.5 106.5 107.7 108.0 107.6

The data below were obtained for the growth of a pure culture of Escherichia coli in nutrient broth at a temperature of 37°C. Determine (1) the specific growth rate and (2) generation time of E. coli and the duration of the (3) lag and (4) log (or exponential) phases. (ln 2 = 0.693) Time (h) 0 1 2 3 4 8 16 32 Bacterial No./mL 104.1 103.9 104.4 105.5 106.5 107.7 108.0 107.6

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter10: Reconstitution Of Powdered Drugs

Section: Chapter Questions

Problem 8.1P

See similar textbooks

Similar questions

Sydney Brenner isolated Salmonella typhimurium mutants that were implicated in the biosynthesis of tryptophan and would not grow on minimal medium. When these bacterial mutants were tested on minimal medium to which one of four compounds (indole glycerol phosphate, indole, anthranilic acid, and tryptophan) had been added, the growth responses shown in the following table were obtained. Mutant Minimal medium Anthranilic acid Indole glycerol phosphate Indole Tryptophan trp-1 − − − − + trp-2 − − + + + trp-3 − − − + + trp-4 − − + + + trp-6 − − − − + trp-7 − − − − + trp-8 − + − − + trp-9 − − − − + trp-10 − − − − + trp-11 − − − − + Give the order of indole glycerol phosphate, indole, anthranilic acid, and tryptophan in a biochemical pathway leading to the synthesis of tryptophan. Indicate which step in the pathway is affected by each of the mutations.
You are cultivating Escherichia coli in a chemostat culture. The maximum specific growth rate (µmax) of E. coli that you can reach is known as 1.0 h-1 at your culture conditions. Describe what you would observe for each condition if you have the following settings: F (flow rate of the fresh medium into the bioreactor vessel) (L/h) V (Volume of the liquid culture in the bioreactor vessel) (L) a) 1 1 b) 5 4 c) 1 2
A serial dilution of overnight E.coli culture was performed by pipetting 1ml of a bacterial culture into a 9 ml LB medium. After this, from 10-4 and 10-5 dilution tubes 100µl were plated onto LB agar plates. Upon overnight incubation at 37°C, 200 colonies were counted in 10-4 and 22 colonies were present on 10-5 plates. How many colony-forming units were present per ml of the original culture? If the formula for CFU/ml =no. Of colonies/dilution factor*volume of culture plate
E. coli has a doubling time of 0.345 hours at 37 0C. Starting with 1 milligram of cells, assuming a lag phase of 30 minutes and a stationary phase of 30 minutes, what number of cells would you expect at the end of 13h, assuming that besides the lag and stationary phases the culture is continuously in exponential phase. Assume that ln (2) = 0.69 and that the mass of a single cell is 10^(-12) g.
What nutrients do the following media components contain? Peptone Yeast extract Beef extract Potato infusion Agar Why should agar media be completely dissolved before they are dispensed in tubes and plates? What are the bases for pegging the temperature at 1210C for 15-30 minutes during moist heat sterilization and 1800C for two (2) hours using dry heat sterilization? 1.Can you sterilize culture media using dry heat sterilization? Why is that so? You will notice in the videos shown, the cotton plug is not used. What is role of cotton plug in media prep, sterilization and culture of microorganisms? Instead of using cotton plug, plastic screw-cap is used, can you substitute this for the former? Is it technically acceptable in microbiology?Please include source
Lysine decarboxylase media is yellow after incubating an organism in it at 37 degrees for 24 hours. Which of the following can be interpreted from this result? A. The organism did not grow so lysine decarboxylase activity could not be determined. B. The organism is negative for lysine decarboxylase. C. The media is too acidic to determine lysine decarboxylase activity. D. The organism is positive for lysine decarboxylase
Differentiate the growth curve exhibited by the same inoculum under the following conditions. Draw and label the parts of your growth curve. A). If it is exponentially growing and inoculated in the same nutritious medium under the same optimum conditions. B). If it is taken from an old culture and inoculated into the same nutritious medium and incubated under the same optimum conditions in (A). C). If it is taken from an old culture and inoculated to a different and less nutritious medium and incubated under the same optimum conditions as (A).
Consider the sterilization of a sodium gluconate production medium in the holding section of a continuous sterilizer. Assuming constant temperature, the specific death rate constant of the contaminant is 20 s-1 . If the average residence time in the holding section is 10 seconds, calculate the Del factor for the following and explain the results. i. For Pe = 400 ii. For Pe = 400, assuming plug flow iii. For Pe = 100 iv. For Pe = 100, assuming plug flow
How would you make two-fold serial dilutions such that the last tube is a 1:32 dilution of the original, concentrated material? Assume that you need to have at least 500 µl of each dilution, and you should be able to perform the dilutions in microfuge tubes with a maximum capacity of 1.5 ml.
how do microorganisms such as bacteria eliminate harmful reactive oxygen species? Nitrate reduction to nitrite is indicated by the formation of a pink to red colour after addition of nitrate test reagent. However, if a culture does not produce a colour change several posibilies exist. Explain.
You have evaluated the rate of aerobic degradation of organic matter in an industrial wastewater and found that it does not follow normal Monod kinetics. After some testing, you have found that the substrate degradation rate follows the following relationship instead: -rut = k0.5XaS0.5 where -rut = substrate utilization rate (mg/L•day) k = 4 (L/mg•d2) S = substrate concentration (mg/L) Xa = active microbial concentration (mg/L) You have also determined coefficients of bacterial growth on this substrate under aerobic conditions to be Y = 0.25 g VSSa/g substrate and b = 0.08/d. (VSSa, active volatile suspended solids) Estimate the effluent substrate concentration when treating the above wastewater in a CSTR (continuously stirred tank reactor) with recycle while operating at a θx (MCRT, mean cell residence time) of 4 day.
Compute the cfu/g (lactic acid bacteria and coliforms) of these samples given the following values below. Show your solution. Media First Sampling First Sampling First Sampling Second Sampling Second Sampling Second Sampling 10-2 10-3 10-4 10-2 10-3 10-4 VRBA TNTC, TNTC 243, 232 24,22 23, 25 0, 0 0, 0 MRS 32, 40 0, 0 0, 0 TNTC, TNTC TNTC, TNTC 102, 120