Answered: The Electrical resistivity (ρ) of a…

The Electrical resistivity (ρ) of a material is inversely proportional to the length (L) of the material Select one: True False

Understanding Motor Controls

4th Edition

ISBN:9781337798686

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter44: Semiconductors

Section: Chapter Questions

Problem 1RQ

See similar textbooks

Related questions

Q: EXAMPLE OF FAILURE CAUSED BY RESONANCE

A: Explanation Resonance: Resonance is the phenomenon at which the natural frequency is equal to…

Q: Whale and Kanmuro are two islands located in the Chimera archipelago. These two are separated by a…

A: Given Data Maximum Power, Pmax=600 MW=600×106W Operating Voltage, V=500KV Ans(A) Current at full…

Q: Define Resistance Proportional to Velocity ?

A: The resistance that is offered to Velocity is Friction. Friction tries to resist the object to…

Q: 14-Two wires have the same length and the same resistance. One is made from aluminum and the other…

Q: Guardrail is an example of protective equipment which prevent people from falling. Select one: True…

Q: A 24.6 2 resistor found experimentally. in Ohm's law experiments, if its actual value is equal to 24…

A: Option b is correct.

Q: 17. Calculate the equivalent capacitance and the voltage on C, on the circ C₂=5 μF C₂ = 15 μF C₁ =…

A: Given Data :

Q: When the heat gain is less than the heat losses, then Select one: a. We will need a cooling system…

A: option 1 is the correct answer. i.e. we need a cooling system we know that energy balance…

Q: Conductivity readings are often referenced to a specific temperature typically equals for…

Q: Biot number signifies (a) The ratio of heat conducted to heat convected (b) The ratio of heat…

A: Given: Biot number signifies,

Q: 15. The torque carried by a rotating shaft is determined by the diameter of the shaft, the power…

A: Torque is defined as the tendency of a force to rotate the body to which it is applied. S.I unit of…

Q: For a given element in a circuit, current through it was measured to be a constant 4.0 A. If the…

Q: 21. Determine the equivalent resistance, Ry, of the circuit shown. 6Ω 10 Ω 15 Ω Μ 30 Ω 12 Ω α Ω Μα…

Q: If the length of a wire stretched by a load is doubled, then its Young's modulus will Select one: O…

A: Young's modulus is a property of material

Q: e ähäi By using the experiment of series connection: the current at each resistance is equal true…

A: True , is series connection the current at each resistance is equal.

Q: The magnitudes of specific heats depend on the temperature or pressure at which the phase change…

A: 43.The given statement is FALSE.

Q: 1 atm is equal to 10.33 m of water Select one: True False

Q: Identify the device which requires external electrical energy source. a. Thermocouple b.…

A: Option B Thermistor

Q: The temperature measurement capability of thermistors is from 200°C to over 2000°C. Select one: True…

A: We have to determine the temperature measurement capability of thermistors

Q: A RTD made up of platinum has a=0.00385 and has a initial resistance of 400. Find the value of…

A: Given: The coefficient of thermal expansion, α = 0.00385 The initial resistance, Ro = 400

Q: The _____________ between the windings of a transformer is the same. current induced emf voltage…

A: Transformer changes current and the voltage of a circuit but power (P=VI) remains constant. This is…

Q: if the electric circuit consist of one resistance, then the resistance voltage is equal

A: The voltage across resistance will be equal to the Voltage of the battery connected to the circuit.

Q: 43. The exposure at 25 cm from a radioactive source is 16 mR/h. At what distance will the exposure…

A: Initial exposure rate =I1=16mR/h at D1=25cmNow,New Exposure rate=64mR/h=I2Let new distance =D2We…

Q: 4. Three parallel connected resistor when connected across a dc voltage source dissipate a total…

Q: 14 In single degree of freedom systems, a. O, 0. II

A: For a single degree of freedom system , natural frequency is given by ωn = km The increase in mass…

Q: In a given DC motor, the output power is 45 HP, and the copper losses are 2.005 KW. If the…

A: Given data Output Power = 45Hp=45(746)=33,570 W=33.570 KW Copper losses = 2.005 KW Rotational…

Q: (i) Three identical capacitors are connected in delta with 400 V. If the line current is 12 A…

A: (i) Voltage, VL=440VLine current, IL=12A As in delta connection,Phase voltage,Vp=line…

Q: True or false for the following question 1.Thermal conductivity is a measure of how thermal energy…

A: 1.Thermal conductivity is a measure of how thermal energy is transferred through a solid by combined…

Q: Nonmetallic-Sheathed Cable (NM) shall be permitted to be derated from the 90 degrees C temperature…

A: Non metallic sheathed cable shall be permitted to be derived from the 90degrees C temperature rating…

Q: Q22 111 Poor power factor results in: a) Higher energy losses b) Higher load current c) Both a & b…

A: Option ( C ) is correct Both a & b

Q: The support reaction experiment is an example of unlike parallel force system. Select one: True…

A: The reactions at support are parallel to each other but their magnitudes can be equal or unequal…

Q: In three phase power measurement using one watt-meter method, if the load is balanced then the total…

A: yes, in three phase power measurement using one watt wattmeter methodif the load is balanced then…

Q: A beam supported between the walls and its rotation is restrained, is an example of a fixed beam.…

A: if a beam is fixed at both ends, then it is called fixed beam.

Q: 22.9 22.9 VD E

A: A system of parts working together in a machine is known as mechanism. The given figure shows a…

Q: .... Q1/(4): The current that a 2 W, 80 kQ resistor can safely conduct is 25 µA O 40 kA O 160 kA O 5…

A: Given data: The power for the current is P=2 W The resistance of resistor is R=80 kΩ=80×103 Ω

Q: 1. The half-life of a certain radioactive material is 1000 years. What fraction of the original…

Q: The objective of this question is to give the missing information about the reading of thermocouple…

A: Given: J type thermocouple

Q: Choice the correct answer of the following statements: 1. The power transmitted of two pulleys…

A: Solution.jpg

Q: 23. As an additional branch resistor is connected in a parallel circuit, a) total current decreases…

A: As more and more resistors are added in parallel to a circuit, the equivalent resistance of the…

Q: A RTD made up of platinum has a=0.00385 and has a initial resistance of 400. Find the value of…

A: RTD -Resistance temperature detectors it is made up of platinum resistance. Initial resistance,…

Q: Thermal question. Set PL = 50 W. Rth = 2 KW, and the ambient air temperature to 30 *C. What Cy value…

A: Given: PL = 50 W Rth = 2 K/W Ta = 30 C t = 20 s

Q: alagram of a two-component system, determ of degrees of freedom. Melting point of A

A: The number of independent ways a dynamic system can move without violating any constraints imposed…

Q: 33. Increasing the speed at which a magnet moves through a coil of wire causes the induced voltage…

A: Increasing the speed of the relative movement between the coil and the magnet – On the off chance…

Q: The continuity equation is based on the principle of conservation of mass. Select one: True False

A: Conservation of mass: According to this law, mass in an isolated system is neither created nor be…

Q: A 24.6 N resistor found experimentally, in Ohm's law experiments, if its actual value is equal to 24…

A: Option b is correct.

Q: An armature has a resistance of 0.2 Ω at 150°C and the armature Cu loss is to be limited to 600…

A: Given data: Resistance R1 = 0.2 Ω Find :- T1 = 150oC…

Concept explainers

Conduction and Convection

When energy travels from one object to another it is said to have undergone heat transfer. Heat transfer is nothing but the transfer of thermal energy or internal energy from one thing to another, like e.g., when a vessel with water, kept on top of a burner, heats up because of the flame underneath it.

Question

17-

The Electrical resistivity (ρ) of a material is inversely proportional to the length (L) of the material

Select one:

True

False

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

11- For Isotropic materials, the properties are same in all directions. Select one: True False
In last week's assignment, you calculated mean free path, total absorption, and reverberation time for a room that is 4 m long, 7 m wide, and has a ceiling height of 3 m. The floor is hardwood, = .15 at 500 Hz. The walls are gypsum wallboard (GWB), = .30 at 500 Hz. The ceiling is acoustic ceiling tile (ACT), = .95 at 500 Hz. 1) What is the room constant for this room?
You have smooth slabs of Titanium (Ti), polycrystalline silica (SiO2), and atactic PS. Rank them from highest to lowest: Thermal conductivity (k) Heat capacity (Cp) Energy band gap (Eg) Thermal expansion coefficient (a) Transparency Resistivity
Distinguish between conductors and semiconductors under the following headings: temperature, coefficient of resistance and band theory.
Which of the following describes a bucky ball? a. plastic explosives nanoparticle b.. a carbon molecule (C60) c. a quantum dots d. a concrete nanoparticle with a comprehensive strength of 20 nanonewton
24- a) a) Explain the coding system of the material 233H65. Specify the classification of carbon
An armature has a resistance of 0.2 Ω at 150°C and the armature Cu loss is to be limited to 600 wattswith a temperature rise of 55°C. If α0 for Cu is 0.0043/°C, what is the maximum current that can bepassed through the armature ?
The accepted resistivity value at room temperature for copper wire is 1.7421 x 10-8 ohm meter. please explain why or why not the measurements recorded are within some percent error of thius value. calculate resistivity and show the percent error. Use R=p L/A Using the formula calculate p
The Subject is Basic Electrical Engineering Chapter 5. Connection of Resistor Connection of Resistors
Considering only the thermal effect to define emf exposure limit is sufficient debate between considering only the thermal effect to define emf exposure limits is not sufficient, non thermal effect also need to be considered
1. Define briefly what a harmonic load is and write a generic equation for this type of load. Similarly, Define briefly what an impulsive load is and provide one example of this kind of load. Explain in detail.
A is the simplest type of semiconductor.