The figure presented below is a 3- liquid system. The height difference between h₁ and h₂ is 370 millimeters. Neglecting the air density and using specific gravity of water = 1.0 and Mercury = 13.6. The density of alcohol is Blank 1 kilogram per cubic meter. *Express your answers in whole significant figure without decimal value and without unit* *** Water Alcohol h₁ 300 mm 100 mm Blank 1 Add your answer Mercury h₂ 120 mm

The figure presented below is a 3- liquid system. The height difference between h₁ and h₂ is 370 millimeters. Neglecting the air density and using specific gravity of water = 1.0 and Mercury = 13.6. The density of alcohol is Blank 1 kilogram per cubic meter. Express your answers in whole significant figure without decimal value and without unit *** Water Alcohol h₁ 300 mm 100 mm Blank 1 Add your answer Mercury h₂ 120 mm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

If a scuba diver descends too quickly into the sea, the internal pressure on each eardrum remains at atmospheric pressure, while the external pressure increases due to the increased water depth. At sufficient depths, the difference between the external and internal pressures can rupture an eardrum. Eardrums can rupture when the pressure difference is as little as 35 kPa. What is the depth at which this pressure difference could occur? The density of seawater is 1025 kg/m3. 1)sketch (include everything in the system) 2)solution(step by step)
The fuel gage for a gasoline tank in a car reads proportionalto the bottom gage pressure as in Fig. . Ifthe tank is 30 cm deep and accidentally contains 2 cmof water plus gasoline, how many centimeters of airremain at the top when the gage erroneously reads“full”?
A pressurized vessel contains water with some air above it, as shown below. A multi-fluid manometer system is used to determine the pressure at the airwater interface, point F? h1 = 0.24 m, h2 = 0.35 m and h3 = 0.52 m Fluid densities are water: 1000 kg/m3 , oil: 790 kg/m3 and mercury(Hg): 13,600 kg/m3 .
The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as shown. Determine the gage pressure of air in the tank if h1 = 16”, h2 = 24”, and h3 = 30”. Take the densities of water, oil, and mercury to be 1.94, 1.65 and 26.39 slugs/ft^3, respectively
Pressure is often given in terms of a liquid column and is expressed as “pressure head.” Express the standard atmospheric pressure in terms of (a) mercury (SG = 13.6), (b) water (SG = 1.0), and (c) glycerin (SG = 1.26) columns. Explain why we usually use mercury in manometers
QUESTION: For an atmospheric pressure of 101 kPa (abs) determine the heights in meters of the fluid columns in barometers containing one of the following liquids: (a) mercury (SG = 13.55), (b) water, and (c) ethyl alcohol (SG = 0.79). Do these results support the widespread use of mercury for barometers? Why?
A 1.0 m3 object is hovering in water, where the specific weight of water is γw=9.81kN/m3. If the object is put into mercury where the specific gravity of mercury is sgm=13.54, then what is the buoyant force in mercury?_______ A. 9.81kN B. 132.83 kN C. It cannot be decided
The round holes drilled in the sides and decks to illuminate the interior of the ships are called "portholes". If the center of a 30 cm diameter porthole of a ship is 10 m below the water level, how many N is the hydrostatic force acting on this porthole? Take the density of the water as 1000 kg / m3, the gravitational acceleration as 10 m / s2 and the value as 3.
Here, a liquid's density is to be determined by a 1-cm diameter cylindrical hydrometer whose division marks are non visable. The hydrometer is first dropped in water, and the water level is marked. The hydrometer is then dropped into the 'liquid x', and it is observed that the mark for water has risen 0.85 cm above the liquid–air interface. In this case, the height of the originalwater mark is 12.7 cm. As such, how would I determine the density of the liquid?
Consider a large cubic ice block floating in seawater. The specific gravity of seawater 1.05. If a 25-cm-high portion of the ice block extends above the surface of the water, the height of the ice block below the surface is 200 cm. Determine the specific gravity of the cube.
In a water-containing manometer, the differential pressure (ΔP) is read as equal to 1 in 20 atmospheric pressure. Accordingly, how many meters is the water height in the manometer? (ρwater = 997 kg/m³, P0 = 101.3 kPa, g = 9,81 m/s²)
You and Madeline are in an aircraft flying steadily at 4,300m above sea level and you are about to experience your first sky dive with her. You jumped first but Madeline, due to hesitation, jumped after few seconds. Supposed that in an instant, the barometric pressure at your elevation is 85.0 kPa and Madeline is higher from you by 800m. Determine the barometric pressure at Madeline's elevation assuming that pressure and temperature at sea level are 101.3 kPa and 25 deg.C respectively. Use lapse rate = 0.00650 K/m