QuestionThe fluid exiting a chromatographic column is called theeluenteluateanalytesolventQuestion 22The elution power of a solvent is determined byThe polarity of the stationary phaseThe nature of the sample componentsAll of the mentionedIts overall polarity Question 18The relative solubility of solute in both the phases determines theRate of disappearance of soluteRate of movement of soluteRate of movement of solventRate of disappearance of solventQuestion 19In Column chromatography, the stationary phase is made ofmobile phase is made ofSolid, liquidLiquid, liquidO Liquid, gasSolid, gasand the

Chromatography is the laboratory method to separate the components of a mixture. Elution is the…

The fluid exiting a chromatographic column is called the eluent eluate analyte solvent Question 22 The elution power of a solvent is determined by The polarity of the stationary phase The nature of the sample components All of the mentioned Its overall polarity

The fluid exiting a chromatographic column is called the eluent eluate analyte solvent Question 22 The elution power of a solvent is determined by The polarity of the stationary phase The nature of the sample components All of the mentioned Its overall polarity

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A sample is analyzed for chloride using the Volhard method. What is the percentage chloride as NaCl using the following data? Weight of sample: 303.0 mg AgNO3 used: 40.00 mL of 0.1234 M KSCN used: 12.20 mL of 0.0930 M
Calculate the gravimetric factor of the following. 2 Fe3O4 is sought(Analyte), 3 Fe2O3 is weighed (Precipitate) 2 Fe is sought(Analyte), 1Fe2O3 is weighed (Precipitate)
Calculate the mass percent of the ascorbic acid in the same show full solution Situation: The pounded Vitamin C tablet was half into two below are the calculated data in the experiment. Each of the half are transfered in a 250ml erlen meyer flask and added 75ml of deionized water for the vitamin C to dissolve. Then it was prepared for titration where the burette was filled with 0.09794M standardize NaOH solution then a total of with 3 drops 2% phenolphthalein indicator was added to each erlen meyer flask l, swrill it and begin the titration. below are the following data gathered: Vitamins used: Nature Made vitamin C 500mg tablet Trial 1 Mass: 0.3108g of Vitamin C tablet Initial volume: 1.6mL Final volume: 15.4mL Trial 2 Mass: 0.3349g Initial volume: 15.4 mL Final volume: 30.2 mL
PS. Further values required for the solvings are give in the various situations below. (ANSWER) Situation: A community in a mountainous area of Bohol uses water collected from a nearby natural spring. A sample was submitted to a laboratory for the analysis of its total hardness. Required: SHOW YOUR COMPLETE CALCULATIONS. BASED ON THE IMAGE PROVIDED BELOW FOR THIS QUESTION: Calculate the amount of titrant used in each trial to reach endpoint. Report total hardness of the sample as mean ±sd. a. 250.0 mL of 500.0 ppm of CaCO3 solution from a primary standard (assume solvent is distilled water only). Answer : Mass of CaCO3 = 0.125 g b, The EDTA solution was standardized by titrating it with a 25.0 mL aliquot of the CaCO3 solution. How much of the titrant was consumed. Answer: Volume of EDTA consumed = 12.405 g c. Calculate the average titer (mg CaCO3/mL EDTA). Mass of CaCO3 in 25 mL CaCO3 solution: 0.0125 g Answer: 1.008 mg CaCO3/ mL EDTA
In gravimetric analysis, volatile electrolyte is used in peptization step a. to form small nucleib. to easily dry precipitatec. to reprecipitate the analyteexplain please
Why is it less desirable to wash AgCl precipitate with aqueous NaNO3 than with HNO3 solution? (Select all that apply.) A) HNO3 evaporates during drying. B)HNO3 is nonvolatile and will lead to a high mass for the precipitate. C )NNO3 is and will lead to a high mass for the precipitate. D)NaNO3 evaporates during drying.
In chromatography, the compound that is least soluble in the mobile phase a) Travels the furthest away from the line of origin b) Stays closest to the line of origin
Please determine how to make a working standard Solution of about 0.010mg/mL. Caffeine will be the active. Diluent will be water.
Given the following data and the λmax determined in the previous questions, determine:1) the molar absorptivity of copper at λmax of cobalt 2) the molar absorptivity of copper at λmax of copper 3) the molar absorptivity of cobalt at λmax of cobalt 4) the molar absorptivity of copper at λmax of cobalt 5) the concentration of cobalt in mM 6) the concentration of copper in mM Copper concentration, mM λmax cobalt λmax copper 20.00 0.177 0.238 40.00 0.382 0.487 60.00 0.518 0.731 80.00 0.765 1.134 100.00 0.902 1.391 Cobalt concentration, mM λmax cobalt λmax copper 20.00 0.186 0.163 40.00 0.412 0.354 60.00 0.637 0.477 80.00 0.754 0.694 100.00 0.961 0.831 unknown, Abs at λmax cobalt 0.893 unknown, Abs at λmax copper 0.997
If a student used the molar mass of magnesium to calculate the concentration in parts per million (ppm) of a manganese stock standard solution, would the reported weight percent of manganese in a subsequent unknown, that was compared colorimetrically, be higher, lower, or not change?
In thin layer chromatography the initial spot is placed: A. on a pencil lineB. four centimeters from the solventC. anywhereD. Tapping the solvent to dissolve it
Because of the risk of lead poisoning, the exposure of children to lead-based paint is a significant public health concern. Thefirst step in the quantitative analysis of lead in dried paint chips is to dissolve the sample. Corl evaluated several dissolution techniques.24 In this study, samples of paint were collected and pulverized with a Pyrex mortar and pestle. Replicate portions of the powdered paint were then taken foranalysis. Results for an unknown paint sample and for a standard reference material, in which dissolution wasaccomplished by a 4–6-h digestion with HNO3 on a hot plate, are shown in the following table. (a) Determine the overall variance, the variance due to the method, and the variance due to sampling. (b) What percentage of the overall variance is due to sampling? (c) How might the variance due to sampling be decreased?