The following reactions are observed when an olefin is epoxidized with dioxygen: alkene + 0₂ epoxide + 0₂ alkene + 0₂ epoxide CO, + H,O CO2 + H,O Derive the rate expression for this mixed-parallel series-reaction network and the expression for the percent selectivity to the epoxide.

Q: s the chemical reaction correct? N2(g)+3H2(g)+2H2O(l)=2NH3(g)+2H2O(g) if not please make some…

A:

Q: . sider the composite solid shown. Solid A is a ther mally conductive material that is 0.5-cm thick…

A: INTRODUCTION  HEAT TRANSFER THROUGH CONDUCTION -  CONDUCTION IS MODE OF HEAT TRANSFER SPECIALLY IN…

Q: A treatment system treating 1.0 m3 /s of water includes a filter followed by a  chlorine contact…

A: please find answer below

Q: 25: Hot oil at a rate of 1.2 kg/s (Cp = 2083 J/(kg-K)) flows through double pipe heat exchanger. It…

A:

Q: Consider a slab of thickness I. and constant thermal conductivity k in which energy is generated at…

A: Introduction Heat conduction is a system in which heat is transferred from the warmer component to…

Q: 2. Express the following quantities in MLtT and FLtT BTU lbm R kW m².K

A:

Q: A 600-m3 house contains air at 17ºCand 1 atm. If the air pressure remains at 1 atm, how many moles…

A:

Q: 9. Given the reaction 2Al(s) + 3Brag-2AIBrs) what is the increase in the standard enthalpy of…

A: Write the given reaction as follows: 2Als + 3Br2g → 2AlBr3s Two moles of Al reacts with three moles…

Q: A gas containing equal parts methane, ethane and ammonia flows at a constant rate through a…

A: It is given that methane, ethane, and ammonia are in equal parts and flow at a constant rate through…

Q: Find the pressure at point A. Water temp. = 150 F A Kerosene 2 in HARAMARI 5 in 7 in-

A: Given that h1=2 in =0.0508 mh2=5 in =0.127 mh3=7 in =0.1778 m

Q: please write your solutions typing it makes it very confusing

A:

Q: In the concentration of fruit juices, a portion of the feed is redirected to bypass the evaporator…

A:

Q: the pressure of the gas in inches Hg.

A:

Q: 1.31 Refrigerant 22 vapor enters the compressor of a refrigera- tion system at an absolute pressure…

A: Absolute pressure of system = 0.1379 MPa Pressure at exit in gage = 1.93 MPa Atmospheric pressure =…

Q: What is the maximum number of independent balances that may be written around each subsystem?…

A:

Q: Water is flowing inside the pipe shown in the sketch below. A Venturi meter equipped with a…

A: Given thatdp =12 cmdt = 6 cmh =4.5 cm

Q: 1.6 1.2 + 0.8 0.4+ O -0.4 -0.8 -1.2 - -2 Fe3+ 2 1 4 Fe²+ 0 3 Fe(s) 4 Fe₂O3(s) 5 FeOH+ Fe3O4(s)…

A:

Q: You have three CSTRS you can place in series to carry out a liquid phase reaction at constant…

A:

Q: Blue water gas (BWG) is obtained by passing steam over red hot carbon-enriched coal. The gas is…

A:

Q: Calculate the pressure ( in atm) at which the freezing temperature of water is -20°C = 253 K H₂O(s)…

A: Given data: Enthalpy of fusion = 6010 J/mol Initial temperature = 273 K Initial pressure = 1 atm…

Q: why does Xm also decreases with Ym upon an increase in temperature. Please explain

A: The temperature mole fraction phase diagram is obtained at constant pressure. On the x-axis, the…

Q: Which of the following occurs in the reaction Cu²+ + Zn → Cu + Zn²+? Select one: O a. Neither copper…

A: The reaction of copper (Cu) and zinc (Zn) given is as follows: Cu2++Zn → Cu+Zn2+ The above reaction…

Q: 9 evaporators are connected in series, i.e., the concentrated product of the first one is fed to the…

A:

Q: The practical depth limit for a suited diver is about 185 m. What is the gage pressure in sea water…

A: Given that :h = 185 m s.g =1.025

Q: The heart is effectively made up of two pumps that create flow through the human circulatory system…

A: Introduction  A pump is a tool that moves fluids (drinks or gases), or occasionally slurries, via…

Q: Acidic gases, such as CO₂ and H₂S, must be removed from natural gas prior to use. You want to remove…

A: From the image given, the value of (1/H) for CH4 at a temperature of 25oC is found to be equal to…

Q: AH in f298 Estimate ΔΗ. mol for 1,3-Butadiene as a liquid.

A: First write the heat of formation reaction of 1,3 butadiene. And then, Write the combustion…

Q: 2. Consider this item as REAL gases: Two hundred and fifty pounds of a mixture of 6.63.% propane…

A: A mixture of gases is completely vaporized.

Q: Estimate the transition length at the entrance to a 15-mm tube through which 100 percent glycerol at…

A: Given Data

Q: 19. An aqueous solution of ethanol containing 10% by weight ethanol is continuously distilled at a…

A: Given that, The mass flow rate of feed F = 1000 kg/h The weight fraction of ethanol in the feed xe,F…

Q: 3. Sea water is to be desalinized by reverse osmosis (RO) using the process shown in Figure 1. The…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: A fuel containing 80% CH4 and 20% C2H6 is burned with dry air. Sixty percent of the carbon burned…

A: Given 100 moles of Fuel 80 mole % CH4 and 20 % C2H6 so 80 moles of CH4 and 20 moles of C2H6 will be…

Q: Which cement is used to create bond .with old concrete surface Rapid Hardening Cement Expansive…

A: option 1 ) Rapid hardening cement is used in areas like road pavements so that the traffic can be…

Q: Assume that the permeability of oxygen in the alveoli is P=4x10-8 cms-1. The P O2 in alveolar air is…

A:

Q: Using the figure below, the lower plate is being pulled at a relative velocity of 3.14 m/s greater…

A: For a detailed solution, please see the attached files.

Q: Adiabatic Flame Temperature (AFT) is the maximum temperature a flame can reach and is of practical…

A: Basis: 1 mole of Lead blast furnace gas Note: Volume% is equal to mole% for ideal gases The number…

Q: Consider the compound, C₂H4O₂. (5 pts each) Using the framework below, draw two possible Lewis…

A:

Q: Given the analysis of fuel oil: C-86.8% and H-13.1% is burned using 20% excess air. 95% of the…

A:

Q: 4. A soil contains 3,500 ppm of available Ca²+. Use this information to calculate the following: a.…

A:

Q: . A four component mixture (ABCD) has AB with K-values > 10 and CD with K-values <0.1. Under the…

A: Given:

Q: As shown in the figure, an exterior wall of a building has an average thermal conductivity of 0.32…

A:

Q: Problem 2: A metal rod 0.4 m long & 0.04 m in diameter has one end at 373 K & another end at 273 K.…

A: Given Lenght of metal L = 0.4 meter Diameter D = 0.04 meter Thermal conductivity K = 385 J/ m s oC…

Q: pressure increase

A:

Q: Heat-Transfer Area and Use of Log Mean Temperature Difference. A reaction mixture having a Cpm =…

A:

Q: Determine the molar volume of n-butane at 510 K and 25 bar based on each of the following: a. the…

A: Given data: T = 510 K P = 25 bar

Q: What does the concept behind the graph wherein the two points of the line meets at the two end.…

A: Temperature, composition of a binary mixture is given.

Q: A gas mixture containing 3.0 mol H2, 4.0 mol N₂ and 2.0 mol He at 273.15K has a total pressrue of…

A: mole fraction of nitrogen = moles of nitrogen / total moles mole fraction of nitrogen =  (4 mol N2)…

Q: On a clear night, when the effective blackbody temperature of the space is - 30°C, the air contains…

A:

Q: If the density of sea water is approximated by the equation of state p = p. exp[(p − Patm)/B], where…

A: It is given that the density of seawater follows the equation as shown below ρ=ρoexpp-patmβ, where β…

Q: Heat Loss by Convection and Conduction.

A: