The induced emf in a conducting loop is proportional to: O a. The rate of change of the magnetic flux cutting the loop. O b. The magnitude of the magnetic flux cutting the loop. O c. The resistance of the loop. O d. The magnitude of the magnetic field cutting the loop. O e. The rate of change of the magnetic field cutting the loop

The induced emf in a conducting loop is proportional to: O a. The rate of change of the magnetic flux cutting the loop. O b. The magnitude of the magnetic flux cutting the loop. O c. The resistance of the loop. O d. The magnitude of the magnetic field cutting the loop. O e. The rate of change of the magnetic field cutting the loop

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 66AP: A metal bar of length 25 cm is placed perpendicular to a uniform magnetic field of strength 3 T. (a)...

See similar textbooks

Similar questions

A metal bar of mass 500 g slides outward at a constant speed of 1.5 cm/s over two parallel rails separated by a distance of 30 cm which are pail of a U-shaped conductor. There is a uniform magnetic field of magnitude 2 T pointing out of the page over the entire area. The railing and metal bar have an equivalent resistance of 150 . (a) Determine the induced current, both magnitude and direction, (b) Find the direction of tire induced current if the magnetic field is pointing into the page, (c) Find the direction of the induced current if the magnetic field is pointed into the page and the bar moves inwards.
The magnetic field through a circular loop of radius 10.0 cm varies with time as shown below. The field is perpendicular to the loop. Plot the magnitude of the induced emf in the loop as a inaction of time.
(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
A truck is carrying a steel beam of length 15.0 in on a freeway. An accident causes the beam to be dumped off the truck and slide horizontally along the ground at a speed of 25.0 m/s. The velocity of the center of mass of the beam is northward while the length of the beam maintains an east-west orientation. The vertical component of the Earths magnetic field at this location has a magnitude of 35.0 T. What is the magnitude of the induced emf between the ends of the beam?
A 2.00-m length of wire is held in an eastwest direction and moves horizontally to the north with a speed of 0.500 m/s. The Earths magnetic field in this region is of magnitude 50.0 T and is directed northward and 53.0 below the horizontal. (a) Calculate the magnitude of the induced emf between the ends of the wire and (b) determine which end is positive.
A metal bar of length 25 cm is placed perpendicular to a uniform magnetic field of strength 3 T. (a) Determine the induced emf between the ends of the rod when it is not moving, (b) Determine the emf when the rod is moving perpendicular to its Length and magnetic field with a speed of 50 cm/s.
What is the value of the magnetic flux at coil 2 in Figure 23.56 due to coil 1? Figure 23.56 (a) The planes of the two coils are perpendicular. (b) The wire is perpendicular to the plane of the coil.
Ail electron is moving at a speed of 1.0 104 in/s in a circular path of radius 2.0 cm inside a solenoid. The magnetic field of the solenoid is perpendicular to the plane of the electrons path. Find (a) the strength of the magnetic field inside the solenoid and (b) the current in the solenoid if it has 25 turns per centimeter.
(a) An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.00 T field with his fingers pointing in the direction of the field. Find the average emf induced in his wedding ling, given its diameter is 2.20 cm and assuming it takes 0.250 s to move it into the field. (b) Discuss whether this current would significantly change the temperature of the ring.
A rectangular conducting loop is placed near a long wire carrying a current I as shown in Figure OQS1.3. If I decreases in time, what can be said of the current induced in the loop? (a) The direction of the current depends on the size of the loop. (b) The current is clockwise. (c) The current is counterclockwise. (d) The current is zero. (e) Nothing can he said about the current in the loop without more information.
A truck is carrying a steel beam of length 15.0 m on a free-way. An accident causes the beam to be dumped off the truck and slide horizontally along the ground at a speed of 25.0 m/s. The velocity of the center of mass of the beam is north-ward while the length of the beam maintains an east-west orientation. The vertical component of the Earths magnetic field at this location has a magnitude of 35.0 T. What is the magnitude of the induced emf between the ends of the beam?
(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V Hall voltage between its wing lips when in level flight over the north magnetic pole, where the Earth's field strength is 8.00105T ? (b) Explain why very little current flows as a result of this Hall voltage.