The lossless network given below is excited with a microwave source having frequency f=3,2 GHz. For the air transmission line L=3,5 nH/m, C=8,7 pF/m. Find the characteristic im pedance of the transm ission line Zo=? (2) 3λ m ZL Yanıt:

The lossless network given below is excited with a microwave source having frequency f=3,2 GHz. For the air transmission line L=3,5 nH/m, C=8,7 pF/m. Find the characteristic im pedance of the transm ission line Zo=? (2) 3λ m ZL Yanıt:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…

A: Given :Z0 of T.L =50 ohm Standing wave ratio (s)=2.0The distance between succesive voltage minimum…

Q: An air lossless transmission line is operating at frequency of 3 MHz and has a length of 1.75 A,…

A: Given: An air lossless transmission line having Frequency, f=3 MHz Length, L=1.75 λ Characteristics…

Q: The 50 ohm half wavelength lossless transmission line is terminated with a 60 ohm load impedance. If…

Q: The following lossless network excited with the microwave source having f = 9 GHZ. if Zo=74 Q, 6,…

A: For lossless transmission line Characteristic Impedance is Zo Zo =√(L/C) Zo^2 = L/C L =…

Q: A transmission line has the following per-unit-length parameters: L = 0.5 µH/m, C = 200 pF/t R = 4.0…

Q: A lossless transmission line of electrical length € = 0.32 is terminated with a complex load…

A: Given Data: electrical length l = 0.3 labda ZL = 20 - j 30 ohm Zo = 75 ohm

Q: A 30-m-long lossless transmission line with Z, = 50 2 operating at 2 MHz is terminated with a load…

Q: An air lossless transmission line is operating at frequency of 3 MHz and has a length of 1.75 A,…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: Q2: (Using Smith chart): Design lossless L-section matching circuits to match the load impedance of…

Q: 6. A 3000 transmission line is 0.8 m long and terminated with a short circuit. The line is operating…

A: z0= 300 ohm, wavelength =0.8m, length =0.8m

Q: A 100 MIHZ EM broadcast station uses a 300 N transmission line between the transmitter and a…

Q: Consider a load impedance, ZL = 25 + j50 N, terminating a 50 2 line. The line length is 60 cm and…

A: We have given the following problem

Q: O A transmission line operating at f = 1 GHz has Z0 = 100 N , a = 0.05 N„/m, ß = 1.5 rad/m. Find the…

A: Given Data: f = 1 GHz Zo = 100 ohm alpha = 0.05 Np/m beta = 1.5 rad/s

Q: Derive the scattering parameters for each of the following networks by using the parameter def-…

A: In the question, network 1 is mention but it is not shown in the figure. hence we will consider the…

Q: 27. A 50 N transmission line is terminated in a load that results in a reflection coefficient of…

A: given;Z0=50ΩΓL=0.5+j0.5ΓL=0.52+0.52ΓL=0.5ΓL=0.707a;load impedance…

Q: A transmission line has the following per-unit-length parameters: L = 0.5 µH/m, C = 200 pF/m, R =…

A: Given Data: R = 4 ohm L = 0.5 uH C = 200 pF G = 0.02

Q: 1) Transmission line properties of typical high-speed interconnects are experimentally investigated…

A: Given parameters phase constant β=200rad/mattenuation constantα =140NP/mcharacteristic impedance…

Q: An air lossless transmission line is operating at frequency of 4 MHz and has a length of 0.25 ),…

A: As per company guidelines we can solve only first three sub part kindly post the rest questions…

Q: Generate an 80 MHz signal. A signal source is connected to an unknown impedance, z1, by a lossless…

Q: A 100 MHz FM broadcast station uses a 300 2 transmission line between the transmitter and a…

Q: lossless transmission line of length 1= = 502, is terminated in a load impedance gnal wavelength on…

Q: A lossless transmission line is 80 cm in length and operating at a frequency of 140 MHz. The line…

A: Given, Length=80cm=0.8m Frequency=f=140MHz Capacitance=C'=70×0.8=56pF Inductance=L'=0.4×0.8=0.32μH…

Q: Tt=3.14 For a Transmission line, L=6,4 nH/m, R=2,9 0/m, C=1,2 µF/m and G=8,5 S/m (f = 1 GHz). For…

A: According to the question we have to find the value of ZR.

Q: The following characteristics have been measured on a lossy transmission line at 100 MHz: Zo = 50 +…

Q: The lossless network given below is excited with a microwave source having frequency f={frq_q1} GHz.…

A: Reflection coefficient

Q: The following lossless network is powered by f = 8 GHz microwave source. If z, = 48 0\ (\epsilon_r V…

Q: An antenna with a load impedance ZL = (100 + j40)0 is connected to a transmitter Za = Zo through a…

A: we need to find out power delivered to antenna.

Q: The lossless network given below is excited with a microwave source having frequency f=4,8 GHz.…

Q: At 3 GHz, a shorted parallel sideline will be used to match a 60 ohm transmission line to a load…

A: Given,f = 3 GHzZ0 = 60 ΩZL = 30-j60 Ω

Q: Q.For the lossless TL shown in Fig. (1) with length L, let Zo 602, Zg= 202 and ZR= 1202. Use Zig-zag…

Q: A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive…

A: Given that, L = 0.5 uH/ft C = 100 pF/ft ZL= 100-ohm impedance of cable is defined as…

Q: One end of an air lossless transmission line having the characteristic impedance of 75 Q and length…

A: Power generation, transmission, and distribution systems constitute a power system. The power…

Q: Q1: A transmission line has the following per-unit-length parameters: L = 0.5 µH/m, C = 210 pF/m, R…

A: Power System Network: A basic Power system network consists of Generation unit, Transmission unit…

Q: A lossless transmission line of length 50 cm with L = oper ated at 30 MHz. Find phase constant 10…

A: Given: In the given question they have mentioned a lossless transmission line. Lossless…

Q: The lossless network given below is excited with a microwave source having frequency f=7,1 GHz. For…

A: Characteristics impedance of the given lossless network is determined as shown below

Q: The following lossless network excited with the microwave source having f = 8 GHz and (E, =3).…

A: Given f = 8 GHz V =12 V τL =0.17l =2 cm

Q: A 602 lossless transmission line is terminated with an antenna of impedance of (27 + j30) Q. Use the…

Q: A) Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: On a 144 N lossless transmission line, the following observations were noted: distance of first…

A: Given Characteristic impedance is Zo=144Ω, Distance of first voltage minimum to the load is 3cm…

Q: A single-phase antenna transmission line with a length of 40 km and supplying the load with a…

A: Transmission is a long conductor used for carrying very high loads. The initial place of load…

Q: An extra high voltage transmission line of length 300 km can be approximate by a lossless line…

A: Given, An extra high voltage transmission line of length= 300 km Propagation constant, β= 0.00127…

Q: A 30-m-long lossless transmission line with Z, = 50 N operating at 2 MHz is termina with a load Z, =…

A: Reflection coefficients determine how much wave is is reflected at discontinuity of medium.It is…

Q: For problems 15 and 17 A transmission line has the following per unit length parameters. R' = 0 Q/m,…

Q: A 30-m-long lossless transmission line with Z, = 50 N operating at 2 MHz is terminated with a load…

A: Given Lossless transmission line Length l=30 mfrequency f=2 MHzZ0=50 Ωload ZL=60+j40 Ωu=0.6c

Q: The line parameters of a lossless transmission line are L = 0.25 µH/m and C= 100 pF/m. If the…

Q: A load impedance ZL = 25 – j50 N is connected to a 50 Q transmission line. Insert a shunt capacitor…

A: Transmission Line: A transmission line is a specialised cable or other structure used in electrical…

Q: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

A: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

Q: The lossless network given below is excited with a microwave source having frequency f=7,1 GHz. For…

Q: (a) A lossless transmission line with Z, line is terminated with a load impedance, Zį = 100 + j100…

Question

Microwave

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Characteristics impedance

VIEW

Step 2: Solution

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive load. What is the characteristic impedance of the quarter-wavelength line that can be used for impedance matching?
A 300ᘯ transmission line is 0.8 m long and terminated with ashort circuit. The line is operating in air with a wavelength of 0.8m and is lossless. (a) If input voltage is 10V, what is themaximum voltage amplitude at any point on the line? (b) Whatis the current amplitude in the short circuit?
1. What is the necessary condition for matching transmission lines? In addition, what is a micro strip line? 2. For a distortion less line α = 0.02dB/m, Z0 (R0) = 60Ω and C = 0.2nF/m. Find the resistance and velocity of wave propagation. [Do not forget the units.] 3. For a finite lossless transmission line with open-circuit termination, sketch Xio vs l. Indicate where the sketch is inductive and capacitive.
An extra high voltage transmission line of length 300 km can be approximate by a lossless line having propogation constant β= 0.00127 radians per km. Then the percentage ratio of line length to wavelength will be given by ??
A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL.According to what is given, a) RL for Voltage Standing Wave Ratio to be 2What should be the relationship between XL and?b) If RL = 100Ω, find the value of XL.c) Find the voltage minimum point closest to the load on the line.
A lossless coaxial cable transmission line has L = 10 uH/ft and C = 4 nF/ft. If the signal frequency is 1 GHz, what is the length between two successive oscillations of an electromagnetic signal?
The following characteristics have been measured on a lossy transmission line at 100 MHz: Zo = 50 + j0, α = 8 dB/m, and β = 1.5 rad/m. Determine R, L, G, and C for the line. Show the details of your work. Paste your scanned solution to the space provided below.
The following lossless network is powered by a f=9 GHz microwave source. A matching circuit is designed for ZL=91 load and ZS. Since it is known that L=631,30220884613 pH here, what is ZS? π=3.1416
A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100 MHz. At an electrical length of 0.8 wavelengths, what is input admittance?
At 3 GHz, a shorted parallel sideline will be used to match a 60 ohm transmission line to a load impedance of ZL = 30 - j60 ohms. What should be the length of the parallel lateral line, in mm? Calculate using the Smith diagram.
A lossless transmission line is terminated by an open circuit. An incident signal travels from the source to the load gets reflected and travels all the way back to the source. It takes 4 microseconds for the signal to go from the source to the load and then from the load to the source. What is the length of the line (in m) if the propagation velocity is equal to the speed of light (in m/s)? Enter only the numerical value. No need for the unit. Use four decimal places (if the answer is not an integer).
A transmitter delivers 50 W into a 600 Ω lossless line that is terminated with an antenna that has an impedance of 275 Ω, resistive. (a) What is the coefficient of reflection? (b) How much of the power actually reaches the antenna?