The Merck Index gives the following data for the solubility of 1 gram of salicylic acid and 1 gram of aspirin: Aspirin (acetylsalicylic acid) 300 mL of H2O 17 ml of chloroform 12 mL of ethyl ether Salicylic acid 460 mL of H20 42 mL of chloroform 3 mL of ethyl ether If 10 grams of aspirin were dissolved in 3000 ml of water, what weight of aspirin would be removed by a single extraction with 3000 ml of ethyl ether? If 10 grams of salicylic acid were dissolved in 4600 ml of water, what weight of salicylic acid would be extracted by two sequential extractions with 2300 ml of chlorofprm for each extraction?

The Merck Index gives the following data for the solubility of 1 gram of salicylic acid and 1 gram of aspirin: Aspirin (acetylsalicylic acid) 300 mL of H2O 17 ml of chloroform 12 mL of ethyl ether Salicylic acid 460 mL of H20 42 mL of chloroform 3 mL of ethyl ether If 10 grams of aspirin were dissolved in 3000 ml of water, what weight of aspirin would be removed by a single extraction with 3000 ml of ethyl ether? If 10 grams of salicylic acid were dissolved in 4600 ml of water, what weight of salicylic acid would be extracted by two sequential extractions with 2300 ml of chlorofprm for each extraction?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Following titration analysis, a sample of a fruit juice was found to contain 8.9 mg cm-3 ascorbic acid. Given that the Mr value for ascorbic acid is 176.1 Da, calculate the value of the ascorbic acid concentration expressed in units of mmols dm-3 then enter it
What is the molar absorptivity and concentration of caffeic acid? Molar mass= 180g/mol the cuvette= 1cm absorbance= 1.98 Started by adding 0.0019g of caffeic acid in 25 mL methanol. This solution was diluted with methanol in 1:100mL, then again in 1:10 dilution.
A commercial vinegar was analyzed by titration to determine the percent acetic acid. Briefly, 10.00 mL of vinegar sample was diluted to 100. mL solution in a volumetric flask. A 25.00 mL aliquot from the diluted vinegar required 25.55 mL of 0.1005 M sodium hydroxide to reach the phenolphthalein endpoint From this experiment which is the standard solution used in titration? CH3COOH NaOH NaCH3COO C20H14O4
I have a 1.2864g sample of maleic acid which was dissolved in enough water to make 100.0 mL of a solution. Then 10.0 mL of the solution was titrated to a phenolphthalein endpoint with 29.39 mL of an unknown sodium hydroxide solution. What is the molarity of the sodium hydroxide solution?
0.750 g of crude acetylsalicylic acid is recrystallized using ethanol as the solvent. The solubility of acetylsalicylic acid in ethanol at 78 oC is 15.45 g per 100 mL. a) How much hot ethanol is needed to dissolve the 0.750 g of acetylsalicylic acid? b) If the solubility of acetylsalicylic acid at 25 oC is 0.100 g per 100 mL, how much acetylsalicylic acid will be obtained after crystallization in ethanol at 25 oC? Use the volume from part A. c) What is the maximum percent recovery for this re-crystallization
IDENTIFY IF THE GIVEN STATEMENTS ARE TRUE OR FALSE In the assay of sodium bicarbonate, three moles of the titrant react to 2 moles of the analyte. One milliliter of 1N sulfuric acid is equivalent to 84.01 grams or 1 mEq of sodium bicarbonate. A weak acid when titrated with a weak alkali will give a sharp endpoint. When a weak acid is titrated with a strong alkali, methyl red is used as an indicator. To have a balanced equation in the assay of sodium bicarbonate, the titrant should have a coefficient of one and the sulfate salt of sodium produced should have a coefficient of three. The standard acid solutions used in acidimetry and alkalimetry are usually prepared from HCl or H2SO4. When a weak alkali is titrated with strong acid, the indicator used is methyl red.4 Sodium bicarbonate is considered as the primary standard in its own assay. When a strong alkali is titrated with a strong acid, phenolphthalein may…
Calculate the equivalence factor (F) of the KF reagent if a 180 mg sample of sodium tartrate dehydrate required 15 ml of KF
The aqueous solubility of AgOCN at 20°C is 7.00 mg/100mL. What is the Ksp of AgOCN at 20°C?
The molar solubility of MgCO3 (Ksp = 3.50 x 10-8) in distilled water at room temperature is ______ M. Titration of a 50.00-mL aliquot of the saturated solution will require ______mL of 0.005000 M HCl to reach the phenolphthalein endpoint.
Normality is same as Molarity for sodium hydroxide and normal = molar (for NaOH) Normality of sodium hydroxide = 0.10395N (normal) or Molarity of NaOH = 0.10395M (molar) Volume of NaOH consumed during the titration = 21.87 mL Mol wt of Naproxen = 230.26 g/mol Weight of Naproxen ds (i.e., sample) = 0.534g Calculate the % Purity (dried-basis) of Naproxen ds, given that the LOD results for Naproxen = 1.0% a 97.0 b 98.0 c 98.5 d 99.0 e 99.5 f none of the other answers.
I'm trying to find the wt% of an unknown sample of KHP. I titrated a 1.4024 g of the unknown KHP dissolved in 50mL of water with 0.1327 M NaOH and the endpoint was at 13.02 mL of NaOH.
Calculate the percent moisture in aminosalicylic acid if 9 ml of KF reagent is having a water equivalence factor of 4.10 was consumed by a 510 mg sample