The Mohr's circle representing a given state of stress is shown. The diagonal line AB represents the original orientation where point A corresponds to the x face and point B corresponds to the y face. a) Show the stresses represented by line AB on the provided stress element. 60 X A -30-1/ 140 σ (MPa) 40 1 y B B T(MPa) 50 √20p 30 40

The Mohr's circle representing a given state of stress is shown. The diagonal line AB represents the original orientation where point A corresponds to the x face and point B corresponds to the y face. a) Show the stresses represented by line AB on the provided stress element. 60 X A -30-1/ 140 σ (MPa) 40 1 y B B T(MPa) 50 √20p 30 40

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The state of stress at a point in a member is shown on the rectangular stress element where the magnitudes of the stresses are |σx|=137 MPa and |τxy|=70 MPa. Determine the state of stress on an element rotated 85∘ clockwise from the element shown.
The reference state of stress shown in the element sketch below results in the Mohr’s circle plot indicated. For this element, as described below, determine:a)The principal stresses.b)The principal directions (angles to the principal planes).c)The maximum in-plane shear stress.d)Is the maximum in-plane shear stress the absolute maximum shear stress?
Mohr's Circle The major and minor principal stresses acting at a point are 80 psi compression and 20 psi tension. (a) Draw the Mohr's circle for this stress combination. (b) What is the maximum shear stress acting at the point, and what value of normal stress acts on the plane? (c) Determine the value of the shear and normal stress acting on a plane that is 30° from the major principal plane. kindly answer the following with a complete solution so that i can understand how to solve it. thank you
Draw Mohr’s circle that describes each of the following states of stress.
The principal stresses at a point across two mutually perpendicular planes are 70 MN/m2 tension and 50 MN/m2 tension respectively. The shear stress across these planes is 30 MN/m? (Counter clockwise). Determine the magnitude of the normal, tangential, the resultant stress, and inclination of resultant stress on a plane inclined at 30° to the plane of greater principal stress. And also verify the answer by drawing the Mohr's circle.
USE the mohr's circle method to determine the stress components acting on the inclined plane AB USE THE MOHR'S CIRCLE METHODE NOT THE ONE IN THE QUESTION
Determine the magnitude of the maximum shear stress on the stress element for which σx=-87 MPa, σy=36 MPa and τxy=-17 MPa. Give your answer in MPa to the nearest whole number.
Determine the average normal stress at points A, B, and C. The diameter of each segment is indicated in the figure.
Calculate the stress perpendicular to the inclined plane AB. Report your answer as a positive number.Answer: σn= Enter your answer in accordance to the question statement ksi.
Determine the average normal stress developed at points A, B, and C. The diameter ofeach segment is indicated in the Figure below.
Determine the maximum normal stress (in Mpa) in bar ABCD if the cross-sectional area of the bar is A = 556 mm2 and P= 36.79 kN. Round off the final answer to four decimal places.
The cross-section of bar ABCD is made of a triangle with sides equal to 15 mm, 12 mm, and 10 mm. Determine the maximum normal stress in the bar. Express o in MPa and round off your answer in 2 decimal places. Please answer this one