The molar mass of a liquid is determined by the Dumas Method. How is the calculated molar mass of the liquid affected, too high, too low or unaffected, if the student did not heat the volatile liquid at a constant temperature for 5 minutes?

The molar mass of a liquid is determined by the Dumas Method. How is the calculated molar mass of the liquid affected, too high, too low or unaffected, if the student did not heat the volatile liquid at a constant temperature for 5 minutes?

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter1: Matter And Measurements

Section: Chapter Questions

Problem 16QAP: Computers are not supposed to be in very warm rooms. The highest temperature tolerated for maximum...

See similar textbooks

Related questions

Q: Derive the reduced expression for the compressibility factor z of a real gas

A: Solution the sponginess issue Z is outlined because the quantitative relation of the degree occupied…

Q: Mass of unchewed gum - 9.1 g mass of chewed gum - 3.6 g mass of sugar - 5.5 g percent of sugar…

A: From given mass of dissolved sucrose to moles- 0.02 moles 1 mole of any species contains Na number…

Q: 1. A gas is undergoing an isothermal process the pressure ratio of the final to the initial state is…

A: Given: The ratio of final pressure to initial pressure (P2/P1) = 2.5 Initial volume (V1) = 2 ft3…

Q: Virial equation can be written in Z (compressibility factor form): Z = pV/RT = 1 + B'p + C'p2 +…

A: Virial equation was proposed by Kamerlingh-onnes.This is the equation of state for real gases in…

Q: III-Defined the thermodynamic temperature scale (with absolute zero temperature) for non-ideal gas…

A: Solution -

Q: Mass of unchewed gum - 9.1 g mass of chewed gum - 3.6 g mass of sugar - 5.5 g percent of sugar…

A: Interpretation: The mass of the dissolved sucrose is to be converted to moles. Given: Mass of…

Q: 21. A mountain is 4500 M high. Assuming Paust- 2700 kg/m' and pmante - 3300 kg/m what is the depth…

Q: 1. A natural gas mixture whose volumetric analysis is 85.8% CH4 (Methane), 13.2% C2H6 (Ethane), 0.9%…

A: Given- The molar masses of CH4 , N2, CO2, and C2H4 are 16 .0 , 28.0, 44.0, and 28 kg/kmol,…

Q: 1. Derive an expression representing the heat transfer from a fluid flowing in a pipe.

Q: Why is it necessary to measure the temperature of water when using it to calibrate a volumetric…

A: As the volume is temperature dependent so it is necessary to measure the temperature of water when…

Q: Show complete solutions and enclose all final answers in a box. Round off final answers to 4 decimal…

A: Answer: let's assume that both the gases are acting like an ideal gas. Therefore on mixing their…

Q: The fifth derivative of which of the following provides the result 0? x*6 + 3 O x*4 - 3x x*6-3 O…

A: Formula used : d/dx = nX(n-1)

Q: 9. A ggs expands in volume from 53.8mL to 92.7mL ata constant tempera ture. Calulate the workdone…

A: Gas is expanding so here work done is=-P(V2-V1) Given, V2= 92.7 ml V1= 53.8 ml

Q: Calculate the density of air at atmospheric pressure at sea level and at 15°C, and at a pressure of…

Q: A cylinder measuring 8.4 cm wide and 10. cm high is filled with gas and the piston pushed down with…

A: We know that, Force = Pressure x area Given, Wide = diameter = 8.4 cm = 0.084 m Area = πr2 =…

Q: 2) In the Ramsay-Shields equation, the units for the ambient temperature T and critical temperature…

A: The ramsay-shields equation can be given as :- (Md)23 γ = k ( tc -t-6) Where M =molecular weight…

Q: 1.1 Unit conversion. (a) Convert 10 lbm • ft/s² to units of lbf and dynes. (b) Convert 20 kPa to…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: The temperature of a constant amount of an ideal gas in a closed system at a fixed pressure, p₁, was…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: For a pure substance, I. Mass II. Inertial property III. Density Which ones of the above properties…

A: There are intensive and extensive properties of substance . The intensive properties are independent…

Q: Properties of a system could be measurable or non-measurable.

Q: Using the calculated experimental average density of the liquid samples as reference, what is the…

A: Density = (Mass ÷ Volume)

Q: Sea water for cooling enters a condenser at 25C and leaves at 40C. The condenser temperature is 45C,…

A: Since it is a condenser, only phase change occurs. Tout = 45 0C - 40 0C = 5 0C Tin = 45 0C - 25 0C =…

Q: What is the relationship between turtuosity and diffusion?

A: A question based on diffusion, which is to be accomplished.

Q: Component Weight Fraction 0.65 C2 0.15 C3 n-C4 n-C5 0.10 0.06 0.04 Calculate: a. Mole fraction of…

A: SOLUTION:Step 1: Hello. Since the question contains multiple subparts, the first three subparts are…

Q: Zr metal transforms to Zro, when heated in air to 1100 degrees Celsius. If one conducts a tensile…

A: a is the correct answer 100 MPa

Q: Mass of unchewed gum - 9.1 g mass of chewed gum - 3.6 g mass of sugar - 5.5 g percent of sugar…

A: The number of moles of substance = mass of the substance (m) ÷ Molar mass of that substance (M).

Q: A cylinder measuring 2.0 cm wide and 2.4 cm high is filled with gas and the piston pushed down with…

A: pressure = (force ÷ Area ) Force = pressure × Area

Q: There is a strong force of attraction betwee False Collisions do not occur when particles are in the…

A: Intermolecular forces refer to the type of interactions which are present in between atoms or…

Q: Sugar Cane Solution Evaporation. Evaporator is used to thicken sugar cane solution. The feed rate is…

A: Sugar solution produced before evaporation process (M1) = 10000 Kg Concentration of solid sugar in…

Q: What is the physical significance of the compressibility factor Z?

A: Gases have no proper shape and volume. They are of low density.

Q: = -11°C and v = 14 km/h, at what rate is windchill changing as air-temperature increases? (Round…

A: We have to find dW/dT and dW/dv

Q: A cylinder measuring 3.4 cm wide and 4.1 cm high is filled with gas and the piston pushed down with…

Q: 6. Using the previously recorded and calculated values, determine the molar mass of the gas for…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: A cylinder measuring 2.1 cm wide and 2.5 cm high is filled with gas and the piston pushed down with…

Q: Determine the compressibility factor for an air system that exists under - 100 °C and 75 bar,…

A: Given temperature =-100oC = 173.15 K pressure = 75 bar Critical temperature of the air, TC =-1400 C…

Q: 3 Why is it wrong to calculate (and report) a value for the quality of a compressed liquid or…

A: A superheated liquid is a liquid that has a temperature higher than its boiling point. A compressed…

Q: Vhat measuring devices can be used to be accurate if you are trying to measure 86.2m hoose all that…

A: According to the question, we need to determine which measuring devices can be used to be accurate…

Q: What could be the assumption when the MW of the sample does not match calculated molecualr weight…

A: Vapour pressure depression, boiling point elevation,freezing point depression are the example of…

Q: if a volumetric pipet delivers 24.844 g of deionized water at 31.00 celsius what is the calibrated…

A: Given : Mass of deionized water = 24.844 g Temperature = 31.00 celsius

Q: When the tire temperature is 30 degrees Celsius, the gage pressure reading on a vehicle tire is 240…

A: Given: Initial temperature = 30 oC Initial pressure = 240 KPa. And final temperature = 65 oC

Q: The molar mass of a liquid is determined by the Dumas method. How is the calculated molar mass of…

A: Introduction : Dumas method is used for molar mass detection .

Q: A gas is under pressure of pressure 20.855 bar gage, T= 104 Fahrenheit and unit weight is 362 N/m3.…

A: Given that , P= 20.855 bar T = 104 oF Unit weight = 362 N/m3

Q: Please explain exactly how to plot and solve. TYIA Pressure trial 1: 0.0759938 density trial 1:…

A: A substance in gas phase can be defined based on four variables. These variables are used to…

Q: Give an example of an isolated system.

A: Thermodynamic is the branch of chemistry that mainly deals with the heat transfer between system and…

Q: Two train cars with the same mass (30,000 kg) are traveling in the same direction when they collide.…

A: Given that, Mass of train car A, mA = mass of train car B, mB= 30000 Kg Velocity of train car A =…

Q: Why should you heat the sample to constant mass?

A: Heating the sample to a constant mass plays an important role in the gravimetric technique. It…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Quality Assurance and Calibration Methods

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The molar mass of a liquid is determined by the Dumas method. How is the calculated molar mass of the liquid affected - too high, unaffected or too low, if the student assumed the volume of the flask was 150ml ( as marked on the side of the flask) rather than measuring the volume experimentally ?
Computers are not supposed to be in very warm rooms. The highest temperature tolerated for maximum performance is 308 K. Express this temperature in C and F.
3.00mL of a hydrogen peroxide solution is used in this experiment and 42.25mL of oxygen gas is trapped in the apparatus. The air temperature is 22.0oC. What is the mass% of H2O2 in the solution?
Two train cars with the same mass (30,000 kg) are traveling in the same direction when they collide. Train Car A has a velocity of 10 m/s and Train Car B has a velocity of 5 m/s. What is their total momentum after the collision? Make sure to show all your work and include proper units.
if a volumetric pipet delivers 24.844 g of deionized water at 31.00 celsius what is the calibrated volume of the pipet?
Mass of unchewed gum - 9.1 g mass of chewed gum - 3.6 g mass of sugar - 5.5 g percent of sugar in gum - 60.4% Molar mass of sugar - 342.34 g/mol mass of dissolved sucrose to moles- 0.02 moles convert the moles of sucrose to molecules of sucrose. Show work using dimensional analysis and report the answer with correct units and sig figs.
if a volumetric pipet delivers 24.844g of deionized water at 31.00 degrees C, what is the calibrated volume of the pipet?
Virial equation can be written in Z (compressibility factor form): Z = pV/RT = 1 + B'p + C'p2 + D'p3 + ... Z = 1 + (B/V) + (C/V2) + (D/V3) + ... Show that C'=(C-B2)/(RT)2 on each Z (compressibility factor form) above.
H4. A zinc pot (coefficient of linear expansion : ) is filled with mercury at 100 °C, then having a 10.0 L capacity. Cools down to 0°C. Calculate the mass of mercury, measured at °C, that must be added so that the vessel is completely full (coefficient of volumetric expansion of mercury: ). Density of mercury at 0 °C; 13.6g/cm3.
Show complete solutions and enclose all final answers in a box. Round off final answers to 4 decimal places and use floating values for intermediate answers. A gas column is separated into two segments by a non-permeable partition. On the first segment is 1.63 moles of Helium with volume V1 and on the second segment is 3.84 moles of Oxygen gas with volume V2. Consider both gases to be ideal and at the same pressure P and temperature T. If the partition is removed, calculate the change in entropy of the gaseous system.
Mass of unchewed gum - 9.1 g mass of chewed gum - 3.6 g mass of sugar - 5.5 g percent of sugar in gum - 60.4% Molar mass of sugar - 342.34 g/mol question? to convert the mass of dissolved sucrose to moles. Show work using dimensional analysis and report the answer with current units and sig. figs
Mass of unchewed gum - 9.1 g mass of chewed gum - 3.6 g mass of sugar - 5.5 g percent of sugar in gum - 60.4% Molar mass of sugar - 342.34 g/molconvert the mass of the dissolved sucrose to moles. Show work using the dimensional analysis and report the answer with correct units and sig. figs