The room described in problem 8 is remodeled. One-inch polystyrenesheathing has been added to the outside wall. The ceiling now has 91⁄2 inchesof insulation. The windows are double pane. What is the new heat load for thisroom?

The room described in problem 8 is remodeled. One-inch polystyrenesheathing has been added to the outside wall. The ceiling now has 91⁄2 inchesof insulation. The windows are double pane. What is the new heat load for thisroom?

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 44P

See similar textbooks

Related questions

Q: À commercial building is built on a slab on grade foundation that is a 40 m by 18 m rectangular…

A: Given, Slab length L=40 m B=18 m Temperature (t)= -15° C

Q: Q- To complement the construction Q- What is the correct Sentence of a wall or to connect a wall to…

A: Thermal insulation- It means the process of resistance against the transmission of heat. Thermal…

Q: Find the heat load for an upstairs 14-foot by 12-foot bedroom that is not onthe corner of the house.…

A: Consider a bedroom with dimensions 14 ft by 12 ft, and the outside wall has two single-pane windows…

Q: Given inside and outside design temperature, 5°C, 23°C, respectively. The temperature of an unheated…

A: Given: The inside design temperature is 5oC. The outside design temperature is 23oC.

Q: A 5-m-wide 3-m-high wall is constructed of one layer of common brick (k= 0.72 W/mK) of thickness 20…

Q: General requirements for helicopter air conditioning (SAE)

A: A standard to which helicopter air conditioning systems designed for the civil aircraft industry.…

Q: A concrete wall has a thermal resistance of 0.095 K/W. There is a glass window in the concrete wall…

A: Given Wall thermal resistance = 0.095K/W Glass thermal resistance = 0.046K/W Total thermal…

Q: You are an engineer, in which area of the roof would you install a solar panel?

A: Solar panels are generally installed on the roof. The service life of the solar panels is 20-25…

Q: Help your customer to calculate the heat losses through a composite wall that includes an 8-mm-thick…

A: Since, the Question to be solved is not specified, the Solution for Question no.01 is as follows:…

Q: With the help of sketches, propose the ideal ventilation method (either naturally, mechanically, or…

A: Introduction There are different control frameworks that can be used, both in normal everyday…

Q: How does a reheat warm-air distribution system differ from a variable air volume system?

A: Reheat system is the system in which air is preheated at the central unit and then distributed in…

Q: What is meant by a ground-loop heat pump?

A: Ground-loop heat pump A mishap apparatus is that the apparatus used at places where groundwater…

Q: Q.3: Building requires to maintain different temperature settings. What are most common cooling…

A: Building cooling systems are in high demand in tropical countries. Especially where the high…

Q: A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The…

Q: Air at 25 ° C blows over the hot steel plate whose surface temperature is maintained at 150 ° C. The…

Q: Define absolute humidity.

A: The absolute humidity is defined as the density of water vapour in wet air.

Q: What purpose do thermostatic traps on each radiator of a steam heating system serve?

A: Watts Thermostatic Radiator steam traps

Q: How far away from the wall is the end of the heater pictured below?

A: From figure, identify the heater dimension is 351516 inches. Find the distance between the end of…

Q: A well-insulated residential wall has a Uvalue of 0.05 and an R-value of 20 (in U.S. units). Compare…

A: Solution; Worst performing window and glazing with single glazing has an R-value of 0.9. The losses…

Q: Discuss the role of glass that faces each of the principal directions of the compass in adding solar…

A: Solar gain is the increase in thermal energy of a space, object, or structure as it absorbs incident…

Q: If the room in problem 16 faced the sun, an additional cooling load would becreated. This extra…

A: Consider a corner room as shown The dimension of the floor and ceiling are 11 ft. 4 in by 10 ft. 8…

Q: Explain the process of Reduced air preheat?

A: Solution: Air preheater is the any device that is designed to heat air before any other process for…

Q: What are the three basic directions of heat flow from warm-air furances?

Q: Discuss the following green system used in engineering: 1. Radiant floors 2. Gray water recycling 3.…

A: Here are the main example of Green Building System Engineering

Q: This damper is in the chimney flue of an oil burner. Through how manydegrees is it turned from its…

A: Consider the angle To calculate the above angle use a protector Align the 0 angle along 1 leg with…

Q: The Good Eating restaurant is adding suspended outdoor radiant heating to its25 feet 60 feet patio…

A: Solution Consider the figure shown below

Q: Building requires to maintain different temperature settings. What are most common cooling system…

A: Focal cooling frameworks are the most energy-proficient approach to cooling a few city blocks…

Q: What is a comfortable relative humdity for indoor air

A: Humidity is measure of level of moisture vapor suspended in the air or amount of vapor present in…

Q: Discuss the three positions in which thermal insulation may be installed in a low-slope roof, and…

A: Solution: Low slope roofs are basically flat with the value of slope less than 17 percent. It is…

Q: This rectangular duct is to be wrapped with insulation. How many inches ofinsulation are needed to…

A: The duct is rectangular with width as 16 in and height as 8 in. Consider the insulation material has…

Q: What is the advantage of a four-pipe system for hydronic heating and cooling?

A: HVAC is the Heating, Ventilating, and Air Conditioning (HVAC) method for conditioning the indoor…

Q: What is the heat load of the top floor?

A: heat load is termed for building in several manners, the heating load acting on top of roof or top…

Q: Below what humidity for 95°F air will we not have to worry about sweating asthe air flows past 72°F…

A: Given:- air T=95oF=350C air flows at Dew temp Tdew=720F=22.230C To find:- humidity

Q: This room needs 19 feet of electric baseboard heaters. Lengths of 6 feet and7 feet are already…

A: Schematic figure of the given problem:

Q: A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…

A: To Find :- error in the area of the rectangular lot measured.

Q: Based on the materials of the course, building loads for which an HVAC system must compensale…

A: 1. There are various types of loads to be considered for HVAC system on buildings HVAC - Heat…

Q: A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The…

A: For any material, it's insulation capacity is defined by thermal resistance value which can be…

Q: Q5: Imagine that you do not want the CO2 concentration to exceed 766 ppm. What is the minimum…

A: Cin=Cout+GNKQ Cin= 766 ppm Cout= 400 ppm G= 0.005 N= 4 people K=1000000

Q: Compute the cooling load for the south windows on a middle floor of an office building that has no…

A: Given :

Q: b.) calculate the outside air flow for the restaurant dining area where cold air is supplied from…

A: Given data, Area of dining space = 175 m2 Ceiling height = 3 m

Q: An apartment building has 8 apartments in it. Each apartment has 7 ductopenings that need diffusers.…

A: The aim is to determine the total number of diffusers required for the apartment.

Q: Which statement is TRUE about displaceme ventilation in UFAD systems? air from the floor is prone to…

A: In UFAD, mixing is enhanced resulting in even air temperature.

Q: Q1/ The west wall in a building in Baghdad (32°N) has a window of the dimensions (1.0 m x 2.0 m).…

A: Outer design temperature=34o C Indore design temperature=24oC Heat absorption coefficient=(U)=4.6…

Q: At 1:00PM, a thermometer reading 70°F is taken outside where the air temperature is –10°F (ten below…

A: Given: The initial temperature is 70oF. The outside temperature is -10oF. The temperature at 1:02 pm…

Question

The room described in problem 8 is remodeled. One-inch polystyrene
sheathing has been added to the outside wall. The ceiling now has 91⁄2 inches
of insulation. The windows are double pane. What is the new heat load for this
room?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the heat load for an upstairs 14-foot by 12-foot bedroom that is not onthe corner of the house. The outside wall, the 14-foot wall, has 31⁄2 inches ofinsulation. The walls are 8 feet high, and there are two single pane windowsin that outside wall that are 4 feet 5 inches high by 3 feet wide. The ceilinghas insulation 6 inches thick. The house has a design temperature differenceof 70°F.
A warehouse measures 40 feet by 50 feet and has 20-foot-high walls. Thewarehouse was built on a concrete slab and has 6 inches of insulation inthe wood frame walls and 91⁄2 inches in the ceiling. There are no windowsin the building, and the door is made just like the walls. What is the heat loadfor this warehouse in an area where there is a 75°F design temperaturedifference?
Calculate the total cooling load for a building at 32° North latitude at time 14 on 21 of August, outdoor design temperature 35 °C, daily range DR = 11.1 deg ⁰C and indoor design temperature 25.5°C. The building has the following data: A-The ceiling is constructed from 152.4 mm lightweight concrete (I.W concrete) and without a suspended ceiling, dark colour (k = 1) and no mechanical ventilation (f = 1) . Area= 25 m². B-South window consists of 3 mm one layer without internal shading, area=4 m², U = 4.5 W/m2 °C. Assume shading coefficient SC = 1 and cooling load temperature difference CLTD=7 °C and cooling load factor CLF=0.55. C- West wall is constructed from 101.6 mm heavyweight concrete wall+finish (H.W. concrete wall+Finish) (group E) and medium colour (k = 0.83) Area= 17.5 m². D-There is another window that has one hinge that causes an infiltration rate of 5 L/(s.m) of infiltrated air. The moving window has a height of 1.5 m and a width of 1 m. E- Four occupants in the…
This room needs 19 feet of electric baseboard heaters. Lengths of 6 feet and7 feet are already placed. What length of baseboard heater still must beplaced?
A restaurant wants to change the design of a dining room. One of its solidwalls is being replaced with a fixed double pane glass wall. The designtemperature difference is 70°F. The wall measures 9 feet high and 20 feet 6inches long. It was a brick wall with 31⁄2 inches of insulation. What will be theadditional heat load for the ventilation system during the winter due to thiswall?
What are the three basic directions of heat flow from warm-air furances?
Discuss the three positions in which thermal insulation may be installed in a low-slope roof, and the advantages and disadvantages of each.
Define fan efficiency.
Given inside and outside design temperature, 5°C, 23°C, respectively. The temperature of an unheated adjacent room can be estimated as: Select one: a. 18˚C b. 9˚C c. 14˚C
The Good Eating restaurant is adding suspended outdoor radiant heating to its25 feet 60 feet patio to increase dining space. The duct is to run diagonallyfrom one corner of the patio to the other. It starts and ends 18 inches from eachcorner. The burner takes up 4 feet of the length. What is the length of theremaining heater duct?
Answer ONLY items 5-8. Room dimensions are: LxWxH = 8.50 m, 5.0 m, 3m. Originally, the room had linoleum flooring with an absorption coefficient of 0.03. Two opposite walls were cladded with unglazed bricks with an absorption coefficient of 0.02, the one having the entrance gypsum door (2.1 m X 0.80 m) with 0.05 abs.co.; the other two were just bare concrete with sliding glass window openings of 1.80m x 1.20 m each; the bare concrete with an abs.co. Of 0.31 and the window glass with 0.18, the ceiling, too , had bare concrete as its finish at 500 Hz. The client would like to renovate the space into an acoustical studio room and would like to change the ceiling and the flooring. The ceiling will have a vinyl faced fiberglass panel with an abs.co. of 0.71, and the floor will have mineral fiber tiles with an abs.co. Of 0.66, all at 500 Hz.
What is the heat load of the top floor?