The simplest diode performs the same basic function as a __________. Select one: a. Clamper b. half-wave rectifier c. None of the above d. Bridge rectifier e. Full-wave rectifier 2. When the diode in a half-wave rectifier points toward the load, the output from the rectifier will be: Select one: a. Negative b. Positive c. None of the above d. Full-wave e. Either positive or negative, depending on the polarity of the transformer secondary voltage 3. What is true about the resistor? Select one: a. It allows the flow of DC current and blocks AC current. b. It reduces the current and voltage within the circuit. c. It is an active component d. It amplifies signal.

The simplest diode performs the same basic function as a __________. Select one: a. Clamper b. half-wave rectifier c. None of the above d. Bridge rectifier e. Full-wave rectifier 2. When the diode in a half-wave rectifier points toward the load, the output from the rectifier will be: Select one: a. Negative b. Positive c. None of the above d. Full-wave e. Either positive or negative, depending on the polarity of the transformer secondary voltage 3. What is true about the resistor? Select one: a. It allows the flow of DC current and blocks AC current. b. It reduces the current and voltage within the circuit. c. It is an active component d. It amplifies signal.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: Moving charges create electric field. Which of the following is true regarding this concept? a.…

A: Given A multiple choice question based on electric and magnetic field.

Q: 1.The system consumes 150KW, 208V line to line at 0.8 lagging power factor from parallel generator…

A: Given The system consumes 150KW, 208V line to line at 0.8 lagging power factor from parallel…

Q: 1) Consider the adjacent electrical circuit: R₁-1022, R₂-422, R3-102, R₁-2002, R, 892 and R=3092.…

Q: Example12/ Open write T-L with L=30 m, ZR = Zo = 502, f=50 MHZ Find Z, and Za d = 10 m Use the…

A: Given : For the given open write transmission line with characteristic impedance and load impedance…

Q: Question 1 A series RLC circuit has a 20 non-reactive resistor, a coil of inductance 0.1 H with…

A: Brief description: For the given RLC circuit we need to calculate impedance and total current in the…

Q: Q2: find Vout for the following OP-AMP circuit: 100 ΚΩ 10 ΚΩ 3. A 6. 8 ΚΩ 4 ΚΩ 7. Vout

Q: calculate all the voltages and currents for each resistor.

Q: Q2 C only thank you

A: Given: Consider transmission of a digitalized voltage signal. The analog signal before…

Q: 2.A DC series generator is supplying a current of 8 A to a series lighting system through a feeder…

A: Given A DC series generator and it's parameters.we need to find the power developed in the armature…

Q: V₁ from 720 चेक

A: Brief description: For the given two port network we need to calculate it's impedance parameters.

Q: integrated circuit families (RTL, DTL, TTL, CMOS) 4. Let vx = vy = 0.1V (Logic 0), B = 25 Determine…

Q: .11 In the circuit of Fig. 2.75, calculate V₁ and V₂. 1V 2 V + + + + 5 V 1 V₂

Q: Your employer has asked you to fix a heating device which is not working as effectively as it…

Q: Consider a closed-loop control with the following loop transfer function: 1 L(s) = Ge(s)G(s) = s(4s…

A: First go through the prerequisites provided. Angle of (ABC)=Angle(A)+Angle(B)+Angle(C)…

Q: Example14/ λλ 3λ Sketch |Ed and Id| for d=0, '8'4 Zg=Zo www Zo S.C Use the following laws and the…

Q: Consider a closed-loop control with the following loop transfer function: 1 L(s) = Ge(s)G(s) = s(4s…

A: The Given close loop Transfer function is Ls=GcsGs=1s4s+16s+1 The Phase angle of Ljω=-180°

Q: 100 W at 60 V from a 2 percent. Specify the Design a buck-boost converter to supply a load of 30 V…

A: Given data, The output power is100 W. The value of the output ripple factor is 2%.

Q: Q2: (a) Design an operational-amplifier circuit that will produce an output equal to -(4v₁ + V₂ +…

A: The solution is provided in the following section.

Q: :) A (4-bit) binary counter is connected with DAC to generate a Saw tooth Signal with Frequency of…

A: Given data : Number of bit n=4 Saw tooth signal frequency = 10kHz

Q: Question 1 Consider using a pair of strain gauges attached on a beam to measure tensile stress that…

A: Consider using a pair of strain gauges attached on a beam to measure tensile stress that the beam is…

Q: R www + C 24 i(t) HE Vo

A: In frequency domain Capacitor impedance is given by Zc= 1/cs ohms Where as for resistor Zr = R…

Q: Find the Error Sensitivity/TF for the following block diagram in both an open loop and closed loop…

A: Given diagram :

Q: Example13/ Find |Ed| at d=0, λλ 3λ λ 5λ 6λ σλ '8'4' 8 8 8 8 KR=1L 0° Draw standing wave pattern…

Q: Practice Problem 14.14 192 2 H 1 F 192 A third-order Butterworth filter normalized to w = 1 rad/s is…

A: Given : ωc = 1 rad/sf'c= 10 kHzc' = 15 nf

Q: By applying the two golden rules of ideal operational amplifier circuits and the superposition…

A: The Given circuit is It is Ideal op-amp; The Voltage gain V0=R2R1V2-V1

Q: Q3: For a 94.5 wt% Fe-5.5 wt% C at a temperature 1 100 °C, determine the following: a) The Number…

A: At carbon 5.5%, Fe=94.5% at 1100°C from Fe-c diagram a. We have 2 phases 1. lede burite(Eutectic…

Q: Example13/ Find |Ed| at d=0, λλ 3λ λ 5λ 6λ σλ '8'4' 8 8 8 8 KR=1L 0° Draw standing wave pattern…

Q: B-Give one example for the followings: 1- direct method of measurement. 2- indirect method of…

A: We are authorized to answer only three question at a time since you have not mentioned which…

Q: Find the Norton equivalent circuit of the circuit in the figure. 8 Ω ww 2 A (4) Α 5Ω + 4G 12 V ww 8…

A: We need to find out the norton equivalent circuit for given circuit

Q: Express the impedances in Fig. 15.120 in both polar and rec- tangular forms. www R=6.801 (a) L=12 H…

A: We need to find out the impedance of given elements

Q: Which of the following integrals correctly solve for the magnetic flux passing through the surface…

Q: Multiple Choice Questions What is true when designing a digital LDO. (a) The clock-driven switching…

A: Digital LDO:- In digital LDO's output voltage is stable with and load variations. It drives low…

Q: Exampl Sketch | Edl and led for x 32 7 T 8 ZzzZ Zo KR2-1 •S-C

Q: Example12/ Open write T-L with L=30 m, ZR = Zo = 502, f=50 MHZ Find Z, and Za d = 10 m Use the…

A: We need to find out the impedance on transmission line

Q: what is the amp of the given question

A: The current rating (ampere) of the given question is provided in the following section.

Q: ruction: Show complete solution. Use at least two decimal places. Express your answer in ineering…

Q: Given the general vector field H = 10 sinΦ aθ in spherical coordinates, find the magnitude of J at…

Q: Example13/ Find |Ed| at d=0, λλ 3λ λ 5λ 6λ σλ '8'4' 8 8 8 8 KR=1L 0° Draw standing wave pattern…

Q: 6. A periodic voltage has the following voltages: 15 V at 0.02 sec, 9 V at another 0.05 sec and 0 V…

Q: Differentiate Photoconductive cells and Silicon Solar Cells

Q: Design an operational-amplifier circuit using the diffe

Q: the given circuit, find the voltage and current for the load resistor, RL, using Thevenin's Find…

A: Thevenin's theorem states that any network containing linear and bidirectional elements and…

Q: V, in the circuit

Q: 4ax + Say - zaz dimensions 3 cm by 6 cm lying on y = 5 in the +y-direction. O 56.55 mWb; O 45 kWb; O…

A: We need to find out the flux Passing through the given surface

Q: 2. Given the four instantaneous current e =-15 cos (346t-2), ez= 12.5 sin (346t+ 3/4), es-10 sin…

A: To convert a cosine wave representation into a sine wave representation the following expression is…

Q: The ammeter shown in Figure reads 5.00 A. Find 11, 12, and e . 15.0V 7.00 Ω + ww 5.00 Ω Μ www 2.00 Ω…

A: current and volatage calculated by using nodal analysis

Q: The load in each phase of a delta connected network is equal to 82∠54 Ohms. The network is connected…

Q: The computation for the magnetic force due to a current carrying conductor requires the following…

A: We know Force on a current carrying conductor in the magnetic field is given by F= I.l×B Where B:…

Q: 3. Determine the efficiency of a 1500 kVA, 2300 V, 3-phase, Y- connected alternator, which operates…

A: Given that Rating of alternator = 1500 kVA Voltage V =2300 V 3-ϕ star connected…

Q: A series circuit containing a resistance of 20-ohms, an inductance of 0.10 Henry, and a 100 microF…

A: In this question, We need to determine the true power P? Power P= I2 R We know XL = wL Xc= 1/wC…

Question

1. The simplest diode performs the same basic function as a __________.

Select one:

a. Clamper

b. half-wave rectifier

c. None of the above

d. Bridge rectifier

e. Full-wave rectifier

When the diode in a half-wave rectifier points toward the load, the output from the rectifier will be:

Select one:

a. Negative

b. Positive

c. None of the above

d. Full-wave

e. Either positive or negative, depending on the polarity of the transformer secondary voltage

3. What is true about the resistor?

Select one:

a. It allows the flow of DC current and blocks AC current.

b. It reduces the current and voltage within the circuit.

c. It is an active component

d. It amplifies signal.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
What is the purpose of a rectifier circuit? Describe the operation of a half-wave rectifier and a full-wave rectifier using diodes. Draw network and input-output voltages of both cases.
1. Draw and briefly explain the ideal characteristics of PN-junction diode ? 2. Explain briefly about avalanche and Zener breakdown ? 3. In which region can Zener diode be used as a regulator? Why? 4. What is the ripple factor? For a good filter, should the ripple factor be high or low? 5. What is a rectifier? What is the difference between a full-wave rectifier and a half-wave rectifier?
The half-wave rectiﬁer as shown is operating at a frequency of 60Hz, and the rms value of the transformer output voltage vI is 12.6V±10%. What are the nominal and worst case values of the dc output voltage VO if the diode voltage drop is 1V?
A 24-V secondary of a transformer is connected to a half-wave rectifier and a 50 ohms load device. Calculate the DC output voltage Calculate the average current Which rectifier diode would be adequate for this application?
Half wave rectifier and full wave rectifier circuit, what is the relationship between the input voltage waveformand resistor voltage waveform if the diode is shorted? Does the input voltage waveform and resistor voltage waveform has the same peak value when the diode is present? Explain why.
1N4001, 1N4002, 1N4003, 1N4004, 1N4005, 1N4006 and 1N4007 For any of the diodes, describe with the aid of diagrams/illustrations its applications in an AC to DC Bridge rectifier power supply circuit. For your circuit show and describe how you are going to smooth out the ripple voltage that will be present.
Question 1: a) Draw the circuit diagram and explain the working of Half Wave Rectifier (HWR). b) With the help of a neat circuit diagram, explain the working principle of a Centre tapped Full Wave Rectifier. Also, Draw the expected output voltage wave forms with/without using a capacitor parallel with the load. Show the factors affecting voltage ripples and how to eliminate these ripples as much as possible.
What are the applications of zener diode? What is zener effect?
Explain the operation of both signal- and three-phase rectifier circuit by making reference to the sketched waveform.
Define the main difference between a rectifier diode and a Zener diode? What is their difference in circuit applications?
Bridge-type full-wave rectification with two-diode full-wave rectification using a mid-end transformer.Compare the rectifier circuit and list its advantages and disadvantages relative to each other.