The soil profile was consists of 4 m sand at the top and 5 m clay at the bottom. The specific gravity of sand and clay is 2.65 and 2.67 respectively and the void ratio of sand and and clay is 0.61 and 0.48 respectively. The water table is located at the interface of sand and clay. Determine the following: a. Effective stress at the bottom of sand layer. b. Effective stress at the bottom of soil strata. c. the depth of water table from the ground so that the effective stress at the bottom of clay layer becomes 104 kPa.....

The soil profile was consists of 4 m sand at the top and 5 m clay at the bottom. The specific gravity of sand and clay is 2.65 and 2.67 respectively and the void ratio of sand and and clay is 0.61 and 0.48 respectively. The water table is located at the interface of sand and clay. Determine the following: a. Effective stress at the bottom of sand layer. b. Effective stress at the bottom of soil strata. c. the depth of water table from the ground so that the effective stress at the bottom of clay layer becomes 104 kPa.....

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter9: Consolidation

Section: Chapter Questions

Problem 9.15P

See similar textbooks

Similar questions

A soil profile is shown in Figure Q3(b)(i). The groundwater level is located on the ground surface. The sand layer is under artesian pressure where the excess pore water pressure is 40 kN/m^2. (i) Calculate the total vertical stress, pore water pressure and effective vertical stress at the base of each layer. (ii)Determine the increment of the effective stress at the base of sand layer if the 1.5m height fill will be imposed on the ground surface. Note that, the density of the fill material is 1750 kg/m^3. (iii) The excavation will be made in the clay layer for the basement construction. Evaluate the stability of the soil from boiling or quick condition. The depth of the excavation is shown in Figure Q3(b)(ii). (iv)Propose the maximum depth of cut that can be made to avoid boiling or quick condition.
A soil profile consists of a sand layer underlain by a clay layer, as shown. If the degree of saturation of the sand above water table was 50%. Saturated and dry unit weight of sand are 21.2 kN/m^3 and 18.22 kN/m^3 respectively. The saturated unit weight of clay is 18 kN/m3. Determine the total stress, pore pressure and effective stress at point A,B,C.
A soil profile consists of two layers of soil with clay layer underlying the sand layer. The sand layer has a unit weight of 20 kN/m^3 having a thickness of 4 m. and the unit weight of the 2.5m layer of clay is 18 kN/m^3. Compression index of the clay is 0.22 with a void ratio of 1.30. Compute the effective stress (kPa) at the mid height of clay. Calculate the final settlement of the clay layer (mm) due to an increase of pressure of 30 kPa at the mid-height of the clay. Calculate the settlement (mm) when the water table rises to the ground surface.
A uniform soil deposit has a dry unit weight of 15.6 kN/m³ and a saturated unit weight of 17.2 kN/m³. The groundwater table is at a distance of 4 m below the ground surface. Point A is at a depth of 6 m below the ground surface. If the water table rises by 3.5 m, determine the change in effective stress at A. Indicate if it is maintained, increased or decreased.
A soil exists in an area where the ground surface is level and the groundwater table is 3 m below the surface. The saturated unit weight for the soil is 22 kN/m3, and the wet weight for the soil above the water table is 18 kN/m3. The lateral pressure is 0.5 times the vertical pressure. The vertical and lateral pressures represent principal stresses. Determine the value for the major and minor principal stresses at a depth of 10 m (determine values for both the total stress and effective stress condition), and the maximum shear stress that develops because of the effective principal stresses.
Determine the effective stress in kPa at a depth of 16 m below the ground level for the following conditions: Water table is 3 m below ground level ; G = 2.68; e = 0.72;average water content of the soil above water table is 8% a.127.5 b.301.6 c.429.1 d.174.1
The water table in soil deposit is 2 m below the ground surface. The soil above the water table has dry unit weight of 14.85 kN/m^3. The saturated unit weight of the soil is 20.58 kN/m^3. Determine the total vertical stress, in kPa, at a point 4.8 m below the ground. Determine the total pore water pressure, in kPa, at a point 4.8 m below the ground. Determine the The effective vertical stress, in kPa, at a point 4.8 m below the ground.
Determine the total stress of the dry sand with the dry unit weight, yd is 16.5 kN/m3 at the depth of 6 m.
Calculate the effective stress at point A for the following soil profile:
6. From the given soil profile, the groundwater table is located 2m below the ground level. (See picture below) Compute the horizontal effective stress at point A. (Answer: 53.36 kPa) Compute the lateral effective stress at point A if the lateral earth pressure coefficient at rest is K0=0.50. (Answer: 26.68 kPa) Compute the lateral total stress at point A. (Answer: 56.11 m)
The soil profile consists of 5m sand underlain by 13 m layer of clay. The ground water table is at a depth 2.8 m below the surface. The sand has a unit weight of 19 kN per cu. Meter above the ground water table and the saturated unit weight below was 20 kN per cu. meter. The saturated unit weight of the clay is 15.7 kN per cu. meter. At a depth of 11 m determine the following:a. Total stressb. Pore water pressurec. Effective stress.....
A soil profile consists of; layer 1, 10m sand layer and layer 2, 3m clay layer. The ground water table is located 4m below ground surface. For sand, γdry=2.00 T/m2 (tons/m2), γsat=2.25 T/m2, and for clay layer, LL=46%, water content=42% and Gs=2.76. A uniform vertical stress, ΔP=20T/m2 is applied at the ground surface. Determine, a) Effective unit weight of clay, b) overburden pressure at the mid point of the clay layer, c) primary consolidation settlement