The surface area of an unclothed person is 1.5m ^2 and thier skin tempature is 33 degree celcius. This ideal person is located in a room with a tempature of 65 dregrees F. and has an emissivity of e=0.95 suppose the room has dimensions 4mx9mx18m a) suppose you and your closest 10 friends come into this room and heat it up. suppose your clothes are in equilibium with your skin and have the same tempature and emissivity. Further suppose that your net power into the room remains constant . How long does it take before the room to get to hot say 95 degrees

The surface area of an unclothed person is 1.5m ^2 and thier skin tempature is 33 degree celcius. This ideal person is located in a room with a tempature of 65 dregrees F. and has an emissivity of e=0.95 suppose the room has dimensions 4mx9mx18m a) suppose you and your closest 10 friends come into this room and heat it up. suppose your clothes are in equilibium with your skin and have the same tempature and emissivity. Further suppose that your net power into the room remains constant . How long does it take before the room to get to hot say 95 degrees

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.68P

See similar textbooks

Similar questions

Consider a flat plate or a plane wall with a thickness L and a long cylinder of radius r0. Both of these are made of materials such that they can be treated as lumped capacitances (Bi0.1). Show that in each case, the characteristic length lc, defined lc=(V/As), can be approximated as (L/2) and (ro/2), respectively.
1.26 Repeat Problem 1.25 but assume that the surface of the storage vessel has an absorbance (equal to the emittance) of 0.1. Then determine the rate of evaporation of the liquid oxygen in kilograms per second and pounds per hour, assuming that convection can be neglected. The heat of vaporization of oxygen at –183°C is .
Find the minimum amount of diameter for the insulation of a spherical water tank? Radius of the tank is 10 m, thermal conductivity is 25 W/(m^2*K) and convective coefficient is 5 W/(m*K)
H4. Solar flux = 900 [w/m^2] h_air from glass cover = 25 [w/m^2-k] Emissivity_glass = 0.88 (nearly opaque to low frequency radiation Transmissivity of glass = 0.95 Alpha to incoming radiaiton = 0.9 T_ambient = 17 C Gap between plates = 25mm Bottom plate is insulated. Hr = radiation heat Hc = convective heat might need to use view factor FIND TEMPERATURE OF TOP SURFACE (the top is the glass) If anything is needed let me know i will try my best to update the question
Consider a long horizontal pipe with a diameter of 90 mm and emissivity of 0.8 transfers steam at 227°C. Outside of the pipe is air at 27°C and the surroundings of the pipe are also at 27°C. You may assume the temperature of the pipe wall is the same as the temperature of the steam. 1. Find the heat loss per unit length (W/m) for the pipe when the air outside is still. 2. Find the heat loss per unit length (W/m) for the pipe when the wind outside is 8 m/s and blows perpendicularly across the pipe.
The solar power striking Earth every day averages 168watts per square meter. The highest ever recorded electricalpower usage in New York City was 13,200 MW. A recordestablished in July of 2013. Considering that present technologyfor solar energy conversion is about 10% efficient,from how many square meters of land must sunlight becollected in order to provide this peak power? (For comparison,the total area of New York City is 830 km2.)
Sipho’s mother is making a fire in the stove inside a shack using coal. A fan is used to extract the flue gasfrom the fire via a chimney made of zinc material. The wall thickness of Chimney is L=4mm and the walltemperature of the chimney on the flue gas side is T_si=60˚C. Sipho, playing outside next to the chimneyexperiences an ambient temperature of 20˚C. The surrounding temperature is T_sur=35˚C and the emissivityis ε=0.95. Assume the convection coefficient is 20W/m2K and the chimney is grey material.Under these conditions determine the outer surface (air side) temperature T_so=? of the chimney.
Calculate the capillary effect in mm in a glass tube of 2mm diameter, when immersed in (1)water, (2)mercury. The temperature of the liquid is 25ᵒC and the values of surface tensions of water and mercury at 25⁰C in contact with air is 0.0765 and 0.57N/m respectively. The angle of contact for water is 0ᵒ and 130ᵒ for mercury . Take the density of water 1000 kg/m3 , specific gravity of mercury is 13.6. The capillary effect of water in mm is equal to=_________ The capillary effect of mercury in mm is equal to= ___________
a band moves at a speed V and is in contact with a surface of an oil tank with viscosity m. calculate the power in watts required if the belt is moving at 2.9 m / s over SAW 30W oil at 20 C with L = 2m, b = 60m, Nu = 329.0mm ^ 2 / s, rho = 0.9g / cm ^ 2 and h=3cm
Solve for interface temperatures. Given: heat transfer due to radiation= 507.415 W/m2
A small sphere (emissivity =0.503 radius=r1) is located at the center of a spherical abestos shell ( thickness =1.74 cm, outer radius= r2; thermal conductivity of abestos is 0.090 J/ (sm c degrees) The thickness of the shell is small compared to the inner and outer radii of the shell. The temperature of the small sphere is 695 degrees Celsius while the temperature of the inner surface of the shell is 352 degrees Celsius, both temperatures remaining constant. Assuming that r2/r1 =8.75 and ignoring any air inside the shell, find the temperature in degrees Celsius of the outer surface of the shell.
Calculate the resistive force acting on the disk, with the error level not less than h^4, according to the pressure distribution on a circular disk of 0.5 m diameter held against the air flow, given in the table below.