The uniform 50-kg sphere has radius r = 0.2 m and is welded to the center of the uniform 30-kg shaft as shown. When a constant couple moment M is applied to the shaft, its angular velocity reaches 74 rad/s after 4 s. Determine the magnitude of the moment M.

The uniform 50-kg sphere has radius r = 0.2 m and is welded to the center of the uniform 30-kg shaft as shown. When a constant couple moment M is applied to the shaft, its angular velocity reaches 74 rad/s after 4 s. Determine the magnitude of the moment M.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The uniform 16.1-lb slender bar is hinged about a horizontal axis through O and released from rest…

Q: The 8-kg crank OA, with mass center at G and radius of gyration about O of 0.22 m, is connected to…

A: To find (a) The magnitude of torque M (b) The angular velocity of OA (ωoa) Given The mass of crank…

Q: The dump truck carries 5 m³ of dirt with a density of 1600 kg /m³, and the elevating mechanism…

A: Data given - Volume of dump truck = 5 m3 Density = 1600 kg /m3 Mass m = density × volume =…

Q: The 1.8-kg uniform bar rotates in the vertical plane about the pin at O. When the bar is in the…

Q: 7. A uniform rod AB of length l and mass m is supported at O. If the cable attached at B suddenly…

Q: The 23-kg wheel has a radius of gyration about its center O of kO = 300 mm. When it is subjected to…

Q: Q1/ A compressor has three inline pistons of mass 40x10 mg, with a crank radius of 0.04 m and ratio…

A: This is a radial engine. Radial engines are multi cylinder in which cranks are places at 120o . This…

Q: 6/40 If the frictional moment at the pivot O is 2 N m, de- termine the angular acceleration of the…

A: Drum mass = 8 kg Radius of gyration = 225 mm Moment = 2 N.m

Q: If rod OA of negligible mass is subjected to the ouple moment M = 9 N•m, determine the angular…

Q: The mass of the A gear is 10 kg and the turning radius is 200 mm. Of gear B its mass is 3kg and the…

Q: The circular disk of 270-mm radius has a mass of 36 kg with centroidal radius of gyration k = 235 mm…

A: Given data: R=270 mmm=36 kgk=235 mmr=105 mmT=50 Nθ=29°μs=0.08μk=0.07 Need to determine the angular…

Q: The wheel has mass m 6.2 kg and a centroidal radius of gyration 685 mm and rolls without slipping up…

A: Show the free body diagram of the system.

Q: Question #1. The 5 kg paper roll has a radius of gyration about its centre of k= 90 mm. The…

Q: R17–5. At the instant shown, two forces act on the 30-lb slender rod which is pinned at O. Determine…

A: Given mass of the rod, m =30 lb. Also, given that a horizontal reaction of 5 lb acts at the pin 'O'…

Q: Four stroke engine has two outer cranks set at 140° to each other, and their reciprocating masses…

Q: (20 pts) A concrete block is lifted by a hoisting mechanism in which the cables are securely wrapped…

Q: A homogeneous 150-kg vertical bar AB is raised from rest at θ = 0° by means of the parallel swinging…

A: Given , Mass of the bar AB , m = 150 Kg Moment applied , M = 5 KNm Motion starts at zero angle

Q: Determine the equivalent of the system using the angular motion of the bar 2c k L 4 4 4 4 Slender…

Q: The 31-kg reel is mounted on the 16-kg cart. Part A: If the cable wrapped around the inner hub of…

Q: The 136-kg spool has a radius of gyration about its mass center of ke = 300 mm If the couple moment…

Q: The uniform slender rod, with a mass of 9.6 kg and a length of e=0.76 m, is fixed to a light…

A: Given DataM=11.8Nmm=9.6kgl=0.76m

Q: A force of P = 20 N is applied to the cable, which causes the 175-kg reel to turn since it is…

A: Given P = 20 N Reel mass = 175 kg kG = 0.42 m To find Angular velocity of reel

Q: A force of P = 60 N is applied to the cable, which causes the 200-kg reel to turn since it is…

A: Draw the free-body diagram of the reel.

Q: The concrete block weighing 644 lb is elevated by the hoisting mech- anism shown, where the cables…

Q: Determine the equivalent of the system using the angular motion of the bar 2c k L L 4 4 4 Slender…

A: Given data: Spring stiffness=k Need to determine the equation for the given system.

Q: The 18 kg wheel has a radius of gyration about its center O of ko = 300 mm When the wheel is…

Q: Rod AB of the mechanism rotates clockwise with a constant angular velocity of 20 rad/s. Determine…

A: From velocity diagramVDE=VBA=8m/sωDE=VDEDE=80.8=10 rad/sωBD=VBDBD=0BD=0 rad/sNow Mass of link…

Q: The slender L-shaped bar ABCD mass 15 kg/m is free to rotate about the pin at B. The spring…

A: Write the given data with suitable variables. m=15 kg/mLs=7 mk=180 N/m

Q: A homogeneous disk of mass m = 4 kg rotates at the constant rate w1 = 12 rad/s with respect to arm…

A: The Angular momentum of a rotating disk is equal to the product of the mass moment of inertia of…

Q: The wheel is made from a 5-kg thin ring and two 2-kg slender rods. If the torsional spring attached…

A: Given Mass of the thin ring = 5 kg Mass of slender rod = 2 kg Stiffness = 2 Nm/rad Torque = 25 Nm To…

Q: The wheel is made from a 5-kg thin ring and two 2-kg slender rods. If the torsional spring attached…

Q: the speed of the loader in t = 10 s starting from rest. The wheels roll without slipping

Q: The uniform 2-kg slender bar AB is mounted on a vertical shaft at C. A constant couple of 9 N-m is…

A: GivenA uniform slender barm=2kghorizontal couple=4N-m ( acc to diag)angular velocityω=6rad/slength…

Q: The speed of the pickup truck’s engine is controlled by the Porter governor with 4 arms of equal…

A: Given: Porter governer with 4 equal arms. The mass of the ball is, m=4 kg. The mass of the central…

Q: The 15 kg pendulum shown has its mass center at G and a radius of gyration about its mass center of…

A: Given data The 15 kg pendulum shown has its mass center at G and a radius of gyration about its mass…

Q: The 5 kg thin disk shown rotates with a constant angular velocity about the shaft CD such that w1=5…

A: Consider the free body diagram of the system,

Q: The uniform 31-lb bar with attached 14-lb wheels is released from rest when 8= 70°. If the wheels…

A: W=31 lbWw=14 lbθ=70°θ'=48°k=8.3 in

Q: The 30 kg pendulum has its mass center at G and a radius: of gyration about point G of kG = 320 mm ,…

Q: The 5-kg disk and hub A have a radius of gyration of 85 mm about the zo-axis and spin at the rate p…

A: Consider the Free Body Diagram:

Concept explainers

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.

Question

The uniform 50-kg sphere has radius r = 0.2 m and is
welded to the center of the uniform 30-kg shaft as
shown. When a constant couple moment M is applied
to the shaft, its angular velocity reaches 74 rad/s after
4 s. Determine the magnitude of the moment M.
Write your answer in N.m but do not write the units.
M
R= 0.1 m
Taylor e m
Te am
Answer:
Answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solution

VIEW

Page 2

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

6/40 If the frictional moment at the pivot O is 2 N+m, de- termine the angular acceleration of the grooved drum, which has a mass of 8 kg and a radius of gyra- tion kg = 225 mm. 200 mm kg 12kg
The bar AB is uniform and has a mass of 50.0 kg. At the moment shown, the rod has an angular velocity of 4.00 rad/s and spring is stretched by 0.30 m. The force constant of the spring is 25.0 N/m.a) Determine whether or not the bar will reach the horizontal position.b) If the bar becomes horizontal, calculate its angular velocity at that position. If not, calculate the angle the bar makes with the horizontal when it comes to rest momentarily.
Determine the required magnitude of the torque moments M1, M2 and M3; so that the resulting torque momentum is MR = (300i + 450j - 600k) N • m.
The racing vehicle has a mass of 750 kg and center of mass in G. If there is no slippage, determinate the normal reaction, in Newtons, presented on each of the front wheels in A, when an acceleration of a = 6.4 m/s².
The spool has a mass of 200 kg and a radius of gyration of kG = 0.2 m. If the coefficients of static and kinetic friction at A are μs = 0.3 and μk = 0.2, respectively, determine the angularacceleration of the spool if P = 400 N.
A man pushes the lawn mower at a steady speed with aforce P that is parallel to the incline. The mass of themower with attached grass bag is 50 kg with mass centerat G. If  = 15°, determine the normal forces NB and NCunder each pair of wheels B and C. Neglect friction. (useg = 9.81 m/s2)
At the top A of the vehicle moving along line AC in the figureIts speed is 30 m / sec and its weight is 9 kN.Tool radius of curvature 40The reaction force to the tires when reaching point B, which is m,and so that the tires do not separate from the asphalt when it reaches point CWhat should be the radius of curvature of point C? (hA = 6 m andhC = 9 m)
The body and bucket of a skid steer loader has a weight of 2000 lb, and its center of gravity is located at G. Each of the four wheels has a weight of 100 lb and a radius of gyration about its center of gravity of 1ft. If the engine supplies a torque of M = 100 lb ft to each of the rear drive wheels, determine the speed of the loader in t = 10 s starting from rest. The wheels roll without slipping
The sports car, having a mass of 1700 kg, travels horizontally along a 20° banked track which is circular and has a radius of curvature of p = 100 m. Determine the normal force of the car in Newton.
The homogeneous bars have a mass as follows: bar AC has a mass of 7 kg, bar ABhas a mass of 10 kg, and rod BD has a mass of 2 kg. In the drawn position, therod AC has an angular velocity of 4 rad/s and an angular acceleration of 2 rad/s2, both clockwise.Determine the magnitude of the moment M acting on the member AC. Give all the equations neededto solve this question without calculating it
The homogeneous cylinder A has a mass of 80 kg, and the mss of the hub can be neglected. The magnitude of the variable force P, is in newtons when t is in sec- onds. The velocity of body B changes from 2 m/s downward when t = 0 to 4 m/s downward t = 5 s. Determine the mass of B. Solve all questions using Impulse and Momentum methods
Determine the gyroscopic couple, if the ship travels at 2 km/min and steer to the right in a curve of 65 m radius.The turbine rotor of a ship has a mass of 10tonnes and a radius of gyration 1.5 m. It rotates at 38r.p.s. anticlockwise, when looking from the stern and write the reactive gyroscopic effect.