There are three conducting wires connected to a junction. The currents flowing into the junction in two wires are i1 = 10sin 314t A and i2 = 15sin (314t - 45°) A. What is the current leaving the junction in the third wire?

Q: The if the input to a Differentiator op-amp is a DC signal then the magnitude of the output will…

A:

Q: For the signal x(t), plot the following time transformations. (NOTE: The signals are zero except as…

A: 4) The signal xt is given as Here by doing the time transformation, we need to obtain the…

Q: Design a Half adder, Full adder, Half Subtractor and Full Subtractor.

A: The adder and subtractor circuit can be designed by using truth table and the Boolean expression can…

Q: . Consider the impulse response function h[n] and input signal x[n]given as; 0 for n 5 x[n] = u[n] −…

A: We need to find out output sequence for input sequence .

Q: Three resistors 10, 15, and 20 ohms are connected in Y-configuration to a balanced 208 V 3-phase…

A:

Q: 3C Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A:

Q: ME. 1. A rectangular surface with dimensions 0.6x0.9 meters is oriented with its normal unit vector…

A:

Q: Consider the circuit of Figure 21-6: RG = 50 + 16 sin wt 0.044 μF FIGURE 21-6 a. Find the resonant…

A:

Q: Q3: A 2 MVA three-phase, 33/6.6 kV, delta/star transformer has a primary resistance of per phase and…

A: Given data,   The value of primary resistance  = 8Ω The value of  secondary resistance =…

Q: (la, x lay) x 2a₂= Select one: O a. 2ay O b. 2az О с. 0 O d. 2ax

A:

Q: Consider an LTI system with frequency response 1- e-j2w H(ejw) HET. 1 + ½e-j4w¹ Determine the output…

A: LTI system is a linear time invariant system. It is a memory less and static system output is time…

Q: Q2/Find ((90)10/(36)8)* (F1)16+(11ΟΟ111)2=( )Gray 1000101100 110100111 O 1010100111 O None of them…

A:

Q: Industrial Motor Controls 8.a. A typical motor speed control circuit that is controlled by an…

A: As per guidelines given to us we can only provide the solution of first question in multiple type of…

Q: Q8/F(A,B,C,D)= [m(0,2,5,8,10,13)+d(1,7,12,15) G(A,B,C,D)= [m(6,7,11,12)+[d(0,2,3,8,13,15) Chose the…

A:

Q: 3 phase 24 pole yy connected ac generator has a stator with 72 slots each slots contain 10 conductor…

A:

Q: A three-phase, 60-Hz. 765-kV transmission line has an inductance of 1.0071 mH/Km per phase and a…

A: Given  Inductance and capacitance of a three phase transmission line.we need to determine the…

Q: The solenoid as shown in the figure below has 200 turns, the current is (10A), length of 4 cm and…

A: Given Data, Number of turns(N)=200 Current (I) =10A Length (l)=4cm or 4×10-2m Radius (a)=1.2cm or…

Q: The most usual form of op-amp package

A:

Q: Q2) In the circuit of Fig.2, Z₁-60 /-30° 2, and Z₂=40 /45°. Calculate the total; a) apparent power,…

A: Given circuit is solve as first calculte equivalent impedance or admitance  then calculate total…

Q: Co 1(t) Lo 1(t) L L C C ~Vin(t) jºjº (2) Vin(t) R R 3R 3R Circuit A Circuit B Let us consider 2…

A: "According to the Company's policy, we will solve only for the first circuit". Given the circuit, as…

Q: Q2) Determine the branch currents in the network bellow using Kirchhoff's voltage law. inn im 10 www

A:

Q: By using a mass scale, five reading were taken to measure a mass of Kg as follows: (50.8, 50.9,…

A:

Q: The converter that employed to vary the root mean square voltage across the load at constant…

A: an ac chopper is a thyristor power converter that converts a fixed voltage, fixed frequency ac input…

Q: Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A:

Q: 1) Given the following circuit comprising a 3x8 decoder with negated outputs and a 2x4 decoder with…

A:

Q: Industrial Motor Controls 18.a. The PLC motor speed control system you are working on has an analog…

A: A Programmable Logic Controller is abbreviated as PLC. These are used for programmable variety of…

Q: 1) The equivalent resistance when a resistor of 1/3 2 is connected in parallel with a 1/4 2…

A:

Q: Three identical capacitance, each of 150 microfarad, are connected in delta. The value of…

A: Given three identical capacitance, each of 150 microfarad, are connected in delta. here we have to…

Q: 3D Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is…

A: For the above given question by drawing the cascade configuration of the operational amplifiers we…

Q: 20. A three phase, 50 Hz induction motor has 8 poles. If the full load slip is 2.5%, determine (i)…

A:

Q: Q5) Determine the z-transform of the following signal. x(n) = n(-1)"u(n)

A:

Q: 11.21 Assuming that the load impedance is to be purely resistive, what load should be connected to…

A:

Q: f 20 MW, a load factor of 60%, a plant capacity factor of 48% and a plant use factor of 80% Find:…

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: Q2A//:For the circuit shown in fig.(2).write voltage equations in term of currents. I₁ 1022 402 VI…

A: For the above given circuit diagram we need to derive the voltage equations in terms of currents.…

Q: QUESTION 1 final a. Explain the word potentiometer as applied to this course b. Explain the word…

A: Given  we need to define potentiometer and bridge used in measurements. Please find the below…

Q: By recording function, the information is supplied by the measuring instrument as a deflection of a…

A: Given  True or false questions based on measuring instruments. Please find the below attachment for…

Q: For the following sequence {3.2,-2.2,-1.5,1.4,1.89,3.3…}, Quantize it using a uniform quantizer in…

A: Given,The sequence is,=3.2,-2.2,-1.5,1.4,1.89,3.3…The range of the quantizer is,=-3, 3total levels…

Q: Design a combinational Logic circuit in which whenever input is an even number between 1 and 10 a…

A: The logic circuit can be designed by using the truth table and the reduced Boolean expression can be…

Q: Q2/Find ((90)10/(36)8)* (F1)16+ (1100111)2=( )Gray O 100101100 1010100111 1000101100 O None of them…

A: given 9010368*F116+11001112=_____grayhere we have find the value which is suitable for blank

Q: 220 kV, 50 Hz A 3-phase, transmission line consists of 1-2 cm radius conductors spaced 2 m at the…

A:

Q: Q7/Chose the correct answer for the output G of the following circuit (Assume that A= 111100 B=…

A:

Q: Q/What are the key analogies between dynamic systems? Support your answer with physical examples and…

A:

Q: Determine the cut-off frequency for an intergrator op-amp if the Ri= 20kOhms while the Cf= 0.02…

A: For the above given question we need to calculate the value of cutoff frequency of the integrator…

Q: for H(s) = (s+1)/(s+4)^2 find the system response from the input cos(2t + 45o)u(t)  u(t) is the…

A: In this question we need to find a output of the given system.

Q: Q / Draw the output voltage Vo₁ & VO₂ of the circuit shown in fig. 2 fig.2 then i/p voltage (Vin) is…

A: Draw the output voltage  V01 and V02 of the circuit shown in fig. 2 when input voltage (Vin) square…

Q: VI and V₂ : V₁ = 53. 914 L25.5° V₂ = 53. 988 4²9.7" SOLVE FOR Answer should be :

A: The given node equation can be solved by using the cramer's rule. It depends on the determinant of…

Q: A 20-KVA, 20,000/480-V, 60-Hz distribution transformer is tested with the following results:…

A: Given  Parameters of a distribution transformer. We need to sketch the per  equivalent circuit.…

Q: In a three phase circuits, determine and plot the phase sequence of the set of voltage :- (a) Va=200…

A: In this question,  We need to determine the phase sequence of the given waveforms.

Q: 1. For unsymmetrical analysis in power system why we use operator a? 2. In Delta connected load,…

A: 1. The operator "α"  stands for an abbreviation for showing a difference phase shift of 120 degrees.…

Q: Example 7.8 Calculate the modulation frequency fm and modulation index m for the spectrum analyzer…

A: Given data, The control frequency = 10MHz The ref. level is 10 dBm

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.