The bulk modulus of a material is 7.24 x 1011 N/m². What fractional change in volume does a piece of this material undergo when it is subjected to a bulk stress increase of 4.85x107 N/m? Assume that the force is applied uniformly over the surface. Round your answer to 3 decimal places.

The bulk modulus of a material is 7.24 x 1011 N/m². What fractional change in volume does a piece of this material undergo when it is subjected to a bulk stress increase of 4.85x107 N/m? Assume that the force is applied uniformly over the surface. Round your answer to 3 decimal places.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 61P: The bulk modulus of a material is 1.01011N/m2 . What fractional change in volume does a piece of...

See similar textbooks

Related questions

Q: A bolt is dropped from a bridge under construction, falling 85 m to the valley below the bridge. (a)…

A: a). It takes 1.62s to pass through the last 23% of its fall. b). It begins at a velocity of 35.83…

Q: An oxygen bottle of 40.0 l volume shows a pressure of 7.00 MPa inside the bottle. Then, 80.0 l of…

Q: Mass of a body is 15.1 kg, What is it's weight ?

A: Given Mass m=15.1kg

Q: A body oscillates with simple harmonic motion ac- cording to the equation x = (6.0 m) cos (37…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: An airplane is flying in the direction 53° west of north at 725 km/hr. Find the component form of…

Q: A body in space weighs 4.5N. If acceleration is 9.8 m/s2.Find the mass

Q: In the circuit shown, R1 = 3 ohms, R2 = 6 ohms, R3 = 20 ohms, and Potential = 12 V. Calculate the…

Q: The resistivity of gold at room temperature is 2.35 x 10-8 ohm-m. The temperature coefficient alpha…

Q: •45 The saturation magnetization Mmax of the ferromagnetic metal nickel is 4.70 x 10° A/m. Calculate…

A: Write the given values with the suitable variables. Ms=4.70×105A/mρ=8.90 g/cm3M=58.71 g/mol Here,…

Q: 6. In the following circuit: 24 2 11V 37 0 Solve for a) the total resistance, b) the total current,…

A: Given Resistance of the two resistors are R1=24 Ω and R2=37 Ω EMF of the battery is V=11 V

Q: .. QUESTIUNS Use the ammeter and voltmeter reading to find the relative error in power where P-VI…

A: We use error analysis to solve this problem

Q: A 4.50 m long rope is stretched between two supports with a tension that makes the speed of…

A: length = l = 4.5 m speed = V = 60 m/s

Q: Gbenga needs to get glasses to correct his farsightedness. His eyes currently cannot focus on…

A: As given, Image distance, v=2.1 ft=63 cm Object distance, u=25 cm Draw the figure as follow.

Q: Draw a free-body diagram depicting RHR-1 for each item. 1. A proton in a particle accelerator has a…

Q: 10. Conservative or Not Conservative F(x, y) = аxi + аy) x2 + y2

Q: Fill in the blanks. A diverging lens has a focal length of -25 cm. A 5-cm object is placed 35 cm…

A: focal length of diverging lens (f) = - 25 cm height of object = 5 cm obejct distance (d) = 35 cm

Q: A rocket has 15,000 kg of fuel and its mass is given by m = 20,000 kg - (50 kg/s)t Thus, its mass…

A: Note that: first and second questions are identical only. 3rd and 4th question is different. As per…

Q: 03 A Gaussian surface in the shape of a right circular cyl- inder with end caps has a radius of 12.0…

A: Radius, r = 12 cm = 12×10-2 m = 0.12 m Length, h = 80 cm = 80×10-2 m = 0.8 m Magnetic flux through…

Q: For the following series circuit, solve for a) the total, equivalent resistance, b) the total…

A: Given Resistance of the three resistors are given as R1=7 Ω, R2=25 Ω and R3=15 Ω EMF of the battery…

Q: Find the rest energy, in terajoules, of a 12.1 g piece of chocolate. 1 TJ is equal to 1012 J . rest…

A: Rest energy (E) = M0 c2 Where M0 = 12.1 g c = 3 x 108 m/s

Q: Gbenga needs to get glasses to correct his farsightedness. His eyes currently cannot focus on…

Q: What is the potential at a distance of 5.0 ? 10-10 m from a nucleus of charge +50e?

A: Given : Charge "Q"= 50e distance "r" =5×10^-¹⁰ m Formula to be used : V= kQ/r Where k =…

Q: What is the difference between the value obtained using E= I/(d2) and E = (# ∙ n ∙ LM ∙ CU ∙ LLF)/A.…

A: Hand wriiten solution is in step-2.

Q: What is the pressure on the base of a swimming pool due to water alone if the depth is 2m? Density…

Q: Within a region of free space, charge density is given as py = (5rcose)/a C/m3, where a is a…

Q: •13 Prove that the displacement current in a parallel-plate capacitor of capacitance C can be…

Q: PROBLEM 2: A particle with mass m and charge q can only move in a narrow vertical oriented…

Q: A 96-mH solenoid inductor is wound on a form 0.80 m in length and 0.10 m in diameter. A coil is…

Q: Which of the following statemtents is inconsistent with the second law of thermodynamics? a. The…

Q: A 2.8 kg block with a speed of 3.9 m/s collides with a 5.6 kg block that has a speed of 2.6 m/s in…

Q: A vibrator with a frequency of 1200 Hz drives a 42 cm length of string attached to it. At the end of…

A: Standing wave, also known as stationary wave, is a combination of two waves travelling in opposing…

Q: boxes move under the effect of the applied force F = 40 N. Coefficient of friction between the…

Q: Galaxy B moves away from galaxy A at 0.519 times the speed of light. Galaxy C moves away from galaxy…

Q: 2. You push very hard on a heavy desk, trying to move it. You do work on the desk: a. whether or not…

A: Let's check each option one by one a whether or not it moves , as long as you are exerting a force…

Q: Suppose that you have found a way to convert the rest energy of any type of matter directly to…

Q: A lunar module weighs 12 metric tons on the surface of the Earth. How much work is done in…

Q: 9. What does a phase diagram tell us about a material?

A: Phase diagram:- Phase diagram is the diagram showing different phases of a material…

Q: eng does it take to boil away 0.2 kg of water at 100 degrees celcius 0/1 000 W heater? Specific…

Q: The nuclide Rn-204 is the daughter nuclide resulting from the a decay of what parent nuclide? A)…

A: Daughter nuclide = Rn-204decay type : alpha decay Let the parent nuclide = YZA

Q: A particle with a charge of 1.24x10-Cis moving with instantaneous velocity v =…

Q: In the circuit shown, Determine the following: A. Magnitude and direction of the current B. The…

Q: A bomb mass 9kg explodes into two pieces of masses 3kg and 6kg. The velocity of the mass 3kg piece…

Q: Part A An electron is fired through a small hole in the positive plate of a parallel-plate capacitor…

Q: 6. A tetherball of mass 3 kg is suspended from a rope of length 5.0 m and travels a circle of radius…

Q: Q2: Q3: Find the charge density in the system shown in Figure 2. V=0 2 5 97 V=0 Figure 2 V-2 V-2…

A: Charge density is defined as the charge per unit volume. q=rho×dV So, rho=q/dV

Q: Calculate the voltage if the resistance is 16.0 ohms and the current is 8 A ?

A: resistance of the resistor, R = 16.0 Ω current, I = 8 A

Q: 1. For the following series circuit, solve for a) the total, equivalent resistance, b) the total…

A: 1GivenV=15 VR1=7 ΩR2=25 ΩR3=15 Ω

Q: A convex lens is set up on a table. On one side is an illuminated object of size 8 cm that is 41 cm…

Q: Please solve. Q7

Q: Use a VIRP Table to analyze the following circuit. R1-50 Ohms 120 V R2-75 Ohms R3-50 Ohms

Concept explainers

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).

Question

The bulk modulus of a material is 7.24 x 1011 N/m². What fractional change in volume does a piece of this material undergo when it
is subjected to a bulk stress increase of 4.85x107 N/m? Assume that the force is applied uniformly over the surface.
Round your answer to 3 decimal places.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Follow-up Questions

Read through expert solutions to related follow-up questions below.

Follow-up Question

there is no unit? isn't Pa (Pascal)?

Solution

by Bartleby Expert

SEE SOLUTION

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Two rods, one made of copper and the other of steel, have the same dimensions. If the copper rod stretches by 0.15mm under some stress, how much does the steel rod stretch under the same stress?
A 100-N weight is attached to a free end of a metallic wire that hangs from the ceiling. When a second 100-N weight is added to the wire, it stretches 3.0 mm. The diameter and the length of the wire are 1.0 mm and2.0 m, respectively. What is Young’s modulus of the metal used to manufacture the wire?
Alarge uniform cylindrical steel rod of density =7.8g/cm3 is 2.0 m long and has a diameter of 5.0 cm. the rod is fastened to a concrete floor with its long axis vertical.what is the normal stress in the rod at the cross-section located at (a)1.0 mfrom its lower end?(b)1.5 m from the lower end?
Can Young’s modulus have a negative value? What about the bulk modulus?
Two thin rods, one made of steel and the other of aluminium, are joined end to end. Each rod is 2.0m long and has cross-sectional area 9.1mm2 . If a 10,000N tensile force is applied at each end of the combination, find: (a) stress in each rod; (b) strain in each rod; and, (c) elongation of each rod.
Review the relationship between stress and strain. Can you find any similarities between the two quantities?
A uniform wire (Y = 2.0 1011 N/m2) is subjected to a longitudinal tensile stress of 4.0 107 N/m2. What is the fractional change in the length of the wire?
A steel cable 2.00 m in length and with cross-sectional radius 0.350 mm is used to suspend from the ceiling a 10.0-kg model aircraft that is flying in a horizontal circle with an angular speed of 6.00 rad/s. What is the strain produced in the cable?
The bulk modulus of a material is 1.01011N/m2 . What fractional change in volume does a piece of this material undergo when it is subjected to a bulk stress increase of 107N/m2 ? Assume that the force is applied uniformly over the surface.
Can compress stress be applied to a rubber band?
A disk between vertebrae in the spine is subjected to a shearing force of 600 N. Find its shear deformation, taking it to have the shear modulus of 1109 N /m2. The disk is equivalent to a solid cylinder 0.700 cm high and 4.00 cm in diameter.
In Example 14.3, we found that one of the steel cables supporting an airplane at the Udvar-Hazy Center was under a tension of 9.30 103 N. Assume the cable has a diameter of 2.30 era and an initial length of 8.00 m before the plane is suspended on the cable. How much longer is the cable when the plane is suspended on it?