This apparatus was used by a student, in a brightly lit room, to measure the rate of water loss from a leafy shoot. He measured how far the bubble moved in five minutes. He measured this three times. The results are shown in the table. i. Measurement Distance moved by the bubble in cm 1 2 Table 9.1 3 11.9 12.6 13.0 Use these results to calculate the mean (average) rate of water loss in cm per minute. Show your working. cm per minute

This apparatus was used by a student, in a brightly lit room, to measure the rate of water loss from a leafy shoot. He measured how far the bubble moved in five minutes. He measured this three times. The results are shown in the table. i. Measurement Distance moved by the bubble in cm 1 2 Table 9.1 3 11.9 12.6 13.0 Use these results to calculate the mean (average) rate of water loss in cm per minute. Show your working. cm per minute

Aquaculture Science

3rd Edition

ISBN:9781133558347

Author:Parker

Publisher:Parker

Chapter12: Water Requirements For Aquaculture

Section: Chapter Questions

Problem 27SA

See similar textbooks

Similar questions

Using my chart can you help me answer this question? Why did we select distilled water to be the negative control?
You record the absorbance of your unknown BSA sample at 0.276. What is the concentration in ug/mL of the unknown assuming you have a standard curve with the line of best fit with y=0.0001x+0.0038 as its equation
In a photosynthetic investigation, a student measured the following pH of the stroma and the inner thylakoid compartments of spinach leaf cells at the conclusion of the experiment. Source of Fluid pH (mean) Standard Error of Mean (SEM) Stroma 8.2 0.75 Inner compartment of thylakoid 5.6 0.35 b. Construct an appropriately labeled graph to illustrate the sample means of the two locations to within 95% confidence (i.e. sample mean + 2 SEM).
I am not sure how to go about illustrating and answering this question: Use a diagram to illustrate how 10^-4, 10^-6 and 10^-8 dilutions in water of the soil suspension in a final volume of 10 mL will be prepared. There are only three tubes available.
in the data given, using salometer, water and salt is being combined with that the results showed that the percentage of salt dissolving in distilled water has greatest percentage, what is the reason behind?
For investigating the effect of pressure (height of a column of liquid), a 50-mL burette wasused with a small length of rubber tubing fixed to the bottom on which a clamp could befitted to start/stop the flow of water (Figure 1). Effluent was collected in a beaker and meanflow rate was calculated (mL/s), and a stopwatch was used to measure how long it took for5 mL of liquid to flow out. For the subsequent sections of the practical, a 25-mL burette wasused, and the top was connected via rubber tubing to a 5-liter reservoir placed on theshelving above the bench. The tubing at the base was connected to the different flowmodules that comprised the different configurations of tubes to be tested. Figure 1: A. Theoretical set-up of the experiment. B. Flow rate data with increasing pressure a. Interpret the graph.b. What does this relate to in the cardiovascular system, and is it something that canchange? How?c. What would be the implications for our ability to control blood flow to different…
During transfer of liquids using a micropipette: What would it mean if the mean is very close to the expected value but your standard deviation is high ?
Calculate the enthalpy of vaporization at the normal boiling point (760 mmHg) of the liquid(water, boiling point of 100 celsius).
For investigating the effect of pressure (height of a column of liquid), a 50-mL burette was used with a small length of rubber tubing fixed to the bottom on which a clamp could be fitted to start/stop the flow of water (Figure 1). Effluent was collected in a beaker and mean flow rate was calculated (mL/s), and a stopwatch was used to measure how long it took for 5 mL of liquid to flow out. For the subsequent sections of the practical, a 25-mL burette was used, and the top was connected via rubber tubing to a 5-liter reservoir placed on the shelving above the bench. The tubing at the base was connected to the different flow modules that comprised the different configurations of tubes to be tested. a. Interpret the graph. b. What does this relate to in the cardiovascular system, and is it something that can change? How? c. What would be the implications for our ability to control blood flow to different tissues, if this were the only control mechanism available? d. Based on the…
The elution order does not match the expected order for coconut oil and the peaks do not match. Explain what might cause this issue.
Using the data in this table, what is the AG° (in KJ/mol) for the reduction of FAD by water?
If HCO, is 24 mEq/L, and PaCO2 is 40 mmHg calculate the pH.