Three pipoes A,B and C coonected in seies discharges 160 L/s of water. The properties of pipe: for pipe A,L= 1800 m, diameter= 0.90 m f= 0.012; for pipe B, L= 1500 m, diameter= 0.60 m f=0.012 and for pipe C, L= 800 m , diameter = 0/45 m, f= 0.012. Disregarding minor losses, find the total headloss of the pipe. include fbd a.0.492 m. b.0.078 m. c.1.675 m. d.1.15 m.

Q: In the figure shown, there are 38 meters of 5-cm diameter pipe, 23 meters of 15-cm diameter pipe,…

A: Soln:- from given figure 1) loss due to entrance :-      Q= AV     4.5 × 10^-3 = area × velocity…

Q: P6.32 SAE 30 oil at 20°C flows in the 3-cm-diameter pipe in Fig. P6.32, which slopes at 37°. For the…

A:

Q: It is a well–known fact that Roman aqueduct customers obtained extra water by attaching a diffuser…

A: Write the expression of the Reynold number. Write the expression of the friction factor.

Q: Example 1 Water enters the basement through a pipe r1=2 cm in radius at an absolute pressure of 3…

A:

Q: Q8. Considering frictionless, incompressible, one- dimensional flow of water through the horizontal…

A:

Q: A converging elbow (see Figure) turns water through an angle of 135o in a vertical plane. The flow…

A: Given,  At inlet - D1 = 400 mm P1 = 150 KPa At outlet -  D2 = 200 mm P2 = 90 KPa   Flow rate ,…

Q: A 15 mm x 250 mm x 100 mm woodblock weighing 10 N is struck by a water jet of 20 mm diameter as seen…

A: Given data: The weight of the block is W = 10 N. The diameter of the water jet is d = 20 mm. The…

Q: Two reservoirs, which differ in surface elevation by 40 m,are connected by 350 m of new pipe of…

A: Write the given Data:

Q: Pump Patm = 100 kPa D=3 cm Gasoline, SG= 0.68 x-

A: Given data:  Discharge, Q = 65 gallons/min Q=65×6.309×10-5 m3/s Diameter of pipe, d = 3 cm = 0.03 m…

Q: Three pipoes A,B and C coonected in seies discharges 160 L/s of water. The properties of pipe: for…

A:

Q: Q5: A smooth pipe of diameter 400 mm and length 800 m carries water at volumetric flow rate 0.04…

A: Given data Diameter of pipe = 400 mm = 0.4 m Length of pipe = 800 m Volumetric flow = 0.04 m3/s…

Q: 3. Water at 20°C is to be pumped from reservoir 1 to 2 in a 6-in-diameter asphalted cast iron pipe…

A: The power required by the pump to displace fluid from a place to another can be calculated using the…

Q: An 11.5-in-diameter centrifugal pump, running at1750 r/min, delivers 850 gal/min and a head of 105…

A:

Q: For a flow of oil (m = 0.1 N.s/m, S.G. = 0.75) through a horizontal, straight, smooth 5 cm diameter…

A:

Q: QI: Gasoline is being discharged from apipe at point 2 at elevation 66.66 m. point 1 located 965.5m…

A:

Q: Water at 20 °C flows through an inclined 8-cm-diameterpipe. At sections A and B the following data…

A: Given Data: The pressure at section A is pA = 186 kPa The velocity at section A is VA = 3.2 m/s The…

Q: Assume that r = 0.137 m, ro = 0.138 m, µ = 1.49 kg/m-s (glycerin), p = 1260 kg/m3, and Qj = 120…

A:

Q: The reservoirs in Fig.  are connected by cast iron pipesjoined abruptly, with sharp-edged entrance…

A: Given data: The diameter of pipe 1 is d1=1 in. The length of pipe 1 is l1=20 ft. The diameter of…

Q: (c) The inlet condition of air to a convergent-divergent nozzle is 2.2 MN/m² and 260°C. The exit…

A:

Q: Three pipes steadily deliver water at 20°C to a large exit pipe in Fig. The velocity V3 = 8 m/s, and…

A:

Q: For the system-Water at 20°C flows by gravity through a smooth pipe fromone reservoir to a lower…

A: Write the given data: L=360 mhf=60 mQ=90 m3/h=0.025 m3/s2.7×10-4 m3/s1 m3/hfor T=20 °ρ=998…

Q: There is a flow of fluid compressible in permanent regime in a circular section convergence. Knowing…

A: given flow weight =1.8N/s circular section convergence d1=15cmd2=7.5cmspecific volume at section 1,…

Q: Water at 10°C flows from a large reservoir to a smaller one through a 5-cm-diameter cast iron piping…

A:

Q: s 50 kg. Determine the anchoring force needed to hold the elbow in place. Take the momentum-flux…

A: The angle of deflection is: θ=45ο The mass flow rate of water is: mο=30 kg/s The area of the elbow…

Q: A pump delivers 1 hp to a water at 68°F flowing in a 10-in-diameter horizontal, cast iron pipe at V…

A:

Q: Water is flowing in a piping system as shown tin figure, Find the i. diameter of section 2 pipe. ii.…

A:

Q: Water exits a 1-cm diameter outlet of a faucet. Estimate the maximum speed that would result in a…

A: In the given problem, the maximum speed (m/s) of the water is asked but the options are given in…

Q: Water at 20 ° C is delivered from one reservoir to anotherthrough a long 8-cm-diameter pipe. The…

A: Given data as per question Pipe diameter = 8 cm Z2 = 80 m h loss ≈17.5( V 2 /2 g ) flow rate = 500…

Q: find the total headloss of the pipe.

A:

Q: (4) What pressure drop is required in order to pump water at 20°C through a pipe 25 cm in diameter…

A: 4 ) given data  Pipe dimension  Diameter = 25cm  Length = 1234m  Flow rate = 1.97 m2 sec -1  Pipe…

Q: Water flows through a venturi as shown in the figure at a flow rate of Q=57.1 L/s. The inlet and…

A: Given:Q=57.1 L/sD=3 cmd=2.5 cmL1=65 cmL2=53 cm

Q: Q2/ In Figure, the fluid is gasoline at 20°C at a discharge of 0.018m3/sec. Assuming no losses,…

A: Given: The discharge, Q = 0.018 m^3/s The density of oil = 680 kg/m^3

Q: Three pipes steadily deliver water at 20°C to a large exit pipe in Fig. The velocity V3 = 8 m/s, and…

A:

Q: 1. Water flows over a flat surface at 1.2 m/s, as shown in the figure. A pump draws in water through…

A: Calculate the source strength. Write the equation of stream function for uniform flow and sink.…

Q: 02. Gasoline at 20°C is pumped through a smooth 12-cm diameter pipe 10km long, at a flow rate of 75m…

A: From the given data,Energy equation of steady state;The velocity will be equal as pipe dia. is…

Q: Example I A fluid flows steadily through a converging duct with cross- sectional areas of sections…

A:

Q: The three-arm lawn sprinkler receives 20°C water through the centre at 2.7 m3/hr. If collar friction…

A: Given data  Volume flow rate of water (Q) = 2.7 m3/hr dia of tube (D) = 7 mm = 0.007 m length of arm…

Q: Roman aqueduct customersobtained extra water by attaching a diffuser to theirpipe exits. Fig. shows…

A: Given data Diameter of the give pipe D1 = 3 cm = 0.03mLength of the pipe L = 2mHeight of the tank H…

Q: In the figure shown, there are 38 meters of 5-cm diameter pipe, 23 meters of 15-cm diameter pipe,…

A: Length of first pipe, L1=38 mDiameter of the first pipe, d1=5 cm=0.05 mLength of second pipe, L2=23…

Q: Two horizontal pipes in series , each 1000 ft long and discahrges water at the rate of 4.75 ft^3/s,…

A:

Q: The following data were obtained for the flow of 20°C water at20 m3/h through a badly corroded…

A: Given data P1=420 KPaP2=250 KPaZ1=12 mZ2=3 m

Q: A surge chamber 10m in diameter is situated at the down stream end of a low pressure tunnel 9.8km…

A:

Q: Estimate the flow rate Q at time t = 4s by using: (a) 2-Point Forward Difference (b) 2-Point…

A: Q = dVdt (a) Forward difference: f'(x) = f(x+h) - f(x)h (b) Backward difference: f'(x) = f(x) -…

Q: The 3.0 cm diameter water line splits into two 1.0 cm diameter pipes. All pipes are circular and at…

A: Given Entrance diameter = 3 cm Entrance velocity = 3.5 m/s Exit diameter = 1 cm To find Velocity at…

Q: Q4. Water flows steadily through 45° reducing elbow, located on a horizontal plane. V1 = 1.5 m/s, P1…

A: As per given question  Determine the flow rate. Determine the flow velocity at the narrow section.…

Q: A hydro turbine operates with a head of 50 m of water. Inlet and outlet conduits are  2 m in…

A: From bernoullis theorem we have P1ρg+v122g+Z1=P1ρg+v222g+Z2....................(1)P1, P2= Pressure…

Q: 10. A fluid moves in a steady flow manner between two sections in a flow line. At section…

A:

Q: Three pipoes A,B and C coonected in seies discharges 160 L/s of water. The properties of pipe: for…

A:

Q: What is the greatest average speed of blood flow at 37° C in an artery of radius 2.00 mm if the flow…

A:

Q: 41. A hole in a tank, (v = 360 m-s1), the tank (volume = 0.041m³, p= 696 kPa, T= 37 C°, the rate…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.