To strengthen his arm and chest muscles, an 82-kg athlete who is 2.0 m tall is doing push-ups as shown in Fig. E11.15. His center of mass is 1.15 m from the bottom of his feet, and the centers of his palms are 30.0 cm from the top of his head. The force (in N) that the floor exerts on each of his feet and on each hand, assuming that both feet exert the same force and both palms do likewise, is Figure E11.15 2.0 m k-30.0 cm 201 402 272 O 103

To strengthen his arm and chest muscles, an 82-kg athlete who is 2.0 m tall is doing push-ups as shown in Fig. E11.15. His center of mass is 1.15 m from the bottom of his feet, and the centers of his palms are 30.0 cm from the top of his head. The force (in N) that the floor exerts on each of his feet and on each hand, assuming that both feet exert the same force and both palms do likewise, is Figure E11.15 2.0 m k-30.0 cm 201 402 272 O 103

Physics for Scientists and Engineers

10th Edition

ISBN:9781337553278

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 11P

See similar textbooks

Similar questions

The Iron Cross When a gymnast weighing 750 N executes the iron cross as in Figure lN.91a, the primary muscles involved in supporting this position are the latissimus dorsi (lats") and the pectoralis major (pecs"). The rings exert an upward force on the aims and support the weight of the gymnast. The force exerted by the shoulder joint on the arm is labeled Fs, while the two muscles exert a total force Fw on the arm. Estimate the magnitude of the force Fw. Note that one ring supports half the weight of the gymnast, which is 375 N as indicated in Figure P8.91b. Assume that the force Fw acts at an angle of 45 below the horizontal at a distance of 4.0 cm from the shoulder joint In your estimate, take the distance from the shoulder joint to the hand to be L = 70 cm and ignore the weight of the arm.
Find the x- and y -coordinates of the center of gravity for theboomerang in Figure P8.12a, modeling the boomerang as inFigure P8.12b, where each uniform leg of the model has alength of 0.300 m and a mass of 0.250 kg. (Note: Treat the legslike thin rods.)
A uniform plank of length 2.00m and mass 30.0kg is supported by three ropes, as indicated by the blue vectors in figure p8.27. Find the tension in each rope when a 700-N person is d=0.500m from the left end.
In an emergency situation,a person with a broken forearmties a strap from his hand to clipon his shoulder as in Figure P8.92.His 1.60-kg forearm remains in ahorizontal position and the strapmakes an angle of θ = 50.0° withthe horizontal. Assume the forearmis uniform, has a length ofl= 0.320 m, assume the bicepsmuscle is relaxed, and ignore themass and length of the hand. Find(a) the tension in the strap and(b) the components of the reactionforce exerted by the humeruson the forearm.
A person bending forward to lift a load “with his back”(Fig. P8.23a) rather than “with his knees” can be injured bylarge forces exerted on the muscles and vertebrae. The spinepivots mainly at the fifth lumbar vertebra, with the principalsupporting force provided by the erector spinalis muscle inthe back. To see the magnitude of the forces involved, and tounderstand why back problems are common among humans,consider the model shown in Figure P8.23b of a person bendingforward to lift a 200.-N object. The spine and upper bodyare represented as a uniform horizontal rod of weight 350. N,pivoted at the base of the spine. The erector spinalis muscle,attached at a point two-thirds of the way up the spine, maintainsthe position of the back. The angle between the spineand this muscle is 12.0°. Find (a) the tension in the back muscleand (b) the compressional force in the spine.
Find the x - and y -coordinates of the center of gravity for the boomerang in Figure P8.12a. modeling the boomerang as in Figure P8.12b, where each uniform leg of the model has a length of 0.300 m and a mass of0.250 kg. (Note: Treat the legs like thin rods.)
You can find the center of gravity of a long ruler by resting it horizontally on your two index fingers, and then slowly drawing your fingers together. First the ruler will slip on one finger, and then on the other, but eventually the fingers meet at the CG. Why does this work
In order to balance a meterstick at the 27 cm mark, how much weight would you need to hang at the 10 cm mark? Assume the stick weighs 200 g and its center of mass is at 50 cm.
. The forces exerted by the bicep muscle and acting on the elbow when a 12 kg barbell is being curledcan be modeled based on the diagram above. The bicep muscle can be treated as a vertical cable. Themass and length of the forearm are 2 kg and 32 cm, respectively. The center of mass of the forearm is adistance of 14 cm from the point P, while the bicep connects to the forearm at a point 4.5 cm from P.a) Determine the tension in bicep muscle and the force of the humerus acting downward on the elbowat point P. b) Assuming the tension in the bicep muscle continues to be oriented vertically, determinethe tension in the bicep muscle and the force acting at P after the barbell has been raised by an angleof 30 relative to the horizontal.
A uniform plank of length 2.00 m and mass 30.0 kg issupported by three ropes, as indicated by the blue vectors inFigure P8.27. Find the tension in each rope when a 700.-Nperson is d = 0.500 m from the left end.
A 1.90-m-long barbell has a 21.0 kg weight on its left end and a 32.0 kg weight on its right end. If you ignore the weight of the bar itself, how far from the left end of the barbell is the center of gravity? Express your answer to three significant figures and include the appropriate units. Where is the center of gravity if the 9.00 kg mass of the barbell itself is taken into account? Express your answer to three significant figures and include the appropriate units.