a) To validate the performance of the power transducer the testing department would like to make surethat the quality of the product in comparison with its competitor is better. To validate this claim you wereasked to conduct the following experiment. Power transducer of the company (T1) and the powertransducer of the competitor (T2) are tested. To compare between them, you decided to test their accuracyand precision. Accuracy of a sensor is a measure of how near its reading is to the real value, the nearer themeasured value to the real value the better. While precision is a measure of how widely spread thereadings of a sensor are [relative to each other] when measuring the same variable, the narrower the spreadthe better. So, you tested the two sensors by measuring the same power, which was 10 W of an LEDSpotlight, and you recorded the following 10 measurements of each sensor. Which Sensor has higheraccuracy, and which one has higher precision.Measured Power is P= 10 W10,1510.16T110.19.99.8510.39.710.259.910.029.98T210.1510.149.9810.1710.29.9510.2110.2310.18

Result: The measure with the higher average value is is said to be higher accurate. Consider, the…

To validate the performance of the power transducer the testing department would like to make sure at the quality of the product in comparison with its competitor is better. To validate this claim you we ked to conduct the following experiment. Power transducer of the company (T1) and the power nsducer of the competitor (T2) are tested. To compare between them, you decided to test their accura d precision. Accuracy of a sensor is a measure of how near its reading is to the real value, the nearer easured value to the real value the better. While precision is a measure of how widely spread the dings of a sensor are [relative to each other] when measuring the same variable, the narrower the spr

To validate the performance of the power transducer the testing department would like to make sure at the quality of the product in comparison with its competitor is better. To validate this claim you we ked to conduct the following experiment. Power transducer of the company (T1) and the power nsducer of the competitor (T2) are tested. To compare between them, you decided to test their accura d precision. Accuracy of a sensor is a measure of how near its reading is to the real value, the nearer easured value to the real value the better. While precision is a measure of how widely spread the dings of a sensor are [relative to each other] when measuring the same variable, the narrower the spr

MATLAB: An Introduction with Applications

6th Edition

ISBN:9781119256830

Author:Amos Gilat

Publisher:Amos Gilat

Chapter1: Starting With Matlab

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rural county presently uses Asphalt A to pave its highways, but is considering using themore expensive Asphalt B (which is reported to be more durable). The two types of asphaltare tested using 200m test strips on five different two-lane highways. On each test strip, arandomly selected lane was paved with Asphalt A and the lane in the opposing direction waspaved with Asphalt B. It has been determined that it is more economical to use Asphalt B ifthe length of time before resurfacing is required (i.e. longevity) is at least 2.5 years longer onaverage than that of Asphalt A. Assume that the longevity of each type of asphalt is normally distributed. Using a 2% significance level and assuming that the data for the two types of asphalt at eachtest strip can be paired, determine if Asphalt B lasts at least 2.5 years longer than Asphalt Aon average. Location 1 2 3 4 5Asphalt A 11.2 9.0 10.7 11.4 8.5Asphalt B 18.8 11.7 19.9 19.0 13.4
A manufacturer of floor polish conducted a consumer-preference experiment to determine which of five different floor polishes was the most appealing in appearance. A sample of 100 consumers viewed five patches of flooring that had each received one of the five polishes. Each consumer indicated the patch he or she preferred. The lighting and background were approximately the same for all patches. The results are given below. Solve the following using the p-value approach and solve using the classical approach. Polish A B C D E Total Frequency 26 16 16 21 21 100 (a) Complete the hypothesis test using ? = 0.10. (i) Find the test statistic. (Round your answer to two decimal places.) (ii) Find the p-value. (Round your answer to four decimal places.)
I need the Solution to Question 4. 4) Mungo’s management team is convinced that the product will be a success if 30% or more ofthe product’s target population indicate they are likely to purchase the product. Based uponyour answer in Task 3, how would you advise management regarding the potential for theproduct to be successful?
An industrial concern has experimented with several different mixtures of the fourcomponents—magnesium, sodium nitrate, strontium nitrate, and a binder—that comprise arocket propellant. The company has found that two mixtures, in particular, give higher flare illumination values than the others. Mixture 1 consists of a blend composed of the proportions.40, .10, .42, and .08, respectively, for the four components of the mixture; mixture 2 consists ofa blend using the proportions .60, .25, .10, and .05. Twenty different blends (10 of each mixture)are prepared and tested to obtain the flare-illumination values. These data appear here (in unitsof 1,000 candles).Mixture 1 185 192 201 215 170 190 175 172 198 202Mixture 2 221 210 215 202 204 196 225 230 214 217a. Plot the sample data. Which test(s) could be used to compare the meanillumination values for the two mixtures?b. Give the level of significance of the test and interpret your findings
A manufacturer of floor polish conducted a consumer-preference experiment to determine which of five different floor polishes was the most appealing in appearance. A sample of 100 consumers viewed five patches of flooring that had each received one of the five polishes. Each consumer indicated the patch he or she preferred. The lighting and background were approximately the same for all patches. The results are given below. Solve the following using the p-value approach and solve using the classical approach. Polish A B C D E Total Frequency 26 16 14 20 24 100 (a) State the hypothesis for "no preference" in statistical terminology. H0: P(A) + P(B) + P(C) + P(D) + P(E) = 1H0: P(x) = P(y) for some x and y H0: P(A) ≠ P(B) ≠ P(C) ≠ P(D) ≠ P(E)H0: P(A) = P(B) = P(C) = P(D) = P(E) = 0.2 (b) What test statistic will be used in testing this null hypothesis? p? ?2tz (c) Complete the hypothesis test using ? = 0.10.(i) Find the test statistic. (Round your answer to two decimal…
In relation to an evaluation of a natural park you have collected data on the visitors, and obtaineddata for the travel costs and their zones of origin, i.e. basic data needed when applying the TravelCost Method.All visitors come by car and there’s only one person in each car. There are four different zones (Iclose, and IV most far away) and the total cost per person is given in the table below. Give a short explanation of the TCM. Would it be possible to do a reasonable TCM analysis from these data? Zone Travel cost per person($) Total population ineach zone Annual number ofvisitors from eachzone I 10 4000 400 II 15 3000 250 III 20 3500 410 IV 25 4000 450
To determine the effectiveness of an oil additive, a testing firm purchased two cars of the same make, year, and model, and drove each a distance of 30,000 miles using the same kind of gasoline, the same kind of oil, the same driver, under the same road conditions. The oil in one engine included the additive, whereas the oil in the other engine did not. At the end of the test, the engines of both cars were dismantled, and it was found that the engine that contained the additive had less wear. The testing firm concluded that the oil additive caused the reduced wear.
A crayon manufacturer is comparing the effects of two kinds of yellow dye on the brittleness of crayons. Dye B is more expensive than dye A, but it is thought that it might produce a stronger crayon. Four crayons are tested with each kind of dye, and the impact strength (in joules) is measured for each. The results are as follows: Dye A: 1.0 2.0 1.2 3.0 Dye B: 3.0 3.2 2.6 3.4 a) Can you conclude that the mean strength of crayons made with dye B is greater than that of crayons made with dye A? b) Can you conclude that the mean strength of crayons made with dye B exceeds that of crayons made with dye A by more than 1 J?
To test compliance with authority, a classical experiment in social psychology requires subjects to administer increasingly painful electric shocks to seemingly helpless victims who agonize in an adjacent room.* Each subject earns a score between 0 and 30, depending on the point at which the subject refuses to comply with authority—an investigator, dressed in a white lab coat, who orders the administration of increasingly intense shocks. A score of 0 signifies the subject's unwillingness to comply at the very outset, and a score of 30 signifies the subject's willingness to comply completely with the experimenter's orders. Ignore the very real ethical issues raised by this type of experiment, and assume that you want to study the effect of a “committee atmosphere” on compliance with authority. In one condition, shocks are administered only after an affirmative decision by the committee, consisting of one real subject and two associates of the investigator, who act as subjects but, in…
Assuming an M/M/1 system setup with a service rate of 25 entities per hour and an idling ratioof 4% Define the system’s birth rate. Define at least two ways of arriving at the number of entities in the system. Define the ratio of the time an entity spends waiting and the time the entity spends in thesystem?
Second question does the method appear to e effective?
choose one of the following procedures for each of the research scenarios described. In a rural school 202 students from a total school population of 723 suffer from malnutrition while in an urban school, 167 students from a total of 1 001 suffer from malnutrition. A master’s degree student wants to determine whether suffering from malnutrition is dependent on the region (urban versus rural) in which the school is situated.