trapezoidal dam wherein the upstream side is vertically straight and has a width at the top of 4 m, height of the dam is 24 m, height of the water at the upstream side is 20 m, bottom is 24 m, and has a coefficient of friction of 0.8 Find the factor of safety against sliding. Please answer it ASAP and with FBD. Thank you so much.

Q: 8. The annual precipitation (in mm) observed on a network of stations is shown in the figure below.…

A: The solution need to join all the station with grid point

Q: Problem # 5: The horizontal member shown in the figure is loaded by 25 kN at E. It is supported by…

A:

Q: 4 m 16 6m 4m 2m

A: First calculate the vertical reaction at A by considering the FBD of whole beam. Then the shear…

Q: . A box contains 500 envelopes of which 75 contains $100, 150 contain $25 and 275 contain 10. a.…

A:

Q: Q2) The velocity distribution for turbulent flow in pipes can be represented by the following…

A:

Q: Tapped into a 3-cm diameter horizontal water pipe is a piezometer and a Pitot tube. The height of…

A: Given: Level of water in pitot tube,h1= 20 cm = 0.2 m Level of water in piezometer,h2= 35 cm = 0.35…

Q: A 45° sector gate is located on the crest of spillway. The water is upto the mid- point of the gate…

A:

Q: An inclined plate 2 m long and 1 m wide lies with its length inclined at 45° to the surface of water…

A: Given: W = 1000Kg/m3, A = 2m*1m Determine the total pressure on the plate=?

Q: Beams AB and BC are connected with a hinge at B. Select the lightest W-shape for each beam if the…

A:

Q: The figure shows a pin-jointed plane truss loaded at the point M by hanging a mass of 100 kg. The…

A:

Q: A sample of wastewater is mixed with 2 parts clean water and placed in a bottle. The DO of a sample…

A: Given data : The value of initial dissolved oxygen D.Oi=10 mg/L The value of Final dissolved oxygen…

Q: 6. The rigid beam is supported by a smooth pin at O and attached to two vertical rods. Assume that…

A:

Q: -2 m. E B 5 m 3 m 3 m A D y -4 m. 244 kN

A:

Q: Consider an object subjected to stresses o, =10N/mm, o, 2N/mm. Along with these, a shear stress T =4…

A: Von misses failure stress theory is also called as Distortion ENergy principleso,We have…

Q: Suppose you have purchased a filling machine for candy bags that is supposed to fill each bag with…

A:

Q: nd the cross-sectional area of steel bar that will not deform e than 10mm nor be stressed b 100 Mpa…

A:

Q: 1- Most of ownership cash flows are expenses (outflow) but is cash inflow. 2- Major repairs &…

A: INTRODUCTION: The cash flow are generally related to the management practices related to any field…

Q: Problem V: A reducing elbow in a horizontal pipe shown in Figure 5 is used to deflect the inlet and…

A: As per bartleby guidelines, only 1st 3 parts among multiple parts questions posted need to be…

Q: The figure shows a pin-jointed plane truss loaded at the point M by hanging a mass of 100 kg. The…

A:

Q: (a) Discuss the importance of these products in the hydration process: i) C-S-H gel CalOH)

A:

Q: An 8 m wide bituminous concrete pavement of a state highway is to be constructed in a heavy rainfall…

A:

Q: Please provide an in-depth explanation of the Field Infiltration Test SetUp and Steps Ring…

A: Field Infiltration Test- Infiltration tests estimate the rate at which runoff will infiltrate…

Q: D, 3 Use the diagram shown above. Given • D= 10 ft • D2= 7 ft • D3=4 ft • W - 500 #/ft Solve for the…

A: Figure is as shown

Q: King Arthur tries to remove a cylindrical hollow metal rod attached to a wall at one end by rotating…

A:

Q: 67 kN 135 kN-m D A B –2 m- –2 m- –2 m- (a)

A:

Q: The width at formation of a certain road is 10m and the side slopes of 1 in 2 in cutting and 1 in 1…

A: Given: The width is 10 m. The side slope in cutting is 1 in 2. The side slope in filling is 1 in 1.…

Q: The width of formation level of a certain cutting is 15m and the side slopes are 1: 2. The surface…

A:

Q: 3. A 30 m steel tape is 2 mm too long at 20°C with a pull of 55 N. A rectangle is measured with this…

A:

Q: Problem 12.2 In an unconfined compression test a sample of clay 100 mm long and 50 mm in diameter…

A:

Q: tangency s long anc ger and sh 31 degre

A:

Q: Using double integration method, for the overhanging beam shown, (a) derive the equation of the…

A: Given data E = 29000 ksi  I = 204 in4 1 ft = 12 inch  1 ft3 = (12)3 inch  Lets solve using both…

Q: 2. Calculate the internal force in members CJ and DE. 2,400. Ibs 1,750. Ibs 10.00 ft 2,000. Ibs…

A: Consider the figure,

Q: B 5m 5 m 5 m P.

A:

Q: . stresses in the steel b. nominal load, Pn

A:

Q: QUESTION 3 3.1. A trapezoidal channel convey 15 m³/s of water on a bed slope of 1 in 200. The base…

A: *Multiple questions*   As per our guidelines we are supposed to answer?️ only one question. Kindly…

Q: EX: The pipe has a diameter of (1.2m) at A. (1.5m) at B and (0.8m) at C. The discharge at C is…

A:

Q: 12 kip 3 kip/ft B - 6 ft 6 ft 12 ft

A:

Q: An irrigation canal is designed to deliver 8 cumec to meet peak of rabi demand of total 5000 ha,…

A: Given:  Discharge, Q=8 cumec Rabi area=5000 Ha Canal Loss =30% =0.3   To find: Duty of the canal

Q: Problem 2 A reinforced concrete beam is 300 mm wide with an effective depth of 400 mm. Use fe= 21…

A: Reinforced concrete beam : Reinforced concrete beams are structural elements designed to carry…

Q: An elevator lifted eleven 70 kg passenger from first floor to 2nd floor of the building with a force…

A: step 1-

Q: In RIDF curves, the duration is not the duration of an actual storm and most likely represents a…

A: Answer :- False Explanation :- In RIDF  curves represent the actual intensity , Duration and…

Q: 2. natural ventilation 3. general exchange of

A:

Q: 3. (a) For the beam shown in Figure Q3a, E is constant throughout. Using the moment distribution…

A:

Q: Question One: (4) List any two advantages and two disadvantages cf MATRIX organization chart when…

A: Matrix organization chart are used in construction management.

Q: 8. As shown, water (15°C) is draining from a tank through a galvanized iron pipe. The pipe length is…

A: Discharge through the pipe = Cd a 2gH is calculated from the discharge formula for a mouth piece H=…

Q: 2. The tangents of a compound curve intersect at an angle of 104°. The first curve has a radius of…

A:

Q: The framing plan of a two-storey post tensioned structure is shown below. Due to some issues, the…

A:

Q: Calculate the diameter of a 32000-meter- long pipe if it is equivalent to a pipe with a diameter of…

A: Given,  Length of pipe (1),   L1= 32000m Length of pipe (2), L2= 1000m Diameter of pipe (2), D2=…

Q: 4. The random variable x is the grade level of a secondary-school student selected at random. Its…

A:

Q: hanging a mass of 10

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.