Two milliliters of 0.025molars potassium iodate solution was used to standardized the sodium thiosulfate used in dissolved oxygen (DO) determination. If 19.4mL of the sodium thiosulfate solution was used, what is the corrected established relationship? (pre-established relationship: 10mL sodium thiosulfate = 1 ppm DO)

Two milliliters of 0.025molars potassium iodate solution was used to standardized the sodium thiosulfate used in dissolved oxygen (DO) determination. If 19.4mL of the sodium thiosulfate solution was used, what is the corrected established relationship? (pre-established relationship: 10mL sodium thiosulfate = 1 ppm DO)

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 109AE: Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray...

See similar textbooks

Similar questions

ANSWER THEM ALL FOR AN UPVOTE. ASAP PLEASE. The theoretical weight of 10 tablets is 9.35g. Each tablet contains 425mg of the active ingredient. Using this data, determine the amount of additive needed to prepare 160, 000 tablets. How many grams of drug are required to make 500ml of 25.0% solution?
Volumetric flasks show no intermediate gradations, but they show a single mark to indicate, with high precision, the volume they contain when they are filled to that mark. For most volumetric devices, "filled to the mark" means filled until the bottom of the meniscus of the contents is exactly coincident with the mark. In lab you prepared a standard solution having a concentration of 7 ppm. Using a buret, you transferred the required amount (7 mL) of the 40 ppm stock solution into a 100.0mL volumetric flask, added 2.0 mL sodium citrate solution, 2.0 mL of hydroquinone solution, 3 mL of phenanthroline solution, and diluted with distilled water to the mark. When you were finished, the final volume in your solution was 0.5cm above the mark. The solution you prepared is __________________ Question 7 options: less than 7 ppm because you added less solvent than necessary. greater than 7 ppm because you added less solvent than necessary. less than 7 ppm because you added more solvent than…
If an IV is mixed so that each 150mL contains 500mg of the drug lidocaine, how many minutes will it take for 750 mg of lidocaine to be administered if the rate is set at 5 mL/min? complete solution
he following five beakers, each containing a solution of sodium chloride (NaClNaCl, also known as table salt), were found on a lab shelf: Beaker Contents 1 200. mLmL of 1.50 MM NaClNaCl solution 2 100. mLmL of 3.00 MM NaClNaCl solution 3 150. mLmL of solution containing 25.5 gg of NaClNaCl 4 100. mLmL of solution containing 25.5 gg of NaClNaCl 5 300. mLmL of solution containing 0.450 molmol NaClNaCl Arrange the solutions in order of decreasing concentration. Rank from most concentrated to least concentrated. To rank items as equivalent, overlap them.
MULTIPLE CHOICE: Choose the letter of the best answer Please answer all questions correctly 1. The standardization of volumetric solution does not require hydrochloric acid. A. Permanganometry B. Cerimetry C. Iodimetry D. lodometry E.All of the choices 2. In the standardization of its volumetric solution, the primary standard is dried to constant weight, which means drying shall be continued until two consecutive weighings do not differ by more than 0.50 mg. A. Permanganometry B. Cerimetry C. Iodimetry D. lodometry E.All of the choices 3. In the standardization of its volumetric solution, potassium iodide was added to A. Permanganometry B. Cerimetry C. Iodimetry D. lodometry E.All of the choices 4. Starch is the indicator of choice for these procedures because it forms intense blue coloration with the solution. A. Permanganometry B. Cerimetry C. Iodimetry D. lodometry E. C and D 5. In the standardization of its volumetric solution, the reaction needs to be…
1. A 50.00 mL stock CaCl2 solution was diluted with water in a 250.0-mL volumetric flask. A 25.00 mL aliquot of this was further diluted to a final volume of 100.0 mL. Finally, 20.00-mL aliquot of the resulting solution was analyzed and found to contain 0.1500 M CaCh2 Solve for the concentration of the stock solution in M. 2. A 50.00 mL stock CaCl2 solution was diluted with water in a 250.0-mL volumetric flask. A 25.00 mL aliquot of this was further diluted to a final volume of 100.0 mL. Finally, 20.00-mL aliquot of the resulting solution was analyzed and found to contain 0.1200 g CaCl2 Solve for %w/v CaCl2 in the stock solution.
Consider 2 aqueous solutions: H2O/NaCl and H2O/CH3OH. Which one will exhibit a positive/negative/no deviation compare to Raoult’s prevision: a. H2O/NaCl and H2O/CH3OH both exhibit a negative deviation b. H2O/NaCl and H2O/CH3OH both exhibit a positive deviation c. H2O/NaCl and H2O/CH3OH don’t exhibit any deviation d. H2O/NaCl negative deviation and H2O/CH3OH positive deviation e. H2O/NaCl positive deviation and H2O/CH3OH negative deviation
While carrying out this practical class, all of the 25% (m/v) HCl solution was used up by the students and more of the solution had to be prepared. Concentrated hydrochloric acid containing 37% (m/v) HCl is available. What volume of concentrated hydrochloric acid should be made up to 100 mL with water in order to prepare more 25% HCl solution? Give your answer in mL to ONE decimal place. You do not need to include the units in your answer below.
A DoD device is charged with a 1.0 molar solution of ibuprofen (the API) in n-hexane. The molecular weight of ibuprofen is 206.3 g/mol. If a prescribed dosage is 5.00 mg ibuprofen/kg patient weight, how many milliliters of solution should be sprayed for a 255.0-pound man and a 100.0-pound child? (I have these answers). man: 2.803 child: 1.099 How many drops are in each dose, assuming that each drop is a sphere with a radius of 0.50 nm?
How many microliters of a 904.0 ppm Co2+904.0 ppm Co2+ stock solution are required to prepare 20.00 mL20.00 mL of a 19.0 ng/?L Co2+19.0 ng/μL Co2+ solution? Significant figures are graded for this problem. Be sure you do not round your answers until the very end of your calculations.
Using M1V1=M2V2 Make 100ml of a solution that contains 0.5mM MgCl2, 15 mM CaCl2 and 120 mM KCl 0.5M of each of these chemicals.
Volume of an unknown used was 30 mL, Initial Buret volume was 0 and the Final Buret volume was 8.5 mL. What is the molarity of the unknown solution if the Net volume of NaOH being used was 8.5 mL and Millimoles (mmoles) NaOH reacted was 0.791? Then, what is the Mass (g) of Acetic Acid in unknown sample and thr average percent (%) Acetic Acid? (assume density = 1g/mL)