VI) For the circuit shown, answer the questions from 15-19. The load Zt = 8+j6 ohms, and thesource frequency is 50 Hz. (voltage source values is given is RMS, ABET assessment #2)ーリ刺jó 2100/0° V17Z87,7loole =ーリP=18,19uFEW 50 loo80017) The capacitor current is.... A:a) j3.37e) j5.64b) -jl.33Dj1.33c)-j5.64g) 2.67 22.36°d) 2.65 Z-85.23°h) None of the abovelo L36 67

Answered: Image /qna-images/answer/672464e3-8a0a-4e56-87fc-502c6b13fc95.jpg

VI) For the circuit shown, answer the questions from 15-19. The load Zt = 8+j6 ohms, and the source frequency is 50 Hz. (voltage source values is given is RMS, ABET assessment #2) ーリ刺 jó 2 100/0° V loole = ーリ P= 8+6)-11 18,19 EW.50- loo 800 17) The capacitor current is... A: a) j3.37 e) j5.64 b) -jl.33 Dj1.33 c)-j5.64 g) 2.67 22.36° d) 2.65 -85.23° h) None of the above lo L36 62

VI) For the circuit shown, answer the questions from 15-19. The load Zt = 8+j6 ohms, and the source frequency is 50 Hz. (voltage source values is given is RMS, ABET assessment #2) ーリ刺 jó 2 100/0° V loole = ーリ P= 8+6)-11 18,19 EW.50- loo 800 17) The capacitor current is... A: a) j3.37 e) j5.64 b) -jl.33 Dj1.33 c)-j5.64 g) 2.67 22.36° d) 2.65 -85.23° h) None of the above lo L36 62

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.13P

See similar textbooks

Similar questions

The amplitude of the sinusoidal symmetrical ac component of the three-phase short-circuit current of an unloaded synchronous machine decreases from a high initial value to a lower steady-state value, going periods through the stages of __________ and ________ periods.
• Zh = 100 ohm • Draw the pu reactance diagram by taking Ut(base) = 132kV, St(base) = 100MVA. If the 33 kV busbar voltage is kept constant at 30 kV and 0.8 inductive 50 MVA power is drawn from this bus, what is the voltage at the synchronous machine ends?
A power plant comprises three turbine-generators rated 1000 MW, 800 MW and 600 MW respectively. The regulation constant of each generator is 0.05 pu based on its own rating. Each unit is initially operating at one-half of its own rating, when the system load suddenly increases by 250 MW. Calculate the following:a) Per-unit area frequency response characteristic on a 1000 MW system base [CR9]b) Steady-state drop in area frequency [CR4]c) The share of the load increase on each generator [CR9]d) Total load on each generator after the increase in system load [CR3]Assume the reference power setting of each turbine is unchanged.
An AC generator having an internal resistance of 2 ?? is connected to an LCR circuit in series as shown in the figure. If the generator supplies an electromotive force, ? = 282 ??? (100??) volt, calculate:a) the impedance of the circuitb) the rms value of the current in the circuitc) the voltage drop across L, C and R
a) How many MVAr of shunt capacitors are required to increase the power factor on a 10 MVA load from 0.85 to 0.9 lagging? b) How many MVAr of shunt capacitors are required to increase the power factor on a 10 MVA load from 0.90- to 0.95 lagging? c) Which requires more reactive power, improving a low power-factor load (case a) or a high power-factor load (case b)?
For type A chopper, dc source voltage = 250 V, load resistance = 10 Ω. Take a voltage excess of 2V across chopper when it is on. For a duty cycle of (0.004*Vs ), calculate (a) average and rms values of output voltage and (b) chopper efficiency.
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm How many times the rated current will the inrush current be when the ASM is started directly?
In the circuit given on the side Ra=Rb=Rc=Basic frequency of 13 Ohm loadsit is powered by an AC voltage of f= 60 Hz. Power derived from the sourceits value was measured as Pk=9372.12 Watts. Each switchingthe element is triggered in such a way that it will be at 180 degrees.The DC bus voltage (E=?) and the effective value of the ic phase current(ic rms=?) calculate.
A power plant comprises three turbine-generators rated 1000 MW, 800 MW and 500 MW respectively. The regulation constant of each generator is 0.05 pu based on its own rating. Each unit is initially operating at one-half of its own rating, when the system load suddenly increases by 300 MW. Calculate the following:a) Per-unit area frequency response characteristic on a 1000 MW system base.b) Steady-state drop in area frequency [CR4]c) The share of the load increase on each generator.d) Total load on each generator after the increase in system load.Assume the reference power setting of each turbine is unchanged.
Explain the importance of load flow analysis in power systems. How does it help in optimizing the operation of electrical grids?
- An 8-pole wave -wound d.c generator with output current is 200 A and has ATc/pole = 2600 AT and ATd /pole= 400 AT. Find the number of conductor.
To qualify system stability, we use: a. Routh criterion b. Phase margin c. Gain and phase margin d. Gain margin