Water on a Clean, Dry Penny Trails are given below: Trial Number of drops 1 19 2 16 3 15 4 19 5 24 Observation: The cohesion and surface tension of water became apparent when the drops of water added to the penny reached the penny's edge. Once the water had reached the edge, began to see a bubble of water forming on top of the penny until it overflowed.

Water on a Clean, Dry Penny Trails are given below: Trial Number of drops 1 19 2 16 3 15 4 19 5 24 Observation: The cohesion and surface tension of water became apparent when the drops of water added to the penny reached the penny's edge. Once the water had reached the edge, began to see a bubble of water forming on top of the penny until it overflowed.

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter14: Chromatography

Section: Chapter Questions

Problem 9P

See similar textbooks

Similar questions

PLEASE ANSWER THE FF: 1.) Systematic error causes: a) Shifts and trends on control (Levey Jennings) charts. b) Outliers on control charts. c) Random error. d) Imprecision. 2.) Select one example of the postanalytic phase: a) Specimen preparation b) Specimen analysis c) Clinician receives the test result d) Specimen collection
Why would precision not matter when you are calibrating a pipette? Background info: You are counting the number of drops of hexane that are equal to 1 millimeter.
1000 mL of 0.45% NaCl IV for 6.5 hoursDrop factor: 60 gtt/mL Flow rate: ________ gtt/min
PLEASE ANSWER THE FF: - CLINICAL CHEMISTRY 1.The main programs of the quality assurance department are: a.) Risk management, in-service and continuing education, safety programs, quality control and peer review. b.) Human resources, national laboratory week committee, and quality control documentation. c.) Diversity, red ribbon week, and health and safety education. d.) Laboratory operations, research and development. 2. Statistical methods commonly used to evaluate quality control data in the clinical lab is/are: a) T-test, z-test, and F-test. b) Numerical statistics and graphic techniques. c) Regression analysis and Pearson’s correlation coefficient d) X2 (chi-square) tests. 3. Precision of a method is best defined as: a) Agreement between replicate measurements obtained from the sample analyzed by the test method under prescribed conditions. b) Allowable bias. c) Accuracy. d.) Closeness of the agreement between the result of the measurement and a true value of the measured
0.2 to 1.0 mg/ml: For each concentration, a volume of 1.0 mL should be prepared. How will you prepare these standards using micropipettes and which one would you use? There is a: 0,5-10 microliter pipette; 2-20 microliter pipette 20-200 microliter pipette 100-1000 microliter pipette.
Table of caffeine standards concentration . Sample Conc, ppm Std1 16 Std2 32 Std3 48 Std4 64 Std5 80 If the volume used to make 100 mL of std 1 is 2 uL what is the concentration in M used to make std calibration curve ? The standards are going to be used to build calibration curve to analyze caffeine in an energy drink. if 500 mL of the energy drink has target of 400 mg , how will you prepare the sample if you need 10 mL for the analysis ? Caffeine MM=194.19 g/mol.
A physician orders isotonic sodium lactate 5 mL/kg body mass to be delivered by IV for a 164-lb patient with severe acidosis. The IV tubing delivers at the rate of 20 drops/mL and set for a flow rate of 15 drops/min. How long should the IV be set to run for this patient?
Jody, a medical assistant in a small clinic, ran out of surface disinfectant while cleaning thecounters in the clinic laboratory. The label of the disinfectant bottle she was using containedinstructions for preparing the surface disinfectant from the concentrated stock solution. Theinstructions read “Dilute the concentrate 1:50 with water.” Jody was using a disinfectant bottlewith a 500 mL capacity. 1. 1. Jody should prepare the replacement surface disinfectant by:a. Adding 1 mL of concentrate to 50 mL of waterb. Adding 10 mL of concentrate to 500 mL of waterc. Adding 10 mL of concentrate to 100 mL of waterd. Adding 10 mL of concentrate to 490 mL of water
One hundred grams (100 g) of water is mixed to 150 g of alcohol (density = 790 kg/m3). Calculate the SG of the total mixture. Please show all complete solution with units to its finals answer thank you
Please answer no. 1 and 2 in the attached image. Note: For No. 1, Sample problem 12 is also attached in the second image.
Is number 13 a true or false question and why? this is a non graded practice worksheet
Find ΔmixG, ΔmixS, and ΔmixH for mixing 100 g of benzene with 100 g of toluene at 20oC and 1 atm. Assume an ideal solution. Please answer fast i give you upvote.