We have already noted two sources of systematic error in the use of this method: not enough sample to displace all the air from the flask and the finite vapor pressure of the unknown. Consider the following possible errors. For each one, describe how the results might be impacted. Please try to be specific (e.g. “The molar mass will be overestimated because…”) The volume of your flask was found by weighing it, filled with water, at room temperature (20ºC).  At 100ºC, because of the expansion of glass, the volume is slightly greater.  How could this affect your results?

Q: Why would industry prefer to purify solids by sublimation or zone refining rather than…

A: The advantage of sublimation for purification process are i) Minimum amount of product is lost. ii)…

Q: Carbon tetrachloride melts at 250 K. The vapor pressure of the liquid is 10539 Pa at 290 K and 74518…

A: Boiling point is defined as the temperature at which the pressure exerted by the surroundings upon a…

Q: Assume the total heat of vaporization (per gram) of water can be used to supply the energy needed to…

A:

Q: 1. What is the physical significance of the flat region (plateau) on the curve? 2. Use the graph to…

A: Here we are observing cooling curve of liquid lauric acid. As liquid cools down it releases heat…

Q: 5.53 The vapor pressure of and its molar enthalpy of vap 10.5 kcal/mol. Assume the effect of a…

A:

Q: 1- Estimate the liquid density at their boiling points for 2-butanol? 2- Estimate the density of the…

A: As per rule we can only one  question , if it is short answer we can answer two questions

Q: Total partial pressure is 101.0 bar. How do I solve for the ICE table? Please help me. Thank you!

A: In ice table write concentration of each species.  Below is the example-

Q: You are tasked to obtain a solid product from your laboratory activity. To verify the identity of…

A: Intermolecular forces refer to the type of interactions which are present in between atoms or…

Q: 2. While determining the pressure during the Dumas experiment, if the barometric pressure reported…

A: GIVEN:-

Q: Is the composition of the vapor at the top of a fractionating column different from the composition…

A: The fractionating column is used in separation of mixtures into component fractions on the basis of…

Q: For a given liquid a plot of the lnP versus 1/T gives a straight line with a slope of -4606 K. What…

A:

Q: The following data was collected for n-pentane and isopentane: Compound Pv (kPa) n-pentane 282.9 at…

A:

Q: Evaluate the statement whether it is true or false: Using an Ostwald viscometer, we can also…

A: To determine the viscosity of liquids, generally we use two methods in our laboratory.  1. Oswald's…

Q: Define Solid aerosol, solid foam and solid sol

A: Solid aerosols, solid foam, and solid sol are all heterogeneous solutions and classified as…

Q: During his quest for an alternate universe, Ultron found an old amber bottle on Earth. The bottle…

A: Since you have posted a multiple question , as per our company guidelines we are supposed to answer…

Q: Based on the calculated Δ?vap values, arrange the liquid samples in order from most ordered to least…

A: The degree of randomness in a system is measured in terms of entropy. The higher the entropy greater…

Q: The vapor pressure of some unknown substance at 27.7°C is 27.46 torr. If 1.26 g of of this substance…

A: T = 27.7°C = 300.85 K  P = 27.46 torr = 0.0361 atm  V = 2.14 L  m = ?  M = 17.63 g/mol  R = 0.08206…

Q: Why is it important to maintain the rock salt/ice mixture at a temperature of -10oC? A. Because it…

A: It  is important to maintain the rock salt / ice mixture at a temperature of -10°C. This is because…

Q: Can you give four real-life applications of cooling curve and determination of the freezing point of…

A: A question based on properties of solid that is to be accomplished.

Q: In Dumas method for determination of molar mass for a volatile liquid, its vapor

A: In Dumas method , molecular mass of a volatile liquid can be determined. Here , one assumption is…

Q: Boiling point is indirectly proportional to volatility. O A. True O B. False

A: Answer Boiling point is indirectly proportional to the Volatility

Q: -1: Fill the blanks with suitable words or phrases: 1- The new properties obtained when mixing…

A:

Q: What substances should be used with caution or not in an experiment to determine the partial weight…

A: A question based on properties of liquids that is to be accomplished.

Q: 1. Calculate the numbers of moles of air trapped at 5°C. Assume the vapour pressure of water at this…

A: Solution :    Partial pressure is defined as the pressure exerted by each gas when more than one gas…

Q: Explain why the boiling point of your unknown liquid is at the point when the last little bubble…

A: The boiling point is the temperature at which the vapour pressure of the liquid is equal to the…

Q: which one will have the higher value for vapor pressure when it is in the liquid phase OF2 or XeF2

A: Given : We have to tell which among the following has high vapor pressure.

Q: In Purification by Sublimation, what improvement can suggest to increase the amount of crystals that…

A: Sublimation refers to when a substance in a solid-state and changes into vapours without going into…

Q: The normal composition for this foliar spray is 128 grams of calcium nitrate at 94.64v liters of…

A: Here we have to determine the change in vapour pressure of solution when 128 g Ca(NO3)2 is added to…

Q: Research on the process of desalination with the use of distillation. Write how vapor-pressure…

A: Desalination is a process that takes away mineral components from saline water. More generally,…

Q: Question 4 Calculate the change in freezing point of water , with ethalpy of fusion = 6.009 kJ/mole)…

A: In this question, we have to Calculate the change in freezing point of water , with ethalpy of…

Q: 4. Calculate the molar mass of vaporized unknown using the following data: mass of vapor = 0.643 g,…

A:

Q: During his quest for an alternate universe, Ultron found an old amber bottle on Earth. The bottle…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Create your scale on the x and y axes. Estimate the boiling point of the mixture which is composed…

A: Since no temperature range is mentioned in the given diagram hence boiling point can not be…

Q: suppose your flask was heated for several minutes after all the unknown liquid had been vaporized.…

A: A question based on analytical process that is to be accomplished.

Q: . Twenty-five pounds of propane are held in a sealed container at 350 psia. The volume of the…

A:

Q: How does the melt temperature of the main phase affect diffusion?

A: The entropy of fusion and the melting temperature have a governing influence on the self-diffusion…

Q: Which of the following molecules in the pure (bulk) liquid state show dispersion and dipole-dipole

A: The HCl being a polar molecule has the only predominant intermolecular force it has is Dipole-Dipole…

Q: A piece of metal weighing 0.713 g was placed in an eudiometer containing aqueous HCI. After the…

A: The water vapor pressure at the given temperature is fixed and it is equal to 23.79 mmHg at 25…

Q: It is preferable to use the conical beaker for the crystallization process

A: Beakers (cylindrical) have a very wide surface area, which allows hot liquids to evaporate more…

Q: During the solution process,  there are four different interacting forces involved: Hydrogen…

A:

Q: how do we find the average of the molar mass of these unkown liquid? how to express the water bath…

A: Given equation,      MM = d × R × TP

Q: An ideal property of a solvent to be suitable for recrystallization of a solid sample is: Group of…

A: In recrystallization process an impure solid compound is dissolved (the impurities must also be…

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.