What is the bond angle of ICl4-

Q: A vessel contains 0.4 moles of H2, 2.0 moles of N2, and 1.7 moles of F2. What are the mole fraction ...

A: The mole fraction of the gases are 0.0976 (H2), 0.4878 (N2), 0.4146 (F2).

Q: 4. The reaction 2NO (g) + 2H2 (g) N2 (g) + 2H;O (g) is found experimentally to be second order in NO...

A:   Since you have posted a question with multiple subparts, we will solve first three subparts for yo...

Q: 5. The magnetic flux through one turn of a 55-turn coil of wire is reduced from 29 Wb to 5.0 Wb in 0...

A: Given, N = 55 Φi = 5 Wb  Φf = 29 Wb  ∆Φ = (29-5) = 24 Wb  t = 0.80 s  I = 36000 mA = 36 A  1 A = 100...

Q: Annotate the IR spectrum by labelling each of the major peaks as a functional group. Does this IR sp...

A: IR spectral analysis:

Q: In the compound below, which specific atom is most likely to get attacked by nucleophiles? Use the n...

A: Nucleophiles are electron rich compounds.

Q: 2. Salt-in effect implies that solubility: a. Remains constant with increase in ionic strength b. In...

A:

Q: tert-butyl chloride (2-chloro-2-methylpropane) from tert- butyl alcohol (tert-butanol) using an acid...

A:

Q: Develop a general equation for the standard heat of reaction as a function of temperature for one of...

A: The general equation for the standard heat of reaction as a function of temperature is given by   ∆H...

Q: What is the molar absorptivity of cobalt at λmax of cobalt?

A: The data given is,

Q: 250. mg of an unknown protein are dissolved in enough solvent to make 5.00 mL of solution. The osmot...

A:

Q: 2NO(g) +O2(g) →  2NO(g) The following kinetic data were obtained for the initial rates of disappear...

A:

Q: how many grams of barium hydroxide will be used up in the reaction with hydrochloric acid to produce...

A: Mole can be defined as a scientific unit for measuring large quantities of very small entities such ...

Q: why is the synthesis of NH4BF4 conducted under acidic conditions?

A: The synthesis of NH4BF4 conducted under acidic conditions as follows,

Q: Why is the yield lower than calculated?

A: The experimental yield of any reaction usually found to be lower than that of the true calculated yi...

Q: A gaseous product has a mass of 2.34g and occupies a volume of 0.854 L.The temperature in the labora...

A:

Q: Latimer diagrams for oxygen and iron under standard conditions are shown below. (a) Write down two ...

A: Given ,  Latimer diagram  O2   → +0.68 V   H2O2 →+1.78 V     H2O

Q: Calculate the mass and volume (mL) of 5.0 mmol triethylsilane Mw: 116.28 g/mol Density: 0.728 g/mL

A: Given :-  moles of triethylsilane = 5.0 mmol  Molecular weight = 116.28 g/mol Density= 0.728 g/mL   ...

Q: Flame test is an example of whatb type of atomic spectroscopy?     Emmsion     Absorption     ...

A:

Q: Module 4 Homework Intermolecular Forces: 1. What are the intermolecular interactions between ammonia...

A: Intermolecular forces are the force of attraction that held between two atom. Types of intermolecula...

Q: The rate of a certain reaction is given by the following rate law: rate =k[N,[H,° Use this informati...

A:

Q: Solve the standard entalphies of the following and determine wether the reaction is endothermic or e...

A: 2NH3(g) + 3N2O(g) -----> 4N2(g) + 3H2O(l) CaCO3(s) -------> CaO(s) + CO2(g)  C(graphite) + O2(...

Q: 1. Consider the following reaction: CO:(g) + CCl (g) → 2COCL(g) a. Calculate the standard Gibbs free...

A:

Q: Calculate the volume (in mL) of a 1.205M stock NaOH solution needed to prepare 250.0 mL of a 0.1157M...

A:

Q: Based on the given data, what is the Àmax of copp 0.1 M Copper 300 0.157 325 0.233 350 0.465 375 0.5...

A: Given : We have to tell lambda max for 0.1 M copper.

Q: minor  product for 2-butanol and HCl ?

A:   When alcohol is treated with HCl it gives alkyl chloride  Carbocation intermediate is formed in t...

Q: While not true in general, many aqueous reactions approximately double their rate for an increase in...

A: Given, If a reaction performed at 300K doubles its rate when the temperature is increased to 310K, i...

Q: What is the molar absorptivity of copper at λmax of copper?

A: The data given is,  

Q: What is the product of the following reaction?

A:

Q: lain what is meant by the term 'resolution' in the above statement?

A:

Q: What is the molar absorptivity of copper at λmax of cobalt?

A: The data given is,

Q: A radio station's channel, such as 100.7 FM or 92.3 FM, is actually its frequency in megahertz (MHz)...

A:

Q: concentration, mM Amax cobalt|^max copper 20.00 0.177 0.238 40.00 60.00 0.382 0.518 0.487 0.731 80.0...

A: Given : We have to calculate molar absorptivity of copper at lambda max cobalt.

Q: Ehylene oxide, C2H4O, decomposes when heated to give methane and carbon monoxide.   C2H4O(g)  →  C...

A: Given , reaction : C2H4O(g) → CH4(g) +CO(g) Temperature , T = 688 k

Q: Yield [g and %] Compound Name (2-2-(3,4- dmethontenadidepe- 23 Structure dihydro-1Hinden-1.one Formu...

A:      

Q: How to calculate the mass of 2.7 x 1024 molecules of sugar C12H22O11?

A: Molar mass of C12H22O11 = ( 12 ×12) + (22×1) + (11×16)                                           = 3...

Q: Below, write the balanced chemical equation for the reaction you observed (including state). If a p...

A:

Q: Multiple Choice: 1. The name of the compound PCI5 is A. Phosphoric chloride B. Phosphorous penta chl...

A: The binary compounds are those in which only two elements are present. The correct answer are given ...

Q: Multiple hoice: 1. The correct coefficient for the equation KCLO3 --> KCL +02 A. 2,2,3 B. 2,3,2 C. 3...

A: Q1. Option A; (2,2,3). Q2. Option A; (2,1,1,2).

Q: Why are there multiple products produced from the halogenation of alkanes via ultraviolet light?

A: Given that : We have to determine the reason why multiple products produced from the halogenation of...

Q: II. Analysis. Given below is a schematic diagram for a simple analysis of a novel tetrasaccharide is...

A: D- fructose.  B- glucose . C - galactose . As A gives Benedict's test: (+) Seliwanoff's test: (-) Bi...

Q: calculate the average end-to-end distance for the ideal chain?

A: Given Data: Number of C-C bond present in the polymer chain, N = 250000                       Bond l...

Q: Which of the following is considered as IR active?     Symmetric Molecule     Assymetric molecul...

A:

Q: how many hydrogen atoms are in 0.1488 of g phosphoric acid

A:

Q: QUESTION 25 Which is true regarding the C-F bond in the compound shown below C-H :F : O it is ionic ...

A:

Q: 1) Write the general rate law equation for the reaction Acetone (C,H,0(a) + Haa) + lodine (1z(aq)) C...

A: Since you have posted multiple questions, we are entitled to answer the first only. 1) The reaction ...

Q: The equilibrium constant, K, for the following reaction is 4.68x10-2 at 536 K. PCI5(g) PCI3(g) + Cl2...

A: We have been given equilibrium constant value along with equilibrium concentration at a particular v...

Q: Under what conditions is the volume of one mole of a gas equal to 22.4 L? What do you call this volu...

A: Under what conditions, volume of one mole of a gas is equal to 22.4 L ?  What do you call this volum...

Q: An ē at its excited state is stable unti it  return  to its ground state. If an ē jumped more than o...

A: An electron jumps from a lower energy level to a higher energy level by absorbing some energy. More ...

Q: A sunywcc.sln.suny.edu compounds on Page 61 of the lab Manual in the list beginning with CO and endi...

A:

Q: Develop a general equation for the standard heat of reaction as a function of temperature for one of...

A: