What is the current through the diode? 1 N 2 IDEAL_DIODE R1 12 kn 12 V

Q: Find the equivalent resistance between terminals a and b R3 a 30 k. R2 R5 ' 90 kΩ 50 kſ. 75 45 kN b ...

A:

Q: How does the amount of leaking electricity consumption compare with the total amount of electricity ...

A: The leakage of electricity affects the electrical power consumption to very large extent and hence i...

Q: Compute for Vout and show complete solution

A: In this question,  Find the voltage Vo  Assume forward bias voltage across Ge = 0.3V And for si type...

Q: volume charge in a form of a cube, 2m on an edge, parallel to the axes and centered at the origin is...

A: We need to find charge enclosed by given surface .

Q: In a superheterodyne receiver, the incoming RF signal is at 25 dBµ, the RF amplifier has a 30 dB gai...

A:

Q: 10. Determine I. + - 21 12V 203 V 6A

A:

Q: A solar cell with an area of 4 cm^2 has the IV characteristics under the illumination of 600 Wm^-2 s...

A: GIVEN: load=5Ω              area=4cm2 FIND: (a)power delivered            (b)efficiency

Q: The silicon transistor in Fixed bias configuration Rb= 360k, Rc= 2k, Vcc = 10V has values of hFE 100...

A: Given that Vcc=10vhFE=β=100RB=360kRC=2kT=250C

Q: For the given circuit, what is the angle by which I leads V? 10a 5V 100UF 60HZ

A:

Q: Two alternators are operating in parallel supplying a common load of 4250 kW at 0.85 power factor la...

A:

Q: In Example 1.1, the relative permeability of the core material for the magnetic circuit of Fig. 1.2 ...

A:

Q: a) A 400 kVA transformer has a primary winding resistance of 0.5 Q and a secondary winding resistanc...

A:

Q: QI\ An ohmmeter has a moving coil of resistance 24 2 with 4mA full scale deflection current. The vol...

A:

Q: Calculate the current through the ammeter. 2.0 A 2.0 A R, 2.0 Ą R3 5.0 A Select one: а. 1.0 A b. 2.0...

A: Given circuit,

Q: Find : a) RT = ? RiB 22 5-2 322 Rを A-2 R23 tw AAA MA R24 Ris- Ri7 = 32 = 42 Rig- Rzo= R21 R24 = 52 %...

A:

Q: What is the difference between an Insulator and a Dielectric?

A: Insulator- Insulator is a substance that provides tremendous amount of resistance towards the passag...

Q: 4. Calculate the potential difference of an energy source that provides 6.8 J for every milli-coulom...

A: 4) Potential difference V= workdone(W)/charge(Q) V= 6.8/0.001 = 6.8KV 3)work done = V*I*t J Time t=1...

Q: H.W 5: Evaluate the steady-state error for the system described by the following equation for unit s...

A: SOLUTION- Transfer function (T(S)) = C(SI-A)-1B FIRST CALCULATE (SI-A)-1 SI-A =   s000s000s--5100-21...

Q: 1. A long, straight, cylindrical copper wire with radius a carries a constant current I. Consider a ...

A:

Q: D1 1 V1 R1 15V 2502 3

A:

Q: 2 the Tx 2 3

A:

Q: 2. Generating station at Musandam has the following load cycle. (Refer the data sheet below). Determ...

A: In this question,  We need to determine the maximum load,  Unit generated by per day We know 1kWH= 1...

Q: a) Answer all question 1. The diffraction process allows reception beyond a mountain in all but a sm...

A:

Q: Find out the Laplace Transform of the following function: z(1) = e s, z(1) = e $'u(t) -551 n.

A:

Q: A 0.05 S B 0.02 S 0.2 AT 0.01 S 0.5 A

A:

Q: Can I use the Manual Motor Starter on a single phase motor? Why?

A: MANUAL MOTOR STARTER Manual motor starters are devices that use manual or automatic switches to star...

Q: use nodal analysis to find Ix

A: The given circuit is shown below:

Q: Simplify 24 + B+3C – {A – 2B – 2(2A – 3B – C)} Select the correct response: 5A - 3B + C -5A+ 3B - C ...

A:

Q: R1 9V 3Ω R3 10 +1

A:

Q: Find the value of the resistance R and inductance L which when connected in parallel will take the s...

A: In this question,  A resistance R1  and L1  are connected in series. If they will be connected in pa...

Q: 3-phase, 220-v, 50-hz, 1500 r.p.m., mesh-connected synchronous motor has a synchronous impedance of ...

A: It is given that: Motor is mesh or △ connected. VL=220 Vf=50 HzN=1500 rpmZs=4 ΩIL=30 Acosϕ=0.8    

Q: Calculate the equivalent impedance, with respect to the supply terminals of the circuit with the dia...

A:

Q: A 120 V electrical outlet with 4 A of current flowing from it has a power value of O 480 W O 48 W 24...

A:

Q: 27. Referring to problem 26, if the 15 V battery is replaced by a short-circuit, the equivalent resi...

A: 27. Last option is correct. The detailed solution is provided below.   As per our guidelines we are ...

Q: 36. Sketch ig and v, for the network of Fig. 2.180 for the input shown. 10 k2 10 V iR Si Si Vi 5.3 V...

A: In this question,  Sketch the current iR  and voltage Vo for the network  Input waveform is shown  A...

Q: Design a clamper circuit that biases the AC waveform so it lies completely below the zero line.

A: Given circuit has output which is clamped  It needs a capacitor and diode  This is called negative c...

Q: V1 R1 10V D1 Vc 1kHz 2.5k2 0° 3

A:

Q: 2-The function of the impact sign given in the s(t) = rect(t/7) find the power spectral density of t...

A: Given function st=rectT  

Q: 8. How much electrical energy in kWh is consumed in operating ten 50 W bulbs for 10 hours in a day i...

A:

Q: а. j -119

A:

Q: Calculate the total impedance (Zin) in the circuit shown below. Assume the given frequency is 50 Hz ...

A: Assume  f= 50Hz

Q: +9V 1 MN Q2 1 MN () 50 μΑ ) Rin 5 mA

A: GIVEN:                R1=1MΩR2=1MΩβ1=50β2=100VBE=0.7V FIND: transmission of the base of Q1 and vb1/v...

Q: A series RLC is connected to an AC source. The effective voltages across the circuit components are ...

A: This question belongs to circuit theory . It is based on concept of voltage drop across series RLC c...

Q: Find out the Laplace Transform of the following function: z(1) = e'u(1) -551 n.

A: In this case, the Laplace transform of the following function is to be determined: zt=e-55tut

Q: Pulse Amplitude Modulation, Pulse Position Modulation and Pulse Width Modulation are three methods o...

A: PWM The width of the pulse is varied depending on amplitude of Unmodulated signal.   PPM The positio...

Q: A uniform sheet charge, infinite in extent, is located at x=2 m. Given that the charge density is 5 ...

A: charge density =  5 nC/m^2 at x= 2 E at origin = ?

Q: Let P be the solution of the Lyapunov equation ATP+ PA = -Q, where A, P,Q E R"X". Show that if = P" ...

A: GIVEN: Lyapunov equation              ATP+PA=-Q SHOW: all eigenvalues of A have negative real parts

Q: Q1\ An ohmmeter has a moving coil of resistance 25 2 with 5mA full scale deflection current. The vol...

A:

Q: Assume an annual available energy of 1200 Kwh/m2. The system rating peak is 50 Kw. The annual energy...

A: Given: Assume annual available energy of 1200 Kwh/m2. The system rating peak is 50 kW. The annual en...

Q: Prob#10 Find I. by nodal analysis.

A: Circuit with defined nodes is shown below

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.