What is the decreasing order of reactivity among the following compounds ? IV OIV > II > II > I O III > IV > I| > I OIV > III > I> || O III > IV > 1> I O IV > I| > III > I

Q: Which of the following has the highest vapor pressure at room temperature and 1 atm pressure? CHF3,…

A: Vapor Pressure is a measure of tendency of a compound to change its form into gaseous state. Vapor…

Q: An archeological sample was predicted to be 9,415 years old. If the C-14 measured at present in the…

A:

Q: One gram of sodium hydroxide pellets is dissolved in two hundred-fifty milliliters water. What is…

A:

Q: What is the ΔH of the reaction 2KS+2K→2K2S? K+S→KS ΔH=+32.5 kJ KS+K→K2S ΔH=+38.2 kJ A +70.7 kJ B…

A: In this question we have to calculate delta H value of the given reaction.

Q: 7. 2 SO3(g) 2 SO2(g) + O2(g) : Кр3 16.5; Pso3 = 0.45 atm; Pso2 = 1.52 atm; Po2 = 0.210 atm || 8. 2…

A:

Q: if 0.030 mole of HCl is added to 0.50 L of the buffer solution (0.24M NH3 and 0.20M NH4Cl) What is…

A:

Q: A gas has a temperature of 10.0 degrees Celsius and a volume of 1.00 Liter. What would the volume be…

A: We have to predict the volume of the gas.

Q: Which of the following is not an expected product of the following reaction ? HBr all of the above…

A: A multiple choice question based on introduction to organic chemistry.

Q: How much energy is required to change the temperature of 15.0 g Fe from 18.5oC to 56.8oC? The…

A:

Q: Provide the correct IUPAC name for the compound shown here.

A: At 1,3,5 position methyl group is present

Q: You are tasked to prepare a 0.5 L of HCl solution with a concentration of 0.04 M. How will you do…

A: Given that -  % HCl Solution = 35%  Volume of new HCl Solution = 0.5 L = 500 mL (V2) Molarity of new…

Q: gमक ठ९१०छ्लम्ख्च र्रल a+.त्मेंन वत्टवणणकদट amode ņ वोक zmes) | zmzt caq) ll Nizt car) Nics) Nirs) -…

A: In this question, we have to write the half reaction occuring at anode for the given galvanic cell…

Q: ulate the pH of a solution prepared by dissolving 1.90 g of sodium acetate, CH,COONA, in 85.0 ml of…

A: Given, Mass of Sodium Acetate = 1.90 g Moles of Sodium Acetate = 1.90/82         = 0.0232 mol Moles…

Q: Identify the conjugate acid of SO 4 2–.

A: In this question we have tell the conjugate acid of the given SO42-

Q: Which of the following is expected to show aromaticity? CH CH HC CH NH O none of the above is…

A:

Q: 1. Write an equation for the preparation of each of the following compounds   a)…

A:

Q: From benzene and thiophene, synthesize the compound below

A:

Q: 1.Determine the number of lone pairs (if any) on each oxygen, nitrogen, and charged carbon atoms in…

A: Lone pair of electrons on an atom are the electrons that are unshared pair of electrons present on…

Q: What is the solubility of argon (in units of grams per liter) in water at 25 °C, when the Ar gas…

A:

Q: 1. Classification of hepatoprotectors, examples of drugs.

A:

Q: 7. Explain the would-be effects (if any) of the following considerations: a. Water sample was made…

A: BOD determination can be done with help of the Winkler method. As we all know that dissolved oxygen…

Q: Calculate the binding energy per nucleon for the argon-36 nucleus, whose mass is 35.967545 u. The…

A:

Q: Acetylsalicylic acid is the primary ingredient in aspirin. It can be made by reacting salicylic acid…

A:

Q: Which of the following aqueous solutions are good buffer systems? U0.36 M barium iodide + 0.29 M…

A: Buffer solution are those which resist any significant change in pH if any strong acid or base is…

Q: you have a bottle of compound X at a pressure of 45atm and temperature of 100 C, what will happen if…

A: The answer is as follows:

Q: Out of these choices, which ones are conjugate acid-base pairs?

A: Bronsted-Lowry acid-base theory: The Bronsted-Lowry acid-base theory states that the acid is a…

Q: The oxidation of nitrogen oxide produces nitrogen dioxide, as shown below: 2NO (g) + O2 (g) → 2NO2…

A:

Q: During which segments could heat of fusion be determined? 2.During which segments could heat of…

A: During the phase change there is no change in temperature because all the heat is absorbed in…

Q: Give 8 applications and or uses of radioactive substances. Make a short description of each.

A: 8 application and or uses of radioactive substances :-  i) They are used as a fuel in nuclear…

Q: give the structure of phenol plz asap 8:27 am /

A:

Q: Calculate the cell potential for the galvanic cell in which the reaction Ti(s) + Co2+(aq) = Ti²+(aq)…

A:

Q: A student ran the following reaction in the laboratory at 658 K: 2 NH3 (g) N2 (g) + 3 H2 () When she…

A:

Q: Which one of the followin shoul have the hiest boiling point? PH3   H2S  HCL    SiH4   H2O

A: Given substances are :  a). PH3  b). H2S  c). HCl  d). SiH4  e). H2O  Which one of the following…

Q: Which solution will have the lowest pH?     0.25 M HClO     0.25 M NaClO 4     0.25 M HClO 4…

A:

Q: Determine the molar mass of an unknown compound if the solution formed when 3.28 g of the compound…

A:

Q: Which of the following is not shown on an energy reaction coordinate diagram? O The energy released…

A:

Q: t is desired to prepare cupric sulfate solution by dissolving 250 grams of cupric sulfate in enough…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: What is the pH of a solution prepared by mixing 50.0 mL of 0.300 M HCl with 450.0 mL of 0.400 M HIO…

A:

Q: i) k) O0-I

A:

Q: Compare the two reactions A and B shown below. Check all the statements that are TRUE regarding the…

A:

Q: How many joules are required to boil 200 grams of water?   350 000 J   452 000 J   500 000 J…

A:

Q: What is the molarity of a solution of calcium chloride which contains 33500 mg of solute in a total…

A: Molarity is calculated using formula : Molarity = Moles of soluteVolume of solution (L)   Note : As…

Q: Consider the titration of a weak monoprotic acid with a strong base. The titration starts with 80mL…

A:

Q: 80 CO AS = ΔΗ ||

A: Entropy is degree of randomness or disorderness in system.  Order of Entropy of different phases…

Q: problem

A:

Q: What is the specific rotation of pure (S)-carvone if a sample of (R)-carvone of 78% ee has a…

A:

Q: 0.0050 mole of  NaOH is added  to 0.50L of the buffer solution 0.24 M NH3 and 0.20 M NH4Cl) what is…

A:

Q: 2 NOg) + Br,(g) INOBr,(M) Initial rate of formation of Br, (M/s) 2 NOBr(g) 0.600 0.828 x 10 0.750…

A: The rate of a reaction is proportional to some power of the molar concentration of each of the…

Q: Which best describes the role of enzymes in a chemical reaction? A. They lower the activation energy…

A: Given statement is : Which best describes the role of enzymes in a chemical reaction? Options are :…

Q: 18 Draw the structures of compounds A through D below: TMS-CI 1. MgBr TBAF HO. D. AICI Et N 2 H,O

A: In this question we have to tell the product of the reaction sequence.

Polymerization Kinetics

Polymerization is a chemical process in which one or more monomers combine to produce a very large chain-like molecule called a polymer. The functional groups present on the monomers and their steric effects are responsible for polymerization through a sequence of reactions that diverge in complexity. There exists a stable covalent chemical bond between monomers that sets apart polymerization from other processes. Polymerization is generally classified into step-growth and chain polymerization. Polymers are categorized into linear polymer and cross-linked polymers that are produced either by condensation or additional polymerization.