Answered: What is the horizontal component of the…

Science

Physics

What is the horizontal component of the force F that the wall exerts on the plank? O 1900 N O −1100 N O1400 N O-3600 N

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 6STP

See similar textbooks

Related questions

Q: QUESTION 8 A sled is being pulled by a force with a magnitude of "F" directed along the positive…

Q: Assume that a square loop of wire lies in the plane of the page. Now let assume that a decreasing…

A: According to Lenz's law, if there is a change in flux then emf will induce in such a way that it…

Q: 4. A particle starts from the origin at t=0 with a velocity of (161 - 12j) m/s and moves in the xy…

Q: A block, initialy at rest, of mass 20 kg starts from point A, where H = 28m, find the velocity on…

A: Apply the energy conservation equation between points A and B.

Q: Let's say the launch speed is constant, but you can adjust the launch angle, and again we will deal…

Q: 2. A heat pump cycle whose coefficient of performance is 2.5 delivers energy by heat transfer to a…

A: As per given, The coefficient of performance = 2.5 Energy delivered by heat pump = 20kW a) Net power…

Q: .. Using Ampere's law derive an expression for the magnetic field due to a long, hollow cylindrical…

Q: A flat circular coil with 130 turns, a radius of 4.99 x 10-2 m, and a resistance of 0.544 2 is…

Q: "A circuit with parallel connected resistors of 2 ohms, 5 ohms, 10 ohms and 15 ohms. On which…

A: Given: The resistors 2 Ω, 5 Ω, 10 Ω and 15 Ω are connected in parallel.

Q: A cow (of mass 750 kg) is caught in an alien spaceship's attractor beam. The beam applies an upward…

A: Given data: Mass (m) = 750 kg Upward force (F) = 8000 N Required: The net acceleration in vertical…

Q: A force of 20 N moves an object in the direction of the force. The work done when the object moves…

Q: A block weighing 100N shown at A is subjected to a horizontal force P = 100N. If the velocity of the…

A: Given, u = 10 m/s P = 100 N So a = F/m = 100x9.81/100 = 9.81 m/s^2 From Newtown's third equation…

Q: Marie passes red light of wavelength 685 nm through a diffraction grating of 829 lines/cm. If the…

A: Determine the width of the line spacing.

Q: force of 20 N moves an object in the direction of the force. The work done when the object moves…

Q: The uniform electric field between two parallel plates of opposite and separate loads of 40 mm has…

Q: "for the circuit below, Voltmeters connected across terminals 4 - 8 and 9 - 13 should yield the same…

Q: 4. A uniform line charge density of 5 nC/m is at y = 0, z = 2 m in free space, while -5 nC/m is…

Q: "for the circuit below, the sum of VR1 + VR2 + VR3 is equal to the sum of VR1 + VR4 + VR5" 4 5 6 7…

Q: You are dragging a toy tractor across a horizontal floor, using a horizontal force. You observe that…

A: Given: The applied force is 81 N. The mass of the toy is 11.09 kg. The toy is moving with constant…

Q: "For the circuit below, for the total voltage of the system, the voltmeter should be connected at…

A: The total voltage of the system includes all the potential of the resistors. Therefore, the…

Q: Your friend tells you that the time-dependence of their car's acceleration along a road is given by…

A: Given:- The time-dependence of their car's acceleration along a road is given by a(t) = γt2+γt here…

Q: A 13 g bullet pierces a sand bag 32 cm thick. If the initial velocity of the bullet was 68 m/s and…

A: Answer:- Given The mass of the bullet(m) = 13 g = 0.013 kg The thickness of the sandbag(x)= 32 cm…

Q: the second law of thermodynamics to explain why an automobile engine requires a cooling system to…

Q: 6. (14.21) A 0.095-kg aluminium sphere is dropped from the roof of a 55-m-high building. If 65% of…

Q: D A C Determine which side of the magnet represents its north pole and which side represents its…

A: To determine : Which side of the magnet represents a north pole and which side of the magnet…

Q: stone weighing 100N is thrown vertically upward with a velocity of 39.2 m/s. Find its A.)Potential…

Q: Cristian determines that the spacing between the planes of a crystalline material is 2.46x10-10 m.…

A: Given that Spacing between the planes of crystal matarial(d)=2.46×10^-10 m Angle(θ)=15.20o first…

Q: 2. The 12 kg disk with a radius of 650 mm is rolling while slipping under the constant force of 210…

Q: 9. When a 40V battery is connected across an unknown resistor there is a current of 100 mA in the…

Q: If the momentum of a car is 80 kg m/s and it's mass is 20 kg . Find the velocity?

A: Given data : Momentum of the car (P) = 80 kg.m/s Mass of the car (m) = 20 kg

Q: 1. Which of the following wave characteristics is the same for any electromagnetic wave traveling…

A: Answer:- Answer (1) :- (c) speed Speed is the same for any electro magnetic waves travelling…

Q: A boy is pulling his sister in a wagon , as shown in the figure . He exerts a force of F = 47N at an…

A: Given Force applied = F = 47 N angle above the horizontal= 30° displacement travel = 31.5 m We have…

Q: A Toyota Corolla Cross rear view mirror shows an image of a Ford Ranger located 10.0m from the…

Q: A cylinder is completely filled with water. The top of the cylinder is sealed with a tight-fitting…

Q: Adam, an airport employee, is working near a jet plane taking off. He experiences a sound level of…

Q: Given data: Velocity 6 m/s Mass = 12.5 kg Calculate kinetic energy?

A: Given data: Velocity (v) = 6 m/s Mass (m) = 12.5 kg Required: Kinetic Energy (KE)

Q: Voltage divider theorem is used for obtaining the of resistors connected in___ A) "voltage,…

A: According to Voltage divider theorem " Voltage divider is a basic circuit, used to generate a part…

Q: A gas undergoes a cycle in a piston-cylinder assembly consisting of the following three processes:…

Q: 5. A circular coil of N turns, each of area A is rotated at an angular frequency in magnetic field…

A: The formula of flux for a loop is ϕ =B→.A→ Where B is magnetic field and A is area vector. Induced…

Q: A submarine is moving toward another submarine at 9.2 m/s. it emits a 3.5 MHz ultrasound. What…

A: Doppler effect: Due to relative motion of source and observer frequency heard by the observer is…

Q: You are going to throw a ball upward at an angle of 25.02 degrees. If you can throw it with an…

Q: Two people on bikes are separated by 350 meters. Person A starts riding north at a rate of 5 m/sec…

Q: What is the voltage across C2? C₁ = 12 µF C3 = 6 µF HH What is the voltage across C3? * C₁ = 12 µF…

Q: The 12 kg disk with a radius of 650 mm is rolling while slipping under the constant force of 210 N…

A: Given:Disk mass, m=12 kgdisk radius, r=650 mm or 0.65 mconstant force, F=210 Nradius of gyration,…

Q: QUESTION 5 A mountain climber (of mass 70 kg) is using their ice picks to climb a mountain that has…

Q: A dog (of mass 50 kg) is happily sliding down a hill that has a coefficient of kinetic friction of…

Q: Ammabel passes red light of wavelength 729 nm through a diffraction grating of 959 lines/cm. If the…

Q: Find work done F=12 N 1df-5m-

Q: Given data: Density = 386 kg / m3 Mass = 44 kg

A: We know density = mass / volume

Q: (15.5) A 1.0-L volume of air initially at 4.5 atm of pressure is allowed to expand isothermally…

A: The given questions are different. So, as per our guidelines we will solve first question for you.…

Concept explainers

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.

Question

What is the horizontal component of the force F that the wall exerts
on the plank?
Q 1900 N
O −1100 N
O1400 N
O −3600 N

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 20.0-kg horizontal plank 4.00 in long rests on two supports, one at the left end and a second 1.00 m from the right end. What is the magnitude of the force exerted on the plank by the support near the right end? (a) 32.0 N (b) 45.2 N (c) 112 N (d) 131 N (e) 98.2 N
A One end of a metal rod of weight Fg and length L presses against a corner between a wall and the floor (Fig. P14.64). A rope is attached to the other end of the rod. Find the magnitude of the tension in the rope if the angle between the rod and the rope is 90.
A certain orthodontist uses a wire brace to align a patients crooked tooth as in Figure P5.4. The tension in the wire is adjusted to have a magnitude of 18.0 N. Find the magnitude of the net force exerted by the wire on the crooked tooth.
An object is being weighed using an unequal-arm balance (Fig. P14.76). When the object is in the left pan, a downward force of 3.0 N must be exerted on the right pan to balance the gravitational force on the object. When the object is in the right pan, a downward force of 2.0 N must be exerted on the left pan to balance the gravitational force on the object. Determine the magnitude of the gravitational force on the object. FIGURE P14.76
The Iron Cross When a gymnast weighing 750 N executes the iron cross as in Figure lN.91a, the primary muscles involved in supporting this position are the latissimus dorsi (lats") and the pectoralis major (pecs"). The rings exert an upward force on the aims and support the weight of the gymnast. The force exerted by the shoulder joint on the arm is labeled Fs, while the two muscles exert a total force Fw on the arm. Estimate the magnitude of the force Fw. Note that one ring supports half the weight of the gymnast, which is 375 N as indicated in Figure P8.91b. Assume that the force Fw acts at an angle of 45 below the horizontal at a distance of 4.0 cm from the shoulder joint In your estimate, take the distance from the shoulder joint to the hand to be L = 70 cm and ignore the weight of the arm.
Two identical strings making an angle of = 30.0 with respect to the vertical support a block of mass m = 15.0 kg (Fig. P4.32). What is the tension in each of the strings?
A brass wire and a steel wire, both of the same length, are extended by 1.0 mm under the same force. Is the cross-sectional radius of the brass wire more, less, or equal to the cross-sectional radius of the steel wire? Explain. Youngs moduli for brass and steel are 1.0 1010 N/m2 and 2.0 1011 N/m2, respectively.
A painter of mass 87.8 kg is 1.45 m from the top of a 6.67-m ladder. The ladder rests against a wall. Friction between the ladder and the wall is negligible. The ladders mass is 5.50 kg. Assume the ladder is set up according to Occupational Safety and Health Administration standards so that it makes a 75.5 angle with the floor. a. What is the minimum coefficient of static friction required for the painters safety? b. Would rubber ladder tips on dry concrete be safe?
A massless, horizontal beam of length L and a massless rope support a sign of mass m (Fig. P14.78). a. What is the tension in the rope? b. In terms of m, g, d, L, and , what are the components of the force exerted by the beam on the wall? FIGURE P14.78
The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91
A flexible chain weighing 40.0 N hangs between two hooks located at the same height (Fig. P12.9). At each hook, the tangent to the chain makes an angle = 42.0 with the horizontal. Find (a) the magnitude of the force each hook exerts on the chain and (b) the tension in the chain at its midpoint. Suggestion: For part (b), make a force diagram for half of the chain. Figure P12.9
You have been hired as an expert witness in a case involving an injury in a factory. The attorney who hired you represents the injured worker. The worker was told to lift one end of a long, heavy crate that was lying horizontally on the floor and tilt it up so that it is standing on end. He began lifting the end of the crate, always applying a force that was perpendicular to the top of the crate. As the end of the crate got higher, at a certain angle, the bottom of the crate slipped on the floor, and the worker, in trying to recover, stepped forward and the crate landed on his foot, injuring it badly. As part of your investigation, you go to the factory and measure the coefficient of static friction between a crate and the smooth concrete floor. You find it to be 0.340. Prepare an argument for the attorney showing that it was impossible to lift the crate in the manner described without it slipping on the floor.