A 46.0-cm-diameter circular loop is rotated in a uniform electric field until the position of maximum electric flux is found. The flux in this position ismeasured to be 5.92 x 105 N • m2/C. What is the magnitude of the electric field?MN/C

Given, Diameter of loop, d=46.0 cm=0.46m Maximum flux, Φ=5.92×105Nm2/C

Answered: What is the magnitude of the electric…

Science

Physics

What is the magnitude of the electric field?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter19: Electric Forces And Electric Fields

Section: Chapter Questions

Problem 37P

See similar textbooks

Similar questions

Figure P15.49 shows a closed cylinder with cross-sectional area A = 2.00 m2. The constant electric field E has magnitude 3.50 103 N/C and is directed vertically upward, perpendicular to the cylinder's top and bottom surfaces so that no field lines paw through the curved surface. Calculate the electric flux through the cylinder's (a) lop and (b) bottom surface, (c) Determine the amount of charge inside the cylinder. Figure P15.49
Figure P15.49 shows a closed cylinder with cross-sectional area A = 2.00 m2. The constant electric field E has magnitude 3.50 103 N/C and is directed vertically upward, perpendicular to the cylinder's top and bottom surfaces so that no field lines paw through the curved surface. Calculate the electric flux through the cylinder's (a) lop and (b) bottom surface, (c) Determine the amount of charge inside the cylinder. Figure P15.49
In which of the following contexts can Gausss law not be readily applied to find the electric field? (a) near a long, uniformly charged wire (b) above a large, uniformly charged plane (c) inside a uniformly charged ball (d) outside a uniformly charged sphere (e) Gausss law can be readily applied to find the electric field in all these contexts.
A thin, square, conducting plate 50.0 cm on a side lies in the xy plane. A total charge of 4.00 108 C is placed on the plate. Find (a) the charge density on each face of the plate, (b) the electric field just above the plate, and (c) the electric field just below the plate. You may assume the charge density is uniform.
Consider the charge distribution shown in Figure P19.74. (a) Show that the magnitude of the electric field at the center of any face of the cube has a value of 2.18 keq/s2. (b) What is the direction of the electric field at the center of the top face of the cube?
A Ping-Pong paddle with surface area 3.80 102 m2 is placed in a uniform electric field of magnitude 1.10 106 N/C. a. What is the magnitude of the electric flux through the paddle when the electric field is parallel to the paddles surface? b. What is the magnitude of the electric flux through the paddle when the electric field is perpendicular to the paddles surface?
(a) Find the electric field at x = 5.00 cm in Figure 18.52 (a), given that q = 1.00 C. (b) at what position between 3.00 and 8.00 cm is the total electric field the same as that for ? 2q alone? (c) Can the electric field be zero anywhere between 0.00 and 8.00 cm? (d) At very large positive or negative values of x, the electric field approaches zero in both (a) and (b). In which does it most rapidly approach zero and why? (e) At what position to the light of 11.0 cm is the total electric field zero, other than at infinity? (Hint: A graphing calculator can yield considerable insight in this problem.)
A 45.0-cm-diameter circular loop is rotated in a uniform electric field until the position of maximum electric flux is found. The flux in this position is measured to be 5.60 105 N · m2/C. What is the magnitude of the electric field?
A 50.0-cm-diameter loop is rotated in a uniform electric field until the position of maximum electric flux is found. The flux in this position is measured to be 4.80 x 105 Nm2/C. What is the magnitude of the electric field?
A uniform electric field of magnitude E = 38 N/C points along the x-axis. A circular loop of radius R = 26 cm is centered at the origin with the normal to the loop pointing θ = 45 degrees above the x-axis. Calculate the electric flux in units of N⋅m2/C that passes through the loop.
A figure shows a closed cylinder with a cross-sectional area A = 3.60 m2. The upper and lower circular surfaces of a vertically-oriented cylinder are labeled A. Electric field vector Epoints vertically upward, going up through the lower surface, up through the cylinder, and finally pointing up through the upper surface.The constant electric field has magnitude 2.85 ✕ 103 N/C and is directed vertically upward, perpendicular to the cylinder's top and bottom surfaces so that no field lines pass through the curved surface. Calculate the electric flux (in (N · m2)/C) through the cylinder's top and bottom surfaces. (a)top surface __________ N · m2 C (b)bottom surface _______ NM^2/C (c)Determine the amount of charge (in C) inside the cylinder. _______C
9. A 40.0 cm diameter loop is rotated to the position where the greatest flux is obtained in a uniform electric field. At this location, the flux is measured as 5 .20x10 ^ 5 N.m ^ 2 / C. Find the magnitude of the electric field. 8.14x105N / C2.14x106 NC5.44x106 N / C6.14x106N / C4.14x106N / C