What is the value of the voltage dropped across forward-biased silicon diodes that are connected in parallel with each other? O 3 V O 1.4 V O 35V O 0.7 V

Q: Compose the mesh equations. 10 Q j10 O j10 O ll ll 10 V [11] [ 12] へ)15V -j10 O sine sine @mesh 1:…

A: In this question,   We need to determine the real and imaginary part of impedance

Q: Question 9 Comstruet a NOR-gate circuit, similar to the figure below, which implements a…

A: A D flip-flop is a single input flip flop the output depends on the clock pulse if the clock pulse…

Q: 20.Under no load condition, the magnetizing current drawn from the supply is more than the real…

A: 20. Under no load condition, secondary is open circuited and hence there will be negligible real…

Q: Si 10 V 10Ω A Si Figure 4

A: We need to find out current for given circuit

Q: Find the current and voltage using superposition across the 4- kN resistor(I, and Vx, respectively).…

A: In this question,   We need to determine the current and voltage across the 4k ohm using the super…

Q: balance Y-connected load of ( 3 + j8 ) ohms per phase is supplied by a balanced three-phase, 60 Hz,…

A:

Q: A resistance R, an inductance L, and a capacitance 10 µF are connected in series as shown in the…

A: We need to find out the value of resistance and inductance for given circuit

Q: Consider the circuit below. solve the output voltage, Vo- 24 V Ge 8k2 Vo 16kn O 23 V O 46.6 V O…

A:

Q: 26.) A voltage v = 220 sin (275t + Tt/2) is applied to a resistor of 12 ohms. Find the r.m.S. value…

A:

Q: At a certain time, the maximum usable frequency (MUF) for transmission at an angle of incidence of…

A:

Q: 14.) Find the value of power dissipated if a voltage v = 240 sin (30t + Tt/4) is applied to a…

A:

Q: AGILA satellite is located 36000 km above the earth’s surface. Assuming free space condition, what…

A: To find the path loss in dB of the signal if the operating frequency is 3 GHz . And distance between…

Q: Find the current and voltage using superposition across the 4- kN resistor(I, and Vx, respectively).…

A:

Q: 26.) A voltage v = 220 sin (275t + Tt/2) is applied to a resistor of 21 ohms. Find the r.m.s. value…

A: When value of voltage and resistance is given , we can find current by ohms law…

Q: 10.) Find the r.m.s. value of the current if the voltage V3D210 sin (275t + Tt/2) is applied to a…

A:

Q: In your own idea using various types of single-phase induction motors, give 2 impacts to the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Problem 1 [5+5] Find the phase difference between these two. Also mention which one is leading. I =…

A:

Q: Question a, Draw a sine wave with a frequency of 250 Hz that lasts for a duration of 12 ms and…

A: Given a sinusoidal signal of 5V. f=50 Hz

Q: O Calculate the photon energy of violet, blue, green, orange and red lights.

A:

Q: A d.c. series motor draws 25 A from a 260 V line while running at 900 rpm. It has an armature…

A: In this question we need to find a value of the diverter resistance Rd .

Q: alternator is rated at 15kVA, 460V. The armature resistance and reactance are 1.50 and 30…

A: In this question we will find single phase alternator no load voltage with given data...

Q: A balance Y-connected load of ( 3 + j8 ) ohms per phase is supplied by a balanced three- phase, 60…

A: In this question,   We need to determine the value of line current, real power and imaginary power…

Q: 440V shunt DC motor has an armature resistance of 1.2Ω and field resistance of 300Ω. find the back…

A: In this question we need to find a back emf  of  motor

Q: 17.) Calculate the force experienced by the conductor of 2 meters long, carrying 80 amperes, placed…

A: The solution is given below

Q: 3. Solve for the inverse Laplace of the following function of s. 68MAT168 a. F(s) =: s(s+2)…

A: In this question we need to find a inverse Laplace transform of the given signal

Q: In PCM, assuming uniform quantization, what is the signal to noise ratio in dB for 12-bit code word?

A: Quantization is  process in which the continuous amplitude signal is converted in to discrete…

Q: Complete the table given by using mesh analysis. Note: If there are no coefficients for a particular…

A: In this question,   We need to determine the value of impedance Z as show the question using the…

Q: (c) An angle-modulated signal is given by: x.(t) = 8 cos[2n(106)t + 0.3 sin(10³) nt]. (i)…

A:

Q: 24.) The figure below shows a series-parallel circuit. Compute for the total active power consumed…

A: This question is related to power calculations

Q: Simplify the following complex numbers. (Write your answers in rectangular form a. i257 + i388 + i4…

A: The solution is given below

Q: 6.) The figuré bélów šhów series-parallel circuit. Compute for the angle O the total circuit…

A:

Q: a) i) Sketch the sequence x[n] = sin(n. T/2) plotted against 'n' (the sketch should only go from n =…

A:

Q: If a silicon diode has a saturation current of 10nA at 25 C to 75° What are the minimum and maximum…

A:

Q: A silicon diode has a saturation current of 7nA at 25° what is the saturation current at 720C?

A:

Q: In radio transmission, the Maximum Usable Frequency (MUF) is the: Highest frequency possible for…

A: The radio transmission is a type of communication which involves use of electromagnetic waves for…

Q: The Single phase fully controlled half- wave rectifier Resistive Inductive (RL) the value of ß…

A: for single phase fully controlled half wave rectifier resistive inductive load the value of beta…

Q: When it comes to semiconductors, how comparable is a diode to a transistor?

A: Comparison  between diode and  transistor: 1.   Definitions:       Diode: A semiconductor device…

Q: If the range selector knob is set to 50 ACV, what would be the voltage reading of the yellow needle?

A: Given the full scale deflection of the analog multimeter is 10 V AC and there is a multiplier of 5…

Q: The speed of a 2 pole SCRIM at no load is; Synchronous speed c. Constant speed d. Infinity а. b.…

A:

Q: Question 16 A transmitter is located at a distance 52 km from a receiving base station. What is the…

A: We need to find out free space loss

Q: When we denote the direction of the line currents in a balance load, balance source system, t is…

A: Load is part of the electrical system which consumes the electrical power generated. The current is…

Q: R, 120V Figure 8-1. CALCULATED VALUES POWER U JA POWER SUPPLIED DISSIPATED (4 x E) V, = V PRI = I, =…

A:

Q: 26. 10,000 pF 0.1 µF 47 pF 0.001 uF 0.01 uF 10 pF :0.001 uF (a) Determine CT for schematic (b); CT-

A:

Q: A Factory takes 200-kW at 1100-volts from a trhee-phase supply and the power factor and the power…

A:

Q: 22.) The figure below shows a series-parallel circuit. Find the magnitude of the total circuit…

A:

Q: 49). A distribution transformer is rated at 100 kVA. If the load p.f. is 0.707 lagging, the active…

A:

Q: A 30kW, 150V DC shunt machine has an armature and field resistances of 0.08Ω and 160Ω respectively.…

A:

Q: 0 11110101 O 01101001 O 01010101 O 01110101 N

A:

Q: 14.) Find the value of power dissipated if a voltage v = 240 sin (30t + Tt/4) is applied to a…

A: Power dissipation in a resistor: The power dissipates in the resister in the form the heat and the…

Q: We encouted different types of signals every day, 1) what is contineous signal? Show an example of…

A: Continuous signal - It is a type of signal which has value at each point of time as it is continuous…

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.