what reactor volume is needed for 95% conversion under adiabatic operation?

Q: 6. Which ratio of cathode to anode accelerates galvanic corrosion? a. Larger cathode to smaller…

A: In general, the rate of corrosion is significantly impacted by the relative sizes of the cathodic…

Q: A Steam Power Plant uses an ideal simple Rankine cycle (the process in the pump and turbine is…

A:

Q: 4. In a safe process, it is planned to produce and sell annually 13 000 pieces of product. The unit…

A: To investigate the feasibility of the investment using the Return on Investment (ROI) method, we…

Q: If 1000kg/h of nicotine-water solution containing Iwt% nicotine is to be counter currently extracted…

A:

Q: On a cold, dry morning after a frost, the temperature was −5 °C and the partial pressure of water in…

A: given = -5^c P = 0.30 KPa The ice sublimates if the vapor pressure exceeds the partial pressure in…

Q: A mercury manometer installed across an orifice meter (diameter = 1.5 cm) in a horizontal pipe…

A: Bernoulli's equation, which connects the pressure difference across the orifice metre to the fluid's…

Q: Q4. In an adiabatic compressor with an efficiency of 0.82, NH3 gas is compressed from 21°C and 200…

A: Efficiency of adiabatic compressor, η = 0.82 Initial temperature of NH3, Ti = 21oC Initial pressure…

Q: 11) The rate constant of T (°C) kx105 (sec¹) 25 1,70 Determine the activation reaction a reaction…

A: Given rate constant of reaction changes with temperature is shown in table below, T(oC) 25 35 45…

Q: For enthalpy 2, the number -63.79 kJ/mol H2SO4 was used for the calculation.  How was this number…

A: The assumption is correct. The value of enthalpy of mixing of H2SO4 at r=8.2 is obtained as -63.79…

Q: A feed to a distillation column consisting of 54 wt% benzene and 46 wt% toluene is separated into…

A: A mixture of benzene and toluene is separated into overhead and bottom product in a fractional…

Q: A 1,1,2-trichloroethane - acetone solution containing 42% acetone by weight at a flow rate of 1200…

A: A mixture of 1,1,1-trichlotoethane-acetone is separated with the help of water in a multistage…

Q: (b) (c) Assume a first order reaction with a half-life of 300 s. What fraction of the initial…

A: (b) The half-life, t1/2 = 300 s The oreder of the reaction is 1. The final time, t = 3000 s

Q: 2 mol gaseous ethene (C₂H4) and 1 mol gaseous water are combined in a reactor and react to form…

A:

Q: The flow rate of vegetable oil was 160 microliters/min (vegetable oils molecular weight is 883 g/mol…

A: Flow rate of vegetable oil=160 microliters/min Molecular weight of vegetable oil= 883 g/mol  Density…

Q: 1) Consider the following reaction:____NH,NO, +Na,PO, (NH₂),PO₂ +_NaNO, Assume we start with 30.0…

A: Note: As per our guidelines, we are supposed to solve only 3 subparts of the question. Please send…

Q: A gas impermeable spherical heterogeneous film from a stationary gas film. It gives the following…

A: Here for the question , we need to derive the equation that gives molar flux  of A in the still gas…

Q: Solution Basis: Given Flow Rate Assume ideal-gas behavior. 2000 L (STP)/min, 20°C (mol/min) 0.100…

A: volumetric flow rate of mixture entering the tower = 2000 L(STP) Temperature of the mixture entering…

Q: The hydrolysis reaction of ethyl ethanoate with an alkaline solution was studied at 25°C using a…

A:

Q: Question 2 Ethylene oxide is produced by the catalytic oxidation of ethylene: 2C2H4 + O2-2C2H4O An…

A: Note: Since you have posted a question with multiple sub parts, we will provide the solution only to…

Q: ratio is 3. How many theoretical plates must the column have if the feed is intro- duced into the…

A:

Q: How do chemical engineers contribute to the development of clean water and wastewater treatment…

A: a )Chemical engineers create and improve treatment systems, such as sedimentation tanks, filtration…

Q: For a Positive displacement compressor, what is the value of discharge temperature, horsepower and…

A:

Q: 20 In 1916 Nusseft derived predicting The Fheoretical relation for coefficient of heat transfer…

A: The convective heat transfer coefficient (h) represents the thermal resistance of a relatively…

Q: 23.1 Identify any initiation, propagation, retardation, inhibition, and termination steps in the…

A: Propagation steps -Elementary steps in which the number of free radicals consumed is equal to the…

Q: Analyze the following images. Identify the type(s) of corrosion. Clearly state your assumptions.…

A: By seeing this image, we can infer that this is an image of a switchboard and by the use of screws…

Q: Q4. Estimate the fugacity and the fugacity coefficient for an equimolar mixture of methyl ethyl…

A: Y1=Y2=0.5 T=50 C=323.15 K P=25 KPa Bij = RTcijPcijBo+ϖijB1formula used to calculate above…

Q: 4.4 In a gas turbine, combusted gas with a volumetric flow rate of 0.5 m³/s expands from 50 bar,…

A:

Q: A counterflow double-pipe heat exchanger is used to heat liquid ammonia from 10 to 30°C with hot…

A:

Q: 6)in a reaction, the rate doubles when the temperature increases from 250C to 350C. What is the…

A: 2R1 =R2 ......(i) T1 = 250C = 298K T2 = 350C = 308 K   where, R1 = rate of reaction  at 250C R2 =…

Q: (b) CMC of a surfactant in water at 25 °C is 0.5 g L-1 and at 45 °C is 0.3 g L-1. The molar mass of…

A: Given that- CMC of surfactant at 250C=0.5 g/L CMC of surfactant at 450C=0.3 g/L Molar mass of…

Q: Analysis of production gases for IC engine show that the mole fractions as: xCO2=0.08637,…

A: Product analysis of an IC engine is given.

Q: The briter of a refrigerator is design to operate at T = 15°F • Assuming the refrigerant in the…

A:

Q: A distillation column contains a mixture of 60% benzene and 40% toluene, by mass, at 1 atm pressure.…

A: A mixture of benzene and toluene is separated in distillate and bottom products using a distillation…

Q: In normal living cells, the nitrogen requirement for the cells is provided from otein metabolism…

A:

Q: A) In the heat exchanger below, it is desired to control the outlet temperature T of the process…

A:

Q: Q3: A pump is pumping 50 gal/ min of water from a pressure of 30 psiato a pressure of 100 psia. The…

A: Pressure at inlet (P1)= 30 Psia=30×6.893 KPa=206.79 KPa pressure at outlet (P2)=100 psia=100×6.893…

Q: A polynomial fit to measurements of the total volume of a binary mixture of A and B is, ν = 778.55 −…

A:

Q: 22-56 A 1-shell-pass and 8-tube-passes heat exchanger is used to heat glycerin (cp= 2.5 kJ/kg-°C)…

A: Given: A 1-8 shell and tube heat exchanger is used to heat glycerine,Cp for glycerine Cpg = 2500…

Q: A feed of one thousand kilograms aqueous solution of pyridine per hour mass) is to be extracted in…

A: A mixture of pyridine-water is to be separated with help of pure benzene in a multistage counter…

Q: For the cell: Cd/Cd(OH)2s/ NaOH(0.01 M/H₂1 Atm.//Pt The electromotive force at 25°C equal Zero, the…

A: Electromotive force at 25 0C = 0 emf  to electrode Cd/Cd+2 = 0.4 V

Q: A dry gas well equipped 30 MMcfd with 85psig tubing pressure must be compressed to 300 psig for…

A:

Q: A plant produces 8,640MT/day of titanium dioxide pigment (100kg/s TiO₂) which must be 99.9% pure…

A: To determine the number of thickeners required for the process, we need to calculate the mass…

Q: Helium undergoes adiabatic compression at Ti = 300 K, Pi = 1 bar. Then, it is heated at constant…

A:

Q: Liquid octane at 25°C and 0,1MPa is burned in 96% theoretical air at 25°C. The exit temperature is…

A:

Q: Gaseous oxygen is maintained at pressures of 2 atm and 1 atm on the opposite sides of a rubber…

A: P1 = 2 atm = 2.0265 bar P2 = 1 atm = 1.01325 t = 0.5 mm = 0.5 x 10-3 m T = 250C = 298K  DAB = 0.21 x…

Q: increase in value? (1) ke Select all that apply, and justify your choice for each. (2) CA at outlet…

A:

Q: Cooling & ideal gas Assuming ideal-gas behavior calculate the heat that must be transferred ar…

A:

Q: Tabulated values from literature for the latent heat of benzene in J/g are provided in the table…

A: Latent heat of vaporization of benzene at 25 0C = 393.3 J/gLatent heat of vaporization of benzene at…

Q: A complete-mixed activated sludge process (CMAS) is to be designed to treat 7.0 MGD of primary…

A: Effluent BOD5 = 170 mg/L TSS concentration = 20 mg/L Biokinetic parameters are, Y = 0.7 mg VSS/mg…

Q: 3. The region inside the inversion curve has and the region outside the inversion curve has…

A: joule thompson coefficient =(∂T∂P)H=μj   joule thompson coefficient(μj) is just the slope in T and P…