What wattage was used for each vanity Luminaire to calculate the estimated load on circuit a 14?

Q: The service size of a main service panel can be found by reading the rating printed on the main…

A: Main electrical service delievering to the houses from the company of electrical utility, it have…

Q: What is the maximum voltage drop allowed for a feeder circuit? 4% 3% 2% 5%

A: The maximum combined voltage drop for both the feeder and branch circuit should not exceed 5%.

Q: What current does a 3/4-hp air conditioning unit draws when it plugged to a 220-volt outlet?

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Will the bulb below (indicated by the arrow) be on or off according to this diagram? on off

A: Given : In the above given circuit they have mentioned a bulb ,voltage source and a switch.   Since…

Q: 3. What wattage was used for each vanity luminaire to calculate the estimated load on Circuit A14?…

A: From the given question,since it has multiple parts we will answer the first three subparts , if you…

Q: Calculate the ammeter reading in the electrical circuit?

A: Use Kirchhoff’s current law,

Q: What wattage was used for the vanity luminaires to calculate the estimated load on Circuit A14?

A: Circuit A14 is a branch circuit of 15 amps. It is used to provide illumination for the corridor, the…

Q: Ali is located in portion number-2 in a long warehouse in company A. ASsuming that the wiring type…

A: Consider the given connection.The live connection and the neutral connection for the arrangement is…

Q: 3. The ballast in some of the older fluorescent luminaires was said to have a low power factor. What…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: explain the point remember for selection and location fo site fora substation

A: Substations:- Substations are crucial parts of the power network needed to maintain consumers'…

Q: DETERMINE THE PROPER SIZE CONDUCTORS for a 500 watt load that is located 100 ft from a 250 volt…

A: Given,THe output power is,Pout=500 WAt panel board the voltage is,V=250 VThe distance between load…

Q: Q20/ Complete the blank The Line Voltage of a star connected three phase alternator  is 255 Volts.…

A: as angle between VR and VY is 120o, the angle between VR and – VY is 180o – 120o = 60o

Q: You are an electrician working in an industrial plant. The company is constructing a maintenance…

A:

Q: Replicate the following circuit showing where each pin should be connected using a breadboard…

A: This is made up of components such as an LDR, a variable resistor, a capacitor, a transistor, and a…

Q: 5. One of electrical wiring design procedure is that circuit all and to the appropriate panels and…

A: Electrical wiring is a proper installation of cables, switchboard, sockets etc in a circuit. Steps…

Q: what switch type and rating is required to control five 300 watt tugsten filament lamps on a 120…

A:

Q: Conductors other than service conductors must not be installed in the same____. A. Service raceway…

A: From Article 230 of National Electric Code (NEC), the following information can be…

Q: Three circuits are set up as shown above. All the bulbs and power supplies are identical. Which of…

A:

Q: Installations used to export electric power from vehicles to premises wiring or for?current flow are…

A:

Q: From what panel board does the kitchen lighting circuit orginate? What size Conductors are used

A:

Q: If you were to place your meter in parallel with a set of closed switch contact that had 120 volts…

A: Assuming there is no resistance in the path, the situation has been shown in the circuit diagram…

Q: 1. Electric utility installations and equipment under the exclusive control of the utility do not…

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 1. Would disconnecting the power supply on the left loop of the circuit, E1, affect the current 12…

A:

Q: A resistor and an inductor are connected in parallel to a 120 volt, 60 cps source. If the total…

A: In this question parallel RL circuit is given with current and power values...We have to find out R…

Q: Kitchen B7 AA R

A:

Q: 13. Two electricians are discussing feeders that supply branch circuits. Electrician A says that the…

A: Feeder: A feeder is a branch of lines associated from one point means at the substation, from…

Q: 5. What wattage for the clothes closet luminaires was used for calculating their contribu- tion to…

A: The wattage of closet luminous for,

Q: A three pole contractor would allow how many paths for current allow ?

A: The path allowed for the passing of the current by the three pole contractor are four.

Q: How much resistance should be connected in series with a 50-ohm lamp rated 2A if it is to be used in…

A:

Q: Calculate the minimum copper conductor size needed for 120/240 V electric range branch circuit the…

A: Given data:                Voltage rating=120/240 VPower rating P=12kWMinimum voltage rating…

Q: On a short/long bond paper, draw a schematic circuit diagram following your house wiring with…

A: electrical wires are designed to bear consistent electric current which should not lead to a fire in…

Q: UNIT 9 VOLTAGE DROP ACROSS CONDUCTORS 81 10. The voltage source across a motor is 238 volts. The…

A: In this question,  Find the source voltage if Voltage across the motor = 228V Total drop in…

Q: What is the demand load for the service for two 3.5-kW wall-mounted ovens and one 5-kW…

A: Here, we have given a problem related to the load demand required for the equipments used by a…

Q: What does it mean by connection of wattmeter confused?

A: In this question we will write about connection of wattmeter meaning in given figure...

Q: Is a service entrance panel a circuit breaker panel

A: This question is based on the  service entrance panel Is a service entrance panel a circuit breaker…

Q: 5.a. Typically, the bonding conductor installed between the panelboard equipment grounding terminal…

A: 5.a) Typically, the bonding conductor installed between the panelboard equipment grounding terminal…

Q: A one watt 470-ohm resistor is connected to 24 volts. Is the resistor operating within its power…

A: A one watt 470-ohm resistor is connected to 24 volts. Is the resistor operating within its power…

Q: Which of the following does not refer to electrical energy? Select the correct response: Joule…

A:

Q: Information about the cables that rating is above 132kv?

A: XLPE extra high voltage cable have voltage rating above 120 KV .

Q: A 120-volt lamp fluorescent ballast for two 40-watt lamps is marked 85 volt-amperes. What is the…

A: Given; Voltage of fluorescent ballast V=120 V Power of each lamp P=40 W Volt-ampere of ballast S=85…

Q: what is the computed load for a cooktop unit with a nameplate rating of  6kW

A: Table 220.19 shown below applies to household cooking appliances (rated over 1,750W). Given name…

Q: What is the current flowing on the 9-ohm resistor if the source voltage is placed at 16 volts?…

A: In this question first we will find equivalent resistance across ab then total current and will find…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.