When 1.06 mmol of 1-pentanol and 1.53 mmol of 1-hexanol were separated by gas chromatography, they gave relative peak areas of 922 and 1 570 units, respectively. When 0.57 mmol of pentanol was added to an unknown containing hexanol, the relative chromatographic peak areas were 843:816 (pentanol:hexanol). How much hexanol did the unknown contain?

When 1.06 mmol of 1-pentanol and 1.53 mmol of 1-hexanol were separated by gas chromatography, they gave relative peak areas of 922 and 1 570 units, respectively. When 0.57 mmol of pentanol was added to an unknown containing hexanol, the relative chromatographic peak areas were 843:816 (pentanol:hexanol). How much hexanol did the unknown contain?

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter88: Column Chromatography

Section: Chapter Questions

Problem 5P

See similar textbooks

Similar questions

Internal standard. When 1.06 mmol of 1-pentanol and 1.53 mmol of 1- exanol were separated by gas chromatography, they gave relative peak areas of 922 and 1 570 units, respectively. When 0.57 mmol of pentanol was added to anunknown containing hexanol, the relative chromatographic peak areas were 843:816 (pentanol:hexanol). How much hexanol did the unknown contain?
2-chloropentane, pentanoic acid, cyclopentane, and pentanal are among the chemicals found in a combination. If the mixture underwent paper chromatography with the same solvent system employed in the experiment, arrange the following components in INCREASING Rf.
A mixture contains the following compounds: 2-chloropentane, pentanoic acid, cyclopentane and pentanal. Arrange the following compounds in INCREASING Rf if the mixture underwent paper chromatography with the same solvent system used in the experiment.
You were analyzing a mixture of volatile solvents using Gas Chromatography and found out that two peaks are unresolved (not well-separated) using your initial program. Which method can you use to obtain a chromatogram with well separated peaks?
In a chromatographic analysis, a solution containing 0.0837M toluene and 0.0666M xylene resulted in peak areas of Atoluene= 423 and Axylene= 347. To analyze an unknown sample, 10.0mL of 0.146M xylene was added to 10.0mL of an unknown toluene-containing solution, and the mixture was diluted to 25.0mL. This mixture gave a chromatogram with peak areas of Atoluene= 553 and Axylene= 582. What was the concentration of toluene in the unknown solution?
1) When you try separating an unknown mixture by normal-phase liquid chromatography with 50% hexane and 50% methyl t-butyl ether, the peaks are too close together. (not resolved) Should you use a higher or lower concentration of hexane in the next run?
Next, 2.00 mL of 9.63 mM S was added to 10.00 mL of a solution of unknown concentration of X, and the mixture was diluted to 25.0mL. Chromatographic analysis of this solution produced peak areas of 4822 for X and 4099 for S. What was the concentration of 5 (in mM) of the 25.0mL solution?
1a) Hexane, CH3(CH2)4CH3, is found to have a long retention time when separated from a mixture. A column with a C18 (18-carbon chain) stationary phase and a methanol-water modal phase is used for the separation. Explain why hexane has a long retention time. 1b)You wish to chromatographically seperate a mixtureof the follwing compunds. Which of the two compounds will be most difficult to seperatate from one another? Why?
Suppose that you try separating an unknown mixture by normal-phase chromatography with the solvent mixture 50% hexane-50% methyl t-butyl ether (which is more polar than hexane). The peaks are too close together and are eluted rapidly. Should you use a higher or lower percentage of hexane in the next run?
A chromatographic column is eluted with a solution containing a mixture of two components, X and Y. The chemical affinity of X for the stationary phase is less than that of Y and the chemical affinity for X for the mobile is greater than that of Y. Which substance will be eluted first? Explain your answer.
Given the mass chromatography, identify the peaks of 200, 144, and 115 for 2-Naphthyl-Butylether.
Oral rehydration salts are stated to contain the following components: Sodium Chloride 3.5g Potassium Chloride 1.5g Sodium Citrate 2.9g Anhydrous Glucose 20.0g 8.342 g of oral rehydration salts are dissolved in 500 ml of water. 5 ml of the solution is diluted to 100 ml and then 5 ml is taken from the diluted sample and is diluted to 100 ml. The sodium content of the sample is then determined by flame photometry. The sodium salts used to prepare the mixture were: Trisodium citrate hydrate (C6H5Na3O7, 2H2O) MW 294.1 and sodium chloride (NaCl) NW 58.5. Atomic weight of Na = 23. The content of Na in the diluted sample was determined to be 0.3210 mg/100 ml. Determine the % of stated content of Na in the sample. The stated should be 104.5, how??