When solving for the normal force at C, why is there no tangential acceleration? SolutionsConservation of total energy1. The spring of constant k is unstretched when the slider ofmass m passes position B. If the slider is released from restin position A, determine its speed as it passes point B andC. What is the normal force exerted by the guide on theslider at position C? Neglect friction between the mass andthe circular guide, which lies in a vertical plane.(Meriam 3/148)|AkВRSolution:CThe system is a conservative system, for position A, B and Cwe haveE1 = E2= E3T1 + Vị = T2 + V2 = T3 + V3HART1 + Vị = 0 + mgR +k1T2 + V2mv, + 02R1mv} – mgRT3 + V3-R3CkR?(ans)→ v2 = 2gR + 0.1716-тNkR?|4gR+0.1716-m(ans)→ Vz =mmgAt C: N- mg= mR→ N= 5mg + 0.1716kR (ans)

The point C is the bottommost point of the circular guide. At the point C, the forces acting on the…

Answered: When solving for the normal force at C,…

Science

Physics

When solving for the normal force at C, why is there no tangential acceleration?

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter8: Potential Energy And Conservation Of Energy

Section: Chapter Questions

Problem 79AP: Consider a block of mass 0.200 kg attached to a spring of spring constant 100 N/m. The block is...

See similar textbooks

Similar questions

Check Your Understanding What potential energy U(x) can you substitute in Equation 8.13 that will result in motion with constant velocity of 2 m/s for a particle of mass 1 kg and mechanical energy 1 J?
“ E=K+Uconstant is a special case of the work energy theorem.” Discuss this statement.
Check Your Understanding Suppose the mass in Equation 8.6 is doubled while keeping the all other conditions the same. Would the maximum expansion of the spring increase, decrease, or remain the same? Would the speed at point B be larger, smaller, or the same compared to the original mass?
A particle of mass 0.50 kg moves along the x -axis with a potential energy whose dependence on x is shown below. (a) What is the force on the particle at x = 2.0, 5.0, 8.0, and 12 m? (b) If the total mechanical energy E of the particle is —6.0 J, what are the minimum and maximum positions of the particle? (c) What are these positions if E = 2.0 J? (d) If E = 16 J, what are the speeds of the particle at the positions listed in part (a)?
A pendulum, comprising a light string of length L and a small sphere, swings in the vertical plane. The string hits a peg located a distance d below the point of suspension (Fig. P7.80). (a) Show that if the sphere is released from a height below that of the peg, it will return to this height after the string strikes the peg. (b) Show that if the pendulum is released from rest at the horizontal position ( = 90) and is to swing in a complete circle centered on the peg, the minimum value of d must be 3L/5. Figure P7.80
Suppose you are jogging at constant velocity. Are you doing any work on the environment and vice versa?
Consider a block of mass 0.200 kg attached to a spring of spring constant 100 N/m. The block is placed on a frictionless table, and the other end of the spring is attached to the wall so that the spring is level with the table. The block is then pushed in so that the spring is compressed by 10.0 cm. Find the speed of the block as it crosses (a) the point when the spring is not stretched, (b) 5.00 cm to the left of point in (a), and (c) 5.00 cm to the right of point in (a).
A particle of mass 4.0 kg is constrained to move along the x -axis under a single force F(x)=cx3 , where c=8.0N/m3 . The particle’s speed at A, where xA=1.0m , is 6.0 m/s. What is its speed at B, where xB=2.0m ?
A 200-g steel ball is tied to a 2.00m “massless” string and hung from the ceiling to make a pendulum, and then, the ball is brought to a position making a 30 angle with the vertical direction and released from rest. Ignoring the effects of the air resistance, find the speed of the ball when the string (a) is vertically down, (b) makes an angle of 20 with the vertical and (c) makes an angle of 10 with the vertical.
Check Your Understanding When the length of the spring in Example 8.3 changes from an initial value of 22.0 cm to a final value, the elastic potential energy it contributes changes by 0.0800 J. Find the final length.
Consider a particle on which several forces act, one of which is known to be constant in time: . As a result, the particle moves along the x-axis from x=0 to x=5 m in some time interval. What is the work done by ?
In a Coyote/Road Runner cartoon clip (https://openstaxcollege.org/l/21coyroadcarcl), a spring expands quickly and sends the coyote into a rock. If the spring extended 5 m and sent the coyote of mass 20 kg to a speed of 15 m/s, (a) what is the spring constant of this spring? (b) If the coyote were sent vertically into the air with the energy given to him by the spring, how high could he go if there were no non-conservative forces?