Answered: When the kinetic energy due to rotation…

Science

Physics

When the kinetic energy due to rotation is zero?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter10: Rotational Motion And Angular Momentum

Section: Chapter Questions

Problem 47PE: Repeat Example 10.15 in which the stick is free to have translational motion as well as rotational...

See similar textbooks

Related questions

Q: A torque of 170 N.m does 4715 J of work on a rotating flywheel. If the flywheels initial kinetic…

A: Given : τ = 170 N.m W = 4715 J Ki = 1320 J

Q: A 240 N sphere of 0.20 m in radius rolls without slipping 6.0 m down a ramp that is inclined at an…

A: Given Weight of the sphere W = 240 N Radius of the sphere r = 0.20 m Length of the ramp L = 6.0 m…

Q: An athlete in a gym applies a constant force of 50 N to the pedals of a bicycle to keep the rotation…

A: Length of pedal arm is r = 30 cm = 0.3 m Force applied on the wheel is F = 50 N

Q: water wheel with radius Rw = 1.3 m and mass Mw = 1.85 x 103 kg is used to power a grain mill next to…

Q: A bowling ball of mass 6.85 kg is rolling at 2.60 m/s along a level surface. (a) Calculate the…

Q: A torque of 170 N.m does 4617 J of work on a rotating flywheel. If the flywheels initial kinetic…

A: To answer the question, we will use the work-energy theorem.

Q: The turntable in a microwave oven has a moment of inertia of 0.038 kg⋅m2 and is rotating once every…

A: Given, moment of inertia =0.038 kg.m2time period T =5.0 secwe have to calculate the kinetic energy.

Q: A 6kg hoop 3m in diameter rolls down a plane inclined 40 degrees. At the bottom of the incline, what…

Q: As shown in the figure, a disk of mass m = 200 grams is placed on a rotating turntable so that the…

A: According to question--- Given data -- Mass of disk (m)= 200 g. Radius of disk = 70 cm. Hanging…

Q: A circular saw is powered by a motor. When the saw is used to cut wood, the wood exerts a torque of…

Q: A hoop of radius 2 m weighs 100 kg. It rolls along a horizontal floor so that its centre of mass has…

A: Without the weights the meter stick will balance at 50 cm.

Q: A bowling ball of mass 7.24 kg and radius 10.7 cm rolls without slipping down a lane at 2.80…

Q: A wheel with a weight of 391 N comes off a moving truck and rolls without slipping along a highway.…

A: We have a wheel of weight F=391 N which has a radius R=0.601 m and has an angular velocity w=25.1…

Q: A wheel had a radius of .51m and a inter ya of 14.8kg•m^2 rotating around 56 rev/min. The wheel…

A: radius r= .51m inertia= 14.8kg•m^2 angular velocity, w= 56 revminute=2π×5660=5.86 rad/s time taken…

Q: An electric sander consisting of a rotating disk of mass 0.7 kg and radius 10 cm rotates at 15…

A: Given data: Mass of the rotating disk, m=0.7 kg Radius of the disk, r=10.0 cm = 0.10 m Initial…

Q: A bowling ball of mass 7.15 kg is rolling at 2.50 m/s along a level surface. (a) Calculate the…

Q: A screwdriver turns a screw an angle of 5.09 radians by applying a torque given by (in Nm) T= 1.57 +…

Q: A 6kg hoop 3m in diameter rolls down a plane inclined 40 degrees. At the bottom of the incline, what…

A: Given: The mass of the hoop m = 6 kg The radius of the hoop r = 1.5 m The horizontal distance d = 3…

Q: When a torque does work on a rotating rigid body, what is the effect on kinetic energy?

A: When a rigid body is rotating abound a fixed axis with an angular velocity w, then a torque is…

Q: A solid disc with the mass of 8 kg and radius R of 10 cm rolls smoothly in a path from rest down a…

A: Decrease in PE=Increase in rotational ξ translational K.E of the…

Q: The top edge of a rod of mass 2.80 kg is pivoted to a point on the ceiling. The rod is free to…

A: in this question we determine angular velocity and angular displacement.

Q: A solid sphere of mass 0.1 kg and radius 2.5 cm rolls without slipping with a uniform velocity of…

Q: The puck in the figure below has a mass of 0.186 kg. Its original distance from the center of…

A: Given: mass of puck, m=0.186 kg Initial radius, ri = 40 cm Initial speed of rotation, v=85 cm/s…

Q: A .20 kg mass is sitting on a frictionless 1 m long incline and is attached via cable to the inner…

Q: The puck in the figure below has a mass of 0.132 kg. Its original distance from the center of…

Q: A solid uniform sphere of radius .250 m and mass 45.0 kg rolls down a ramp of length 4.50 m that…

A: sphere moment of inertia is equal to : I = 25×m×r2 = 25×45×(0.25)2 = 1.125kg m2 we can also write…

Q: A hollow sphere rolls without slipping down a ramp that is 3.5 m long. the ramp is inclined at an…

Q: A torque of 170 N.m does 4602 J of work on a rotating flywheel. If the flywheels initial kinetic…

A: Given Work done W=4602J Initial kinetic energy Ki=1289J

Q: A solid sphere of mass 0.05 kg and diameter 2 × 10-2 m rolls without slipping with a uniform…

Q: A wheel has a moment of inertia of 7.97 kg m². Its initially rotating at 7500 revolutions per…

A: Moment of inertia of wheel,(I)=7.97 kg-m2 ------(1) [Given] Number of rotation,(N)=7500 rev/min…

Q: A hollow sphere rolls without slipping down a ramp that is 3.5 m long. the ramp is inclined at an…

A: Given information: Here, l is the length of the ramp and θ is the ramp’s inclination angle.

Q: A circular saw is powered by a motor. When the saw is used to cut wood, the wood exerts a torque of…

Q: A solid sphere of mass 0.05 kg and diameter 2 x 10-2 m rolls without slipping with a uniform…

Q: A bowling ball of mass 7.20 kgkg and radius 10.7 cmcm rolls without slipping down a lane at 2.90…

Q: A thin 105 g disk with a diameter of 7.00 cm rotates about an axis through its center with 0.615 J…

A: Given : Mass of a disk (m) = 105 g = 0.105 kg Diameter (d) = 7 cm = 0.07 m Kinetic energy (K) =…

Q: A 26 g block sits at the center of a turntable that rotates at 50 rpm. A compressed spring shoots…

Q: An automobile has a total mass of 1600 kg. It accelerates from rest to 50 km/h in 25 s. Assume each…

Q: A rotating wheel has a kinetic energy of 135 J when its rotating at an angular speed of 30 rad/s.…

A: In this question, we are dealing with the rotational motion. Given: Kinetic energy, K=135 J Angular…

Q: A bus moves towards Kadıköy direction. A 392 N tire comes off and rolls without slipping along…

A: Given data: The weight of the tire, W=392 N. The angular velocity of the tire at the bottom of the…

Q: A bicycle is turned upside down while its owner repairs a flat tire on the rear wheel. Afriend spins…

Question

When the kinetic energy due to rotation is zero?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The puck in Figure 10.25 has a mass of 0.120 kg. The distance of the puck from the center of rotation is originally 40.0 cm, and the puck is sliding with a speed of 80.0 cm/s. The string is pulled downward 15.0 cm through the hole in the frictionless table. Determine the work done on the puck. (Suggestion: Consider the change of kinetic energy.)
A 40.0-kg solid sphere is rolling across a horizontal surface with a speed of 6.0 m/s. How much work is required to stop it? Compare results with the preceding problem.
A cylinder of mass 10.0 kg rolls without slipping on a horizontal surface. At a certain instant, its center of mass has a speed of 10.0 m/s. Determine (a) the translational kinetic energy of its center of mass, (b) the rotational kinetic energy about its center of mass, and (c) its total energy.
A bicycle is turned upside down while its owner repairs a flat tire on the rear wheel. A friend spins the front wheel, of radius R, and observes that drops of water fly oil tangentially in an upward direction when the drops are at the same level as the center of the wheel. She measures the height reached by drops moving vertically (Fig. P10.74). A drop that breaks loose from the tire on one turn rises a distance h1 above the tangent point. A drop that breaks loose on the next turn rises a distance h2 h1 above the tangent point. The height to which the drops rise decreases because the angular speed of the wheel decreases. From this information, determine the magnitude of the average angular acceleration of the wheel.
The puck in Figure P11.46 has a mass of 0.120 kg. The distance of the puck from the center of rotation is originally 40.0 cm, and the puck is sliding with a speed of 80.0 cm/s. The string is pulled downward 15.0 cm through the hole in the frictionless table. Determine the work done on the puck. (Suggestion: Consider the change of kinetic energy.) Figure P11.46
A 40.0-kg solid cylinder is rolling across a horizontal surface at a speed of 6.0 m/s. How much work is required to stop it?
A bowling ball of mass 7.00 kg is rolling at 3.00 m/s along a level surface. Calculate (a) the balls translational kinetic energy, (b) the balls rotational kinetic energy, and (c.) the balls total kinetic energy, (d) How much work would have to be done on the ball to bring it to rest? (See Section 8.6.)
A tennis ball is a hollow sphere with a thin wall. It is set rolling without slipping at 4.03 m/s on a horizontal section of a track as shown in Figure P10.62. It rolls around the inside of a vertical circular loop of radius r = 45.0 cm. As the ball nears the bottom of the loop, the shape of the track deviates from a perfect circle so that the ball leaves the track at a point h = 20.0 cm below the horizontal section. (a) Find the balls speed at the top of the loop. (b) Demonstrate that the ball will not fall from the track at the top of the loop. (c) Find the balls speed as it leaves the track at the bottom. What If? (d) Suppose that static friction between ball and track were negligible so that the ball slid instead of rolling. Would its speed then be higher, lower, or the same at the top of the loop? (e) Explain your answer to part (d). Figure P10.62
A block of mass 3 kg slides down an inclined plane at an angle of 45 with a massless tether attached to a pulley with mass 1 kg and radius 0.5 m at the top of the incline (see the following figure). The pulley can be approximated as a disk. The coefficient of kinetic friction on the plane is 0.4. What is the acceleration of the block?
Two spheres, one hollow and one solid, are rotating with the same angular speed around an axis through their centers. Both spheres have the same mass and radius. Which sphere, if either, has the higher rotational kinetic energy? (a) The hollow I sphere, (b) The solid sphere, (c) They have the same kinetic energy.
Repeat Example 10.15 in which the stick is free to have translational motion as well as rotational motion.
An electric food processor comes with many attachments forblending and slicing food. Assume the motor maintains thesame angular speed for all the various attachments. The largestattachment has a diameter of 12.0 cm, and the smallest has a diameter of 5.00 cm. Find the ratio of the translational speeds of points on the edges of each attachment.