Answered: When you touch a hot object with your…

When you touch a hot object with your finger, the heat transferred to your finger is by Group of answer choices radiation none of these Conduction convection

Materials Science And Engineering Properties

1st Edition

ISBN:9781111988609

Author:Charles Gilmore

Publisher:Charles Gilmore

Chapter4: Temperature Effects On Atom Arrangements And Atom Motion

Section: Chapter Questions

Problem 4.1P

See similar textbooks

Related questions

Q: 4. A town is covered by an inversion layer 500 m above the ground. The town’s area isapproximately…

A: Calculation of sulphur dioxide in town air:

Q: a. The velocity before the jump b. The depth after the jump c. The velocity after the jump d. The…

Q: A pipe 40 cm in diameter contains steam at 100°C and is covered with asbestos (K = 0.0006…

Q: 2. A system is cooled at constant volume from state 1 to state 2, the internal energy decreasing 88…

A: For a cyclic process net changes in internal energy becomes zero so we can find changes in internal…

Q: A rod length l with the thermally insulated lateral surface is made of a material whose thermal…

A: Heat flow: The movement of heat is known as heat flow. This process of heat flow is done by…

Q: Transferring a composite wall and then to an inside air represents heat from outside air to O…

Q: 6.106. Air at 25°C and 1 atm with a relative humidity of 25% is to be dehumidified in an adsorption…

A: Part a Assumptions : all water vapor adsorbed in 2 hours Pressure and temperature are constant.…

Q: water goes through the water cycle again and again, the amount of water on Eart A- Increases. C-…

A: 1. C stays the same 2. A Decreases with higher altitudes 3. D Rainfall 4. C Evaporation,…

Q: A 10 m aluminium flagpole is installed at 30°C. After 2 days, the temperature drops to -10° C. How…

Q: The function of solar collector is to.. O a. Absorb heat O b. Release heat O c. Produce heat O d.…

A: Finding out function of solar collector.

Q: What is the effect of temperature on surface conduction of any material?

A: Solution: The temperature has an inverse effect on the surface conduction of any material. The…

Q: You are designing a heatsink to cool a 100mm tall, 100mm wide surface. The fins you use are…

A: Solution; Given that; Height (H) =100 mm = 0.100 m Width (W) =100 mm=0.100 m Thickness of fins tf=2…

Q: 50 m length of tape is of standard length at temperature of 50.76°C. What would be the error in the…

Q: Water sample has pH of 9.25. Find the concentration of hydroxyl ion in water sample.

A: Given: pH = 9.25 Molecular weight of OH- = 17 g Also,

Q: . Determine the capillary rise of kerosene in the

Q: A dehumidifier is used to extract excess moisture from the air inside a room with dimension 8x6x3…

A: Given- Dimension of room=8×6×3 m3temperature=30°crelative humidity=70%wet bulb temperature =11°Cdry…

Q: All For laminar flow over a flat plate, the local heat transfer coefficient h, is known to where x…

Q: A closed system undergoes a cycle consisting of two processes. During the first process, which…

A: According to the above situation the the process is cyclic and Internal energy and enthalpy does not…

Q: Condensation occurs when the temperature is the dew point temperature (Td).

A: solution Less than or equal to due point actually when the falls below the dew point the excess…

Q: Thermometer measures the latent heat. Select one: O True O False

A: Thermometer measures the latent heat.

Q: 14. A fire detector cannot detect: A. O Radiation А. В. O Heat С. O Light D. O Smoke

A: Fire detector cannot detect

Q: A rocket engine burns 8.5kg of fuel and oxidizer per second, and combinations gases exit the rocket…

A: Given data- Burning rate of fuel = 8.5 kg /s Rocket velocity = 565 m/s Pressure = atmospheric…

Q: How can a gas-fired warm-air furance be used to cool a building

A: Gas-fired warm air furnace- In this, they have a burner in the furnace filled with natural gas. A…

Q: 2. Domestic "tap" water generally has a conductivity in the range 0.5 - 1.0 ms/cm. Based on your…

A: The total amount of dissoloved salt in water can be easily estimated by measuring the specific…

Q: Precipitation requires lifting of air mass so that it warms and condenses. O True O False

A: Precipitation occurs only when there is some mechanism to cool the atmospheric air to bring it to…

Q: Estimate the ev from a reservoi temperature, as рerati air temperature

A: Given :- Water surface temperature T = 40 °C = 313 K surface mass exchange coefficient for blowing…

Q: Your are required to install a temperature sensor for measuring room temperature. Which of the…

A: The Thermocouple is by far the most commonly used type of all the temperature sensor types.

Q: The restriction of the transmitted and/or received energy to a single horizontal or vertical plane…

A: Condensation is important in the water cycle because it is responsible for the formation of clouds.…

Q: (a) outdoor environment. The thermal performance of a building depends upon the facade design to a…

A: Note:- “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: he temperature of a body falls from 90°C to 70°C when placed in a surrounding of constant…

A: First condition, The initial temperature is Ti=90°C. The final temperature is Tf=70°C. The…

Q: What is the pH of a solution made by dissolving 3.71 grams of calcium fluoride in enough water to…

A: Given Data: The mass of the calcium fluoride is M=3.71 g. The volume of resulting solution is V=450…

Q: If the outside diameter of a pipe is 50 mm was covered with a 0.64 cm of insulation made of asbestos…

A: Here we first calculate the heat flow between outside and inside of pipe and then equate with heat…

Q: A fluid enters a device steadily at 35 m/s, 200 kPa and 65C and exits at 240 m/s and 95 kPa. The…

A: Given that , fluid enters a device steadily at 35 m/s, 200 kPa and 65C and exits at 240 m/s and 95…

Q: list of tools and equipments to undergo an experiment on cryptosporidium parvum in sewages

A: Answer:- Cryptosporidium parvum:- It is one of the most common human parasitic protozoa and is…

Q: The temperature of a system increases from 35 C to 65°C during a heating process. Express this…

A: C = Celsius, F = Fahrenheit, R = Reaumur, and K = Kelvin are four different method of measuring…

Q: 38 degrees celsius and 218 kpa gage, the specific weight of a certain gas was 15.0 n/m^3. determine…

A: Answer: Given: Temperature, T = 38 deg. C. = 38+273 = 311K Pressure, P = 218 kPa Specific Weight of…

Q: A line was measured with a 50-m tape which was found to be 532.28 m. the tape is known to be of…

A: True length =532.37m

Q: An insulated steam pipe having outside diameter of 3 cm is to be covered with two layers of…

A: Given data D1=30 mmD2=30+25=55 mmD3=30+25+25=80 mm So there will be two cases Case 1 Case 2 k…

Q: A steel tape with a coefficient of thermal expansion of 0.0000116/°C is known to be 50 m long at…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

100%

When you touch a hot object with your finger, the heat transferred to your finger is by

Group of answer choices

radiation

none of these

Conduction

convection

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The height of kerosene in the left leg was measured as 8.2 cm high and 5.2 cm on the right leg. The difference in elevation between the interfaces of kerosene and water measured 2.5 cm. Determine the specific gravity of kerosene.*
Choose the correct answer How can relatively denser object be made to float on the less dense fluid? * a-By altering the shear forces acting on the object b-By altering the shape. c-By altering the forces acting on the object d-None of the mentioned
Endothermic reaction is a chemical reaction which produces heat. Select one: True False
For the beam deflection / beam bending experiment 1a- Briefly state the engineering research problem being addressed. 1b-Briefly explain how the experiment addresses the research problem. 1c-State and explain the equations used and the key principles behind them
Environmental Engineering, environmental chemistry question: Hydrogen sulfide (H2S) is an odorous gas that can be stripped from solution. The reaction is: H2S<<<>>>H+ + HS- The equilibrium constant, Ka1 = 0.86 x 10-7 Find the fraction of hydrogen sulfide in H2S form at pH 6 and pH 8.
For stearically stabilized system, weak flocculation occurs when thickness of absorbed layer is [x], particle radius is [y] and Hamakar constant is [z]. Chose the correct answer for x, y and z in the sentence above. Group of answer choices: x=large; y=small; z=large x=small; y=large; z=large x=large; y=small; z=small x=large; y=large; z=large x=large; y=large; z=large x=large; y=large; z=small
Choose the correct answer e) None of the mentioned c) Depends on the conditions d) Depends on the type of Motion a) Yes b) No
To damp oscillations, the pointer of a galvanometer is fixed to a circular disk which turns in a container of oil as shown in the figure. What is the damping torque for angular velocity ω= 0.30 rad/s if the oil has a viscosity of 8 X 10-3 Pa-s. Assume at any point the velocity profile of the oil is linear, and neglect edge effects.
In Figure below if a metlic c:ube of a 1 2 inch side length weighing 46 kg, floats at a two layer fluids mercury and sea water. Detennine the position of the block at mercury- water interface when it has reached equilibrium. (mass density of sea water ; 63.92623 lb/fts) and for mercurv : 845 lb/ftS).
Question 2. A coal fired power station requires an ESP for dust removal from the flue gas. The influent flu gas has a concentration of 5200 mg/m3 of dust particles and a flow rate of 150 m3/s. The smallest particles in the gas stream are 1.5 um in diameter, and all particles have a dielectric constant of 5.5. The emission standard is 50 mg/m3. Assume a plate-to-plate spacing of 30 cm and an applied voltage of 15,000 volts. Each plate is 20 m long and 15 m high. Estimate –a) The particle drift velocityb) The required collection-plate area and number of plates required.Assume – Standard temperature and pressure.
Calculate suppprt reaction
Dead time is the time spent by analyte in both mobile and stationary phases True False