Which activities are likely to cause contamination of stock chemicals in the laboratory? pouring out chemicals from the stock container into another container returning unused stock chemicals to their original container at the end of an experiment swirling the container of stock chemicals to ensure that the contents are thoroughly mixed spilling some of the chemicals on the lab bench and then returning them to the original container inserting a dirty pipet into a container of stock chemicals

Which activities are likely to cause contamination of stock chemicals in the laboratory? pouring out chemicals from the stock container into another container returning unused stock chemicals to their original container at the end of an experiment swirling the container of stock chemicals to ensure that the contents are thoroughly mixed spilling some of the chemicals on the lab bench and then returning them to the original container inserting a dirty pipet into a container of stock chemicals

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 83QRT

See similar textbooks

Similar questions

Which activities are likely to cause contamination of stock chemicals in the laboratory?
Determine each statement if it describes dissolution or disintegration. It is mainly affected by tablet hardness, presence of binders and fillers. The process of breaking down a substance that is not readily soluble May apply on solid, liquid and gaseous dosage forms. The process of breaking down a substance into tiny fragments. Involves the interaction between solute and solvent. Heat will majorly make the process faster The process closer to the absorption process. Tested using a machine with a basket rack holding six plastic tubes. The test for this process requires the sample to be tested for concentration of active ingredient over time. Usually only applies to solid dosage forms.
If uncertain as to how to dispose a chemical, dumping it to the sink followed by copious amount of water is a safe disposal procedure true or false
Which of the following given statements is false? 1. The electrical conductivity of water is dependent on the temperature of the water sample. Removal of suspended particles by sedimentation depends upon the size and specific gravity of those particles. Suspended solids retained on a filter may remain in suspension if their specific gravity is similar to water while very dense particles passing through the filter may settle. Sodium hydroxide and sodium chloride are both bases. 2. In a sedimentation process, the solid particles settled at the bottom of the container because they are heavier than water and are acted upon by gravity. In the process of distillation, the condenser helps in the conversion of the vapor that goes inside it into liquid. After filtering a mixture using a filter paper, there is more solute at the bottom of the container compared to the contents of the filter paper. In the reaction between dry ferrous sulfate and dry potassium ferricyanide, no change is observed.…
Is it acceptable to recycle the containers of hazardous chemicals? Why or why not? Explain your answer within the context of chemical safety.
All infectious waste containers should be.... A. Label on at least one side with biohazard symbolB. Be leak proofC. Should not be made of cardboardD. Should not be hung on a metal type rack offering no secondary containmentE. Never be left left on the floor outside of a secondary leak-proof containerF. All of the above
researchers working in a chemistry lab were examined anatomical structures of the brain using concentrated formaldehyde solutions. Once their studies concluded there remained 1.5 gallons of the substance and the researcher decided to pour this down the drain. In this case, they directly violet regulations put in place by which office?1. Office of research integrity 2. Institutional animal care and use committee3. Occupational safety and health administration 4. Institutional review board
Different type of methods used in household contaminated wastewater purification
Draw a schematic diagram using this information. Preparation of the solution Take about 25-30 ml of distilled water in a beaker and add powdered crude copper sulphate while stirring the solution so that the powder dissolves. Keep adding the powdered sample till a little of it remains undissolved, even if it is stirred thoroughly. Now add 2-3 ml of dil. H2SO4 to make the solution clear. This prevents the hydrolysis of copper sulphate. Filtration of the solution Take a funnel and fix a filter paper in it and clamp it to a stand. Place a china dish under the funnel. The stem of the funnel should touch the wall of the china dish to avoid the solution splashing out. Pour the solution into the funnel over a glass rod and collect the filtrate in a china dish. The insoluble impurities are left in the filter paper as residue. Concentration of the filtrate to crystallisation point Heat the china dish on a sand bath till the solution is reduced to about one-third of its original volume. To…
TRUE OR FALSE __________ 6. The bowl of the funnel for gravity filtration may be filled to the brim. __________ 7. Transfer liquids and solutions from a reagent bottle or beaker with the aid of a stirring rod. __________ 8. Never touch, taste, or smell a chemical unless specifically told to do so. __________ 9. If uncertain as to how to dispose of a chemical, dumping it into the sink followed by copious amount of water is a safe disposal procedure. __________ 10. A centrifuge machine should be balanced with an even number of centrifuge/test tubes, placed across the rotor from one another, with equal volumes of liquid.
Assignment: This is an individual activity. After studying the lesson and watching all the videos, answer the following questions. Answer in not more than 3 sentences per question. 1. Discuss the a) direct method of weighing b) indirect weighing using the analytical balance. 2. Explain how suction filtration is carried out in the laboratory. Give the important points that must be observed in doing the process. 3. Explain why it is important to wash the precipitate. Can distilled water be used to wash all types of precipitates? 4. Discuss how to use a desiccator. When should a desiccant be replaced?
New employees at Avondale Industries’ unmanned systems production line in Denver, CO, participate in employee training under the direction of the training and development department, but the line managers conduct the actual training. During the last two trainings, the line managers cut the sessions short and explained that the employees would receive better training while working on the production line. The trainer responsible for the program understood the line managers’ viewpoint about developing skills used on the line but needed them to see that training should provide more than just developing those specific skills. Which of the follow statements best explains why training should provide a longer-term view than just teaching line workers the skills needed to perform satisfactorily in their current jobs? Giving line workers expanded training helps them understand more than specific skills; it also helps them become more confident contributors. Training with a…