Which is not true for electrogravimetric analysis? A. If the analyte has color in solution; The disappearance of the color indicates that the build-up is complete. B. If a qualitative test for a small sample of the analyte solution is positive, the analyte deposition is complete. C. The analyte is quantitatively deposited on an electrode by electrolysis. D. If the additional electrode surface is exposed to the solution and there is no further deposition, the deposition of the analyte is complete.

Which is not true for electrogravimetric analysis? A. If the analyte has color in solution; The disappearance of the color indicates that the build-up is complete. B. If a qualitative test for a small sample of the analyte solution is positive, the analyte deposition is complete. C. The analyte is quantitatively deposited on an electrode by electrolysis. D. If the additional electrode surface is exposed to the solution and there is no further deposition, the deposition of the analyte is complete.

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

ChapterA1: Evaluation Of Analytical Data

Section: Chapter Questions

Problem A1.23QAP

See similar textbooks

Similar questions

Refering to the image attached (Winkler method), what is the function of sodium thiosulphate and why do we need to add in the solution until it turns into pale yellow colour?
What do you think is a limitation of the flame test in identifying metal ions in solution?
What are the types of gravimetric methods? Give an examples where each method is used in an analysis.
During the mixing step, briefly discuss why gentle mixing of the solution is necessary after the addition of ferric chloride? How does this impact the next step of sedimentation?
When using ion-selective electrodes, to comensate for a complex or unknown matrix, the __________ method can be used to determine the analyte concentration. a) least-squares analysis b) standardization c)standard addition d)dilution e)calibration curve
2. The gravimetric analysis of nickel in copper and iron, what is the purpose of "dipping" the precipitation in this experiment
Which among these is the most important piece of data in a gravimetric analysis? Mass of analyte Mass of weighing form Mass of crucible Mass of precipitating agent
How is lake test for aluminium ion based upon adsorption?
Give equations and explanations for: Randles Sevcik analysis and Brown Anson analysis
A student rushed through this experiment, but noted some procedural errors in their lab notebook. If the following observations were listed in the lab notebook, how would they affected the calculate sodium hypochlorite percentage? Would the calculated percentage be too high, too low, or unchanged by their procedural error? A student forced the remaining liquid in the pipet out with the pipet pump. A student had an air bubble in the buret tip that remained there during the entire titration. A student had an air bubble in the buret tip that came out during the titration.
How does the adsorptive characteristic of filter papers affect the concentrations involving heavy metal ions analysis? How does quality control procedures such as reagents blanks, fortified blanks and spikes help correct analytical methods such as the filter paper analysis for heavy metals?
Accurately weigh out about 6g copper(ii) sulfate crystals into a weighing boat. Use the copper(ii) sulfate crystals to make up 250cm3 of standardized copper (ii) sulfate solution Pipette 25cm3 of this solution into a conical flask Add 1.5g potassium iodide and swirl thoroughly Titrate this solution with standard 0.1 moldm-3 Na2S2O3 in a burette. When the iodine color fades, add 1 cm3 starch indicator. Use your titration data below to calculate the percentage by mass of copper in the copper(ii) sulfate crystals.